降解菌JQL4-5甲氰菊酯水解酶的提取及酶学特性研究

Sphingomonas sp.JQL4-5是一株甲氰菊酯降解菌。提取该菌株的甲氰菊酯水解酶,对其酶学特性进行了初步研究。该酶水解甲氰菊酯的最适pH值为7.0,最适温度为30℃,供试的金属离子均对酶活性有一定的抑制作用,抑制率与金属离子的浓度呈正相关,其中Ag+的抑制作用最强烈,几乎可以导致酶活性完全丧失。该酶在极性有机溶剂中比在非极性的有机溶剂中稳定。     

铁炭微电解预处理聚酯树脂废水的试验研究

采用铁炭微电解法预处理聚酯树脂废水研究,先进行正交试验,考察铁屑投加量、铁炭比和废水初始pH值对微电解效果的影响,接着在正交试验的基础上进行单因素试验,确定铁炭微电解法的最优工艺参数。试验结果表明:废水初始pH值对微电解处理聚酯树脂废水的影响最大,其次是铁屑投加量和铁炭比,最适工艺条件为:室温,废水初始pH值为2.0,铁屑投加量为100 g/L,铁炭质量比为1:1,曝气搅拌反应时间2.0 h。在此工艺条件下,BOD5/CODcr从0.17增加到0.33;此外,废水的CODcr去除率也可达到50.91%,这大大降低了后续生化处理的有机负荷。     

珠三角SO_2污染区划及来源的定量研究

文章利用珠三角粤港空气质量监测网13个空气质量监测点2009年11月SO2监测浓度,通过聚类分析对珠三角SO2进行污染特征区划,最终选定该时段内3个核心关注区域,分别为广州中心城区、佛山江门片区、珠江口西侧片区。发现佛山江门片区的污染最为严重,其次是珠江口西侧片区。根据一定标准,选定11月23-27日为典型污染过程,11-16日为典型清洁时段。利用MM5-CALPUFF模式对这3个区域,在典型污染过程与清洁时段内的SO2平均浓度进行来源分析,发现在选定的模拟时段内,广州中心城区在污染过程中以本地污染为主(贡献率达62.47%),清洁时段则广州本地污染(49.43%)与东莞输送污染(40.27%)并重;佛山江门片区在污染过程和清洁时段均以外地输送污染(分别为65.06%和68.92%)为主,主要输入源地是广州和东莞;珠江口西侧片区在污染过程和清洁时段均是输送污染与本地污染并重(污染过程输送污染44.10%,本地污染51.83%;清洁时段输送污染50.25%,本地污染41.11%),其中污染过程中,输送污染的主要输入源地是深圳与东莞,清洁时段输送污染比重略大于本地污染,主要输入源地只有东莞。研究结果为控制及治理珠三角SO2源提供科学依据。     

Fabrication of supported acid catalytic composite fibers by a simple and low-cost method and their application on the synthesis of liquid biofuel 5-ethoxymethylfurfural

In this paper, sulfonic groups functionalized annealed bio-based carbon microspheres loaded polytetrafluoroethylene (A-BCMSs-SO3H@PTFE) fibers with high activity, high stability, and easy regeneration were successfully fabricated by a simple method using low-cost raw materials. The characterization results showed that the annealed biomass carbon microspheres derived from waste Camellia oleifera shells were evenly distributed on the polytetrafluoroethylene fibers and the sulfonic groups can be successfully loaded on the surface of annealed biomass carbon microspheres by room temperature sulfonation. Subsequently, the as-prepared A-BCMSs-SO3H@PTFE fibers were applied to the acid-catalyzed synthesis of liquid biofuel 5-ethoxymethylfurfural. The catalytic experiment results indicated that the annealing temperature and time during catalyst preparation have a significant effect on the activity and selectivity of A-BCMSs-SO3H@PTFE fibers. The results of catalytic reaction kinetics showed that the yield of 5-ethoxymethylfurfural can reach more than 60％after 72 h of acid-catalyzed reaction. The stability test showed that the as-prepared A-BCMSs-SO3H@PTFE fibers still maintained a stable acid catalytic activity after four recycles.     

几种化学物质对番茄幼苗耐低温弱光能力的影响

以4叶期番茄为试材,对叶面喷施不同浓度的CaCl_2、甜菜碱和ALA(5-氨基乙酰丙酸),用人工霜箱进行低温弱光胁迫处理,通过观测、计算冷害指数,测定净光合速率、气孔导度等指标,结果表明,CaCl_2、甜菜碱和ALA等几种化学物质能够提高番茄幼苗的耐低温弱光能力,其中CaCl_2的适宜浓度为0．4～1 mmol/L,甜菜碱的适宜浓度为2．5 mmol/L,ALA的适宜浓度为30mg/L。     

BOD_5快速测定法

寻求BOD生化过程动力学方程,依据广泛性的、相关性很好的多组实验数据(X,Y),建立回归方程用于计算BOD5。本法仍以国标GB/T7488-1987为依据,仅以较少培养时间的BOD值推算得BOD5值。BOD5的计算值与其实测值间的相对误差<5%。     

H-ZSM-5分子筛吸附-氧化NOx的研究

针对湿法脱硫后船舶尾气特点,考察了3种不同硅铝比的H-ZSM-5分子筛对船舶脱硫后尾气中NO_x的吸附-氧化过程及其影响因素,并采用TPD研究了干气下不同硅铝比的分子筛吸附饱和后的脱附情况.结果表明:干气条件下,硅铝比低的分子筛具有较好的吸附效果;硅铝比高的分子筛具有较好的抗水性,但从干气到饱和湿度下,硅铝比为300的分子筛的NO氧化率从36%降至18%;干气下,低温有利于分子筛的吸附-氧化;分子筛用量增加能够增加其对NO_x的吸附效果和氧化效果.TPD结果表明:NO和NO2共吸附在分子筛上,3种分子筛中脱附出的NO_x中NO2均占脱附总量的80%以上,但在600℃时,NO_x在分子筛上脱附仍不完全.     

安全文化宣教机理研究

为明晰安全文化宣教机理,从而提升安全文化宣教效果,基于宣传与教育的定义,提出安全文化宣教的定义,并分析其内涵。基于此,构建并解析安全文化宣教的“5-13”模式和受众处理安全文化符号信息的过程模型。在此基础上,提炼驱动受众心理的猎奇心理、重情心理与审美需要等16条理论依据和与之对应的一些具体方法。结果表明,设计、筹划和实施安全文化宣教活动和行为应以安全文化宣教的“5-13”模式和受众处理安全文化符号信息的过程模型为依据,有效驱动受众心理是提高安全文化宣教效果的关键。     

桂林“5.9”山体滑坡的暴雨成因分析

对造成2011年5月9日广西桂林咸水乡山体滑坡的暴雨成因进行了分析,结果表明,滑坡是由于暴雨因素诱发的地质灾害,短时强暴雨是造成山体滑坡的直接原因.大量的水汽传送到滑坡点,同时低层辐合抬升,因而滑坡点是大暴雨的发生地.滑坡发生滞后强降雨结束2.5h.滑坡点位于暴雨中心带,暴雨区位于高空急流的右侧,200h Pa为强烈辐散区,高空辐散带的走向与山脉走向一致.西南低空急流与地形的相互作用是暴雨形成的直接原因,雷达回波显示在“湘桂走廊”存在强风速的出流与横向风速梯度,对应反射率有弓状回波,同时具有前侧V形人流缺口和后侧V形下沉缺口等对流单体特征.     

Dispersive liquid–liquid microextraction of cadmium(II) for preconcentration prior to flame atomic absorption spectrometric detection in water

A dispersive liquid–liquid microextraction procedure for cadmium(II) as its 2-(5-bromo-2-pyridylazo)-5-diethylamino-phenol chelate is presented. Carbon tetrachloride and methanol were used as extraction and dispersive solvents, respectively. After phase separation, the preconcentrated-separated cadmium(II) is determined by flame atomic absorption spectrometry with a microinjection technique. The factors which affected the extraction efficiency, i.e. the pH of the sample solution and the volumes of reagent and sample were investigated. The effects of some alkali, alkali earth, and transition metal ions, and of some anions on the recovery of cadmium were also studied. A preconcentration factor of 250 was obtained for a sample volume of 50?mL under optimum conditions. The method was validated by analysis of certified reference materials and applied to some water samples from Turkey.