南昌市环境空气质量分析和控制

利用多年的环境监测数据,分析南昌市环境空气中主要污染物尘类、二氧化硫和氮氧化物产生的原因,并提出有效控制上述污染物的具体措施。     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

大气环境影响评价工作分级要求要点

根据大气环境影响评价工作的分级要求,提出了针对性的工作要点,以满足大气环境评价工作的需要.     

液固比对含重金属水泥熟料制品中重金属释放的影响

通过模拟煅烧试验制取水泥熟料,参照JGJ 55-2000（《普通混凝土配比设计规程》）制取混凝土样品,参考SR003.1和NEN 7375浸出试验,分别研究液固比对粒状及块状混凝土样品中重金属（Cr、Ni和As）释放的影响。结果表明,在不同液固比条件下粒状混凝土中的重金属浸出浓度为Cr>Ni>As,Cr、As浸出浓度基本保持不变,分别为2 500 μg/L左右和5～6 μg/L,Ni在液固比（L∶S）<6时,浸出浓度随着液固比的增加而降低,在L∶S>6时,浸出浓度较稳定,为35.7～41.5 μg/L;浸出量均随着液固比的增加而增大。液固比（L∶S）<10时,块状混凝土中重金属累积释放量及扩散系数均随液固比的增加而增大,当L∶S>10时两者基本保持不变。     

Cu2+或表面活性剂AE对黄鳝肝损伤的超微结构观察

利用透射电镜研究了亚致死浓度的Cu^2 或表面活性剂AE(脂肪醇聚氧乙烯醚)对黄鳝肝细胞结构的损伤作用．观察发现，在ρ(Cu^2 )=4．5mg／L的污染环境中，黄鳝肝脏细胞核变形，染色质凝集，内质网囊泡化，细胞质中出现较多的溶酶体和过氧化物酶体；在ρ(AE)=4．0mg／L的表面活性剂污染下，黄鳝肝脏细胞核变形，内质网呈线状，溶酶体、过氧化物酶体体积大、数量多，部分细胞质解体，细胞中出现空腔甚至死亡．图版1参10     

内蒙古典型草原土壤不同剖面深度CO_2通量格局及其驱动因子

土壤CO2的释放能够显著增加大气牛CO2的浓度,增强温室效应,从而对全球气候和环境变化产生重要影响.但是,不同的土壤层对CO2通量的贡献量有很大的差异.文章通过挖坑法结合红外气体分析法研究了内蒙古草原典犁针茅(Stipa krylovii)群落和羊草(Leymus chinensis)群落不同剖面深度土壤CO2通量格局以及影响CO2通量的驱动因素.结果表明,表层土壤移走后,土壤CO2通量的变化可分为瞬时、短期、长期三种格局.新剖面上最初的0～21 min内释放的CO2通量最均大于初始土壤表层CO2通量,而且两者比值随土壤深度增加而增大,也随土壤CO2生产能力增强而增大.2～4 d后,新剖面CO2通量持续下降至低于初始土壤表层CO2通量的水平.形成短期稳定状态.更长时间后,新剖面则逐渐表现出与初始土壤剖面表层相近的CO2通量特征.我们认为,(1)在新剖面形成时的CO2通量瞬时和短期格局主要受土壤中存留的原始CO2的浓度及其扩散过程控制,(2)长期格局则由资源水平和环境条件共同决定的土壤CO2生产能力主导.文章进一步揭示了建立包含垂直分层的SOC分解和CO2扩散过程的生态系统模型的必要性.     

TiO2@palygorskite composite for the efficient remediation of oil spills via a dispersion-photodegradation synergy

• A novel and multi-functional clay-based oil spill remediation system was constructed. • TiO₂@PAL functions as a particulate dispersant to break oil slick into tiny droplets. • Effective dispersion leads to the direct contact of TiO₂ with oil pollutes directly. • TiO₂ loaded on PAL exhibits efficient photodegradation for oil pollutants. • TiO₂@PAL shows a typical dispersion-photocatalysis synergistic remediation. Removing spilled oil from the water surface is critically important given that oil spill accidents are a common occurrence. In this study, TiO₂@Palygorskite composite prepared by a simple coprecipitation method was used for oil spill remediation via a dispersion-photodegradation synergy. Diesel could be efficiently dispersed into small oil droplets by TiO₂@Palygorskite. These dispersed droplets had an average diameter of 20–30 mm and exhibited good time stability. The tight adsorption of TiO₂@Palygorskite on the surface of the droplets was observed in fluorescence and SEM images. As a particulate dispersant, the direct contact of TiO₂@Palygorskite with oil pollutants effectively enhanced the photodegradation efficiency of TiO₂ for oil. During the photodegradation process, •O₂⁻and •OH were detected by ESR and radical trapping experiments. The photodegradation efficiency of diesel by TiO₂@Palygorskite was enhanced by about 5 times compared with pure TiO₂ under simulated sunlight irradiation. The establishment of this new dispersion-photodegradation synergistic remediation system provides a new direction for the development of marine oil spill remediation.     

Property-performance relationship of core-shell structured black TiO2 photocatalyst for environmental remediation

● Properties and performance relationship of CSBT photocatalyst were investigated. ● Properties of CSBT were controlled by simply manipulating glycerol content. ● Performance was linked to semiconducting and physicochemical properties. ● CSBT (W:G ratio 9:1) had better performance with lower energy consumption. ● Phenols were reduced by 48.30% at a cost of $2.4127 per unit volume of effluent. Understanding the relationship between the properties and performance of black titanium dioxide with core-shell structure (CSBT) for environmental remediation is crucial for improving its prospects in practical applications. In this study, CSBT was synthesized using a glycerol-assisted sol-gel approach. The effect of different water-to-glycerol ratios (W:G = 1:0, 9:1, 2:1, and 1:1) on the semiconducting and physicochemical properties of CSBT was investigated. The effectiveness of CSBT in removing phenolic compounds (PHCs) from real agro-industrial wastewater was studied. The CSBT synthesized with a W:G ratio of 9:1 has optimized properties for enhanced removal of PHCs. It has a distinct core-shell structure and an appropriate amount of Ti³⁺ cations (11.18%), which play a crucial role in enhancing the performance of CSBT. When exposed to visible light, the CSBT performed better: 48.30% of PHCs were removed after 180 min, compared to only 21.95% for TiO₂ without core-shell structure. The CSBT consumed only 45.5235 kWh/m³ of electrical energy per order of magnitude and cost $2.4127 per unit volume of treated agro-industrial wastewater. Under the conditions tested, the CSBT demonstrated exceptional stability and reusability. The CSBT showed promising results in the treatment of phenols-containing agro-industrial wastewater.     

饮用水生物处理中微生物量和活性的测定方法

微生物量和微生物活性是饮用水生物处理工艺设计与运行的重要参数。总结论述了适用于表示饮用水生物处理过程生物膜中微生物数量和活性的几种主要指标的测定方法。     

负载型纳米TiO2光催化降解水中微量溶解性间二甲苯

以高压汞灯为光源 ,采用浸涂 -烧结法制备的负载型纳米TiO2 作为光催化剂 ,通过对水中微量溶解性间二甲苯的光催化氧化过程的研究表明 ,初始浓度在 6 .6 8— 17.36mg/L的范围内 ,间二甲苯的光催化反应遵循表观一级反应动力学规律 ,反应的表观速率常数随溶液初始浓度的增大而减小 ,半衰期则随初始浓度的增大而增加 ,经 1.5h反应后 ,溶液中间二甲苯的去除率从 17.36mg/L的 5 4 .4 4 %增加到 6 .6 8mg/L的 75 .90 %。