入太湖污水中三态氮水质模型的研究

本文通过多次现场调查与室内实验的数据分析,对流入太湖污水中三态氮水质模型的建立进行了初步探讨。研究表明,模型的计算数值与现场实测数值基本一致。     

应用OCMA-220型油分仪测定水样中油含量在实际工作中的几个问题

ＯＣＭＡ－２２０型油分仪应用非散红外光谱法测定水样中油的含量，测定结果较稳定，准确度较高，在环境监测中应用广泛。实际操作中，水样中悬浮料粒子较多且萃取层与ＣＣＬ４层为乳化状态时，必须经滤纸过滤和无水Ｎａ２ＳＯ４脱水处理，才能进行测定。但经滤纸过滤和无水Ｎａ２ＳＯ４脱水处理后，空白值分别在５ｐｐｍ和１６ｐｐｍ以上，如果样品油含量较低时，产生的系统误差，将导致分析结果准确度降低。     

4-氯酚存在对生物强化系统降解2,4-二氯酚的影响研究

采用生物强化技术降解废水中的难降解有机物 2 ,4 二氯酚 (简称 2 ,4 DCP) ,研究了不同浓度的 4 氯酚 (简称 4 MCP)存在对 2 ,4 DCP降解的影响 ,并通过半连续流实验研究了 4 MCP长期存在下 ,强化系统中 2 ,4 DCP和 4 MCP降解速率的变化趋势 .结果表明 ,第 1次半连续流实验中 ,4 MCP浓度为 5、10、2 0及 30mg L时 ,都会对强化系统中 2 ,4 DCP的降解速率产生一定的抑制作用 ,而且抑制作用随着 4 MCP浓度的增加而增强 .随着半连续流实验次数的增加 ,4 MCP对 2 ,4 DCP降解的抑制作用减弱甚至消失 ,共基质时 2 ,4 DCP的降解速率反而比其单基质半连续流运行时快 .4 MCP与 2 ,4 DCP共基质存在时 ,2 ,4 DCP优先被微生物利用 ,此后 4 MCP才被降解 ,表现出两阶段降解的现象 .     

土壤中麦草灵残留的固相萃取—高效液相色谱测定

土壤中麦草灵用酸性乙醇提取，采用固相萃取技术用Ｓｅｐ－Ｐａｋ Ｃ１８柱净化浓缩，以反相离子抑制高效液相色谱分离测定，方法简便、快速、在土壤中的检出下限为０．０４ｍｇ·ｋｇ＾－１回收率范围在８３．８－８５．８％之间。     

单甲脒等农药的土壤薄层层析行为

用土壤薄层层析法研究单甲脒，单甲脒盐酸盐、灭幼脲和涕灭威等农药在不同土壤中的迁移行为，分别获得了这几种化合物的Ｒｆ值，它们分别为０．１４、０．１７，０．０８，０．７６，研究表明，单脒，单甲脒盐酸盐和灭幼脲不会污染地下水，而涕灭威则会对地下水污染构成严重的威胁。     

湘南水田施含SO_4~(2-)和Cl~-肥料对作物生长和养分吸收的效应

1990年4—11月,在湖南祁阳中国农科院红壤实验站布置田间试验,比较含SO_4~(2-)和Cl~ -类肥料对作物生长的效应。结果表明,SO_4~(2-)促进早稻和晚稻营养生长,但水稻收获时的稻谷产量以Cl~-肥料处理区较高。两种阴离子对水稻养分吸收无显著差异,但SO_4~(2-)对早稻体内的磷素转化不利,可能是稻谷产量较低的原因之一。     

好氧颗粒污泥处理高浓度氨氮废水的研究

在不同接种源污泥颗粒化过程中污泥理化性状对比研究的基础上,采用成熟好氧颗粒污泥处理高浓度氨氮废水,对其脱氮行为以及不同C/N条件下好氧颗粒污泥微生物的比耗氧速率、好氧颗粒污泥对氨氮的比降解速率随时间的变化等进行了研究.实验结果表明,在进水氨氮质量浓度较高(480 mg/L)、温度30℃左右的条件下,稳定运行15 d,氨氮的去除率维持在85%左右;进水氨氮的浓度越高,随着微生物对环境的逐渐适应,硝化菌的活性也逐步增加;随着进水氨氮浓度的提高,好氧颗粒污泥对氨氮的比降解速率也逐渐上升.     

The Danish eulerian hemispheric model — a three-dimensional air pollution model used for the arctic

A three-dimensional Eulerian hemispheric air pollution model, the Danish Eulerian Hemispheric Model (DEHM), is in development at the National Environmental Research Institute (NERI). The model has been used to study long-range transport of air pollution in the Northern Hemisphere. The present version of the model includes long-range transport of sulphur dioxide (SO₂) and particulate sulphate (SC₄²⁻. The chemistry in the model is described by a simple linear oxidation of SO₂ to SO₄²⁻, and the wet deposition of SO₂ and SO₄⁻ is estimated based on the amount of precipitation, which is calculated from the contents of liquid cloud water (see Christensen, Air Pollution Modelling and its Applicatioons, Vol. X, pp. 119–127, Vol. XI, pp. 249–256, Plenum press, New York; 1995, Ph.D. thesis, National Environmental Research Institute, Denmark). The model has been used to study the air pollution in the Arctic. Results from yr simulation with an analysis of the results is presented: the model results are verified by comparisons, to measurements not only from the Arctic region but also from Europe and Canada. Some examples of episodes in the Arctic including analysis of the meteorological conditions during the episodes are presented. Finally, the model has been used to estimate the contribution from the different source regions on the northern hemisphere to the Arctic sulphur pollution.     

Ferrioxalate-mediated photodegradation and mineralization of 4-Chlorophenol

INTENTION, GOAL, SCOPE, BACKGROUND: Advanced oxidation processes are powerful methods which are capable of transforming refractory, nonbiodegradable and/or toxic organic compounds into harmless end products such as carbon dioxide and water. However, one commen problem of all advanced oxidation processes is the high demand of electrical energy for ultraviolet lamps, which causes high operational costs. Minimization of the required irradiation time, and therefore the energy consumption, by optimization of other reaction conditions such as catalyst-oxidant type and concentration, pH, temperature, pollutant/oxidant ratio etc., therefore continues to gain importance. OBJECTIVE: The main objective of this study was the minimization of the required irradiation time through optimization of the use of a newly patented catalyst, ferrioxalate, and also to compare the performance of this catalyst with the performance of other AOPs. METHODS: Oxidation of 4-chlorophenol by photo-Fenton process using potassium ferrioxalate as a mediator was studied in a lab scale photoreactor. The influence of parameters such as hydrogen peroxide and ferrioxalate concentrations, initial pH, power-output, oxalate/iron ratio and different iron sources was evaluated. An upflow photoreactor equipped with a 1000 Watt high-pressure mercury vapour lamp and operating in a recirculation mode was used during photodegradation experiments. The extent of the reduction of 4-chlorophenol, Total Organic Carbon and Chemical Oxygen Demand was used to evaluate the photodegradation reaction. RESULTS AND DISCUSSION: The optimum pH range observed was found to be 2.7-3. The efficiency of 4-chlorophenol oxidation increased with increasing concentrations of hydrogen peroxide and ferrioxalate, reaching a plateau after the addition of 10 and 0.072 mM of those reagents, respectively. Using an Oxalate/iron ratio of 12 was 18% less efficient than using a ratio of 3:1. The efficiency increased with increasing radiation power. However, this increase was not linear. The UV/ferrioxalate/H2O2 process, by which complete mineralization of 100 mg l(-1) 4-chlorophenol was achieved in 20 min of total reaction time, was the most efficient process among the alternatives applied. CONCLUSIONS: The use of ferrioxalate as the catalyst was found to be more efficient than the use of Fe(II) and Fe(III) iron species. It was possible to completely mineralize 4-chlorophenol. RECOMMENDATION AND OUTLOOK: The results of this study demonstrate that the ferrioxalate-mediated degradation of 4-chlorophenol requires less irradiation times than other advanced oxidation processes. There are mainly 19 phenol isomers and other toxic and nonbiodegradable organic compounds. We recommend that similar studies should be performed on many such compounds in order to attain a clear understanding of the performance of this catalyst. Because of its light sensitivity, this catalyst should be used immediately after its preparation. The use of low pressure mercury vapour lamps in this process should also be considered, since low power outputs may be enough for the process.     

单甲脒在土壤中的吸附

用批量平衡法研究了单四脒酸盐的活性部分－单甲脒在不同类型土壤中的吸附行为，获得了单甲脒的单位土壤有机质吸附常数（Ｋｏｍ）为２８４和吸附自由能变化量为１３．９９ｋＪ．ｍｏｌ＾－１的实验数值，研究表明，单甲脒在土壤中吸附符合Ｆｒｅｕｎｄｌｉｃｈ经验公式，其在土壤中的吸附系数Ｋｄ与土壤中有机质含量和阳离了交换容量均显著正相关。