粉煤灰吸附去除弱酸性艳蓝印染废水

利用粉煤灰对弱酸性艳蓝印染废水进行了处理。研究表明：粉煤灰的粒径、灰水比、废水pH值以及振荡吸附时间对粉煤灰的吸附能力均有较大影响。在以下工艺条件下：20℃,粉煤灰的粒径200目,灰水比为1：30,pH为2．0,振荡吸附2．5h,弱酸性艳蓝印染废水经粉煤灰处理后,COD值由576mg／L降至71mg／L,COD去除率可达87．7％：废水色度可从10000倍降为50倍,色度的去除率达99．5％,出水pH为6．5。出水水质达到了国家印染废水一级排放标准(GB4287—92)。     

Phytotoxicity and groundwater impacts of leaching from thermal treatment residues in roadways

The use of coal fly ash (CFA), municipal solid waste incinerator bottom ash (MSWIBA) and flue gas desulfurization residue (FGDR) in road construction has become very common owing to its economical advantages. However, these residues may contain toxic constituents that pose an environmental risk if they leach out and flow through the soil, surface water and groundwater. Therefore, it is necessary to assess the ecotoxicity and groundwater impact of these residues before decisions can be made regarding their utilization for road construction. In this study, the physico-chemical characteristics, leaching and phytotoxicity of these residues were investigated. Specifically, multivariate analyses were used to evaluate the contributions of the leaching constituents of the CFA, MSWIBA and FGDR leachates to the germination index of wheat seeds. B, Ba, Cr, Cu, Fe and Pb were found to be more toxic to the wheat seeds than the other heavy metals. Furthermore, the leached concentrations of the constituents from the CFA, MSWIBA and FGDR were below the regulatory threshold limits of the Chinese identification standard for hazardous wastes. Analyses conducted using a numerical groundwater model (WiscLEACH) indicated that the predicted field concentrations of metals from the CFA, MSWIBA and FGDR increased with time up to about 30 years at the point of compliance, then decreased with time and distance. Overall, this study demonstrated that the risks resulting from MSWIBA, CFA and FGDR leaching could be assessed before its utilization for road construction, providing crucial information for the adoption of these alternative materials.     

浅谈粉煤灰综合治理及建议

介绍了大庆石油化工总厂热电厂自投产以来，粉煤灰综合治理的经过，所采取的措施，存在的问题和收到的成效。这对于我国高寒平原地区的燃煤电厂有一定的借鉴参考作用。     

基于响应曲面法优化烧结烟气脱硫灰改性工艺

采用BOX-Behnken的中心组合实验设计及响应面分析方法对半干法烧结烟气脱硫灰进行改性研究,得到脱硫灰转化率的预测模型。结果表明:通过该预测模型可以很好地描述脱硫灰的转化率与反应温度、反应时间和气固比等重要操作参数之间的关系,R2=0.9903。因素分析表明,反应温度对脱硫灰的转化率影响最大,同时反应温度和气固比的交互作用与反应温度和时间的交互作用对脱硫灰的转化率的影响作用相同。利用得到的改进预测模型可以计算脱硫灰的转化率。     

Reduced downward mobility of metribuzin in fly ash-amended soils

Metribuzin, a triazine herbicide, is poorly sorbed in the soils, therefore leaches to lower soil profile. Fly ash amendment, which enhanced metribuzin sorption in soils, may play a significant role in reducing the downward mobility of herbicide. Therefore, the present study reports the effect of Inderprastha fly ash amendment on metribuzin leaching in three soil types. Fly ash was amended at 1, 2 and 5% levels in the upper 15 cm of 30 cm long packed soil columns. Results suggested a significant reduction in the leaching losses of metribuzin in fly ash-amended columns of all the three soil types and effect increased with increase in the level of fly ash. Even after percolating water equivalent to 362 mm rainfall no metribuzin was recovered in the leachate of 5% fly ash-amended columns. Fly ash application affected both metribuzin breakthrough time and its maximum concentration in the leachate. Further, it resulted in greater retention of metribuzin in the application zone and better effect was observed in the organic carbon poor soils.     

1000 MW燃煤机组电除尘深度节能技术研究及应用

电除尘设备在减少工业粉尘排放量、降低大气环境污染、保护生态环境等方面有着重要的作用,随着我国对节能减排工作的重视及环保要求的提高,保证其安全、稳定、经济、节能运行成为火电厂环保工作重点。对北仓电厂三期2×1000 MW机组电除尘电场供电方式优化、电除尘振打方式优化、电除尘闭环控制技术、电除尘高频电源技术、电除尘灰斗、瓷套蒸汽加热技术组合集成应用进行了研究,在确保除尘效率达到要求的情况下,降低运行电耗。相关的电除尘深度节能技术成果在国内同类型设备中具有一定的借鉴意义。     

粉煤灰负载铁离子催化氧化活性黄染料废水

以粉煤灰为载体,制备铁/粉煤灰负载型催化剂,并利用该催化剂催化H2O2氧化降解活性黄染料废水,探讨了H2O2投加量、催化剂投加量、染料初始浓度和初始pH值等因素对染料废水COD去除率和脱色率的影响。结果表明,当染料废水COD初始浓度为200 mg/L,初始pH值为1.7,投加0.5 g/100 mL催化剂及加入1.0 mL浓度为1.13 mol/L的H2O2溶液时,处理效果最好,此时染料废水的COD去除率和脱色率分别达到63%和99%,并且废水的可生化性得到很大的提高。利用该负载催化剂能够有效地减少活性黄染料废水中Fe3+的残留量。     

某“W”型锅炉炉效低的综合治理

针对某锅炉经济性差的问题,从设备、运行及自动控制等方面分析,并进行了相应整改。影响炉效的主要因素有煤质恶化、灰渣含碳量高、排烟温度高和CO浓度高等,同时炉膛燃烧不稳定也是影响燃烧效率的重要因素。通过漏风整改、制粉系统优化、燃烧优化调整和控制系统优化等方法有效提高了锅炉经济性。研究表明：分析锅炉经济性降低的影响因素时应抓住主要因素,兼顾其他,科学的生产管理是保证锅炉运行经济性的重要基础;入炉煤质恶化是最主要的外在因素;良好的自动控制系统能有效稳定燃烧参数,提高燃烧效率;降低飞灰含碳量的主要工作应集中在制粉系统优化调整;完整而系统的燃烧调整试验能够保证锅炉运行控制参数的科学合理,并需要正确调整氮氧化物排放和锅炉效率之间的关系。     

Stabilization of heavy metals in MSWI fly ash using silica fume

The objective of this work was to investigate the feasibility and effectiveness of silica fume on stabilizing heavy metals in municipal solid waste incineration (MSWI) fly ash. In addition to compressive strength measurements, hydrated pastes were characterized by X-ray diffraction (XRD), thermal-analyses (DTA/TG), and MAS NMR (²⁷Al and ²⁹Si) techniques. It was found that silica fume additions could effectively reduce the leaching of toxic heavy metals. At the addition of 20% silica fume, leaching concentrations for Cu, Pb and Zn of the hydrated paste cured for 7 days decreased from 0.32 mg/L to 0.05 mg/L, 40.99 mg/L to 4.40 mg/L, and 6.96 mg/L to 0.21 mg/L compared with the MSWI fly ash. After curing for 135 days, Cd and Pb in the leachates were not detected, while Cu and Zn concentrations decreased to 0.02 mg/L and 0.03 mg/L. The speciation of Pb and Cd by the modified version of the European Community Bureau of Reference (BCR) extractions showed that these metals converted into more stable state in hydrated pastes of MSWI fly ash in the presence of silica fume. Although exchangeable and weak-acid soluble fractions of Cu and Zn increased with hydration time, silica fume addition of 10% can satisfy the requirement of detoxification for heavy metals investigated in terms of the identification standard of hazardous waste of China.     

Optical and Chemical Methods of Metal Ash Analysis and Tin Recovery

‘Metal ash’ presents a waste disposal problem in most of the developing countries as the industries employ obsolete technologies. In this paper we describe analysis of tin ash, zinc ash and aluminium ash by means of optical methods, such as X-ray diffraction (XRD), inductively coupled plasma mass spectrometry (ICP-MS), electron probe micro analysis (EPMA), scanning electron microscopy (SEM) and chemical methods. The results of tin ash obtained by XRD method matched well with the cassiterite, a naturally occurring mineral of tin. ICP-MS studies reveal the presence of a large number of tracer metals, which may cause pollution by tertiary dispersion and this aspect is discussed. Conversely, the data generated by chemical methods are limited. However, the methods are simple and cost-effective. Then, they can easily be adopted by low-budget industries. Simple and cost-effective process to recover tin from tin ash is described. It is based on heating tin ash with sodium cyanide to about 900°C to separate tin component from the metal ash. The process recovers good quality tin and offers a very high yield. The process can be scaled up to small pilot plant.