自然风化条件下原油中金刚烷的风化规律

以渤海2个原油作为研究对象进行自然风化实验,探讨了原油中金刚烷化合物的分布情况及其风化规律.结果表明,经过100 d的室外自然风化,原油中金刚烷的分布已经发生了较大的改变：风化损失程度与金刚烷化合物的沸点有关,风化初期单金刚烷损失严重,风化45 d,单金刚烷完全消失;双金刚烷浓度变化较小,有较好的抗风化稳定性;通过t检验分析,所选取诊断比值中,单金刚烷指标A6、A8、A12和双金刚烷指标A16、A17、A18较为稳定,能很好地指示自然风化20 d内油样的来源;双金刚烷指标A17、A18风化100 d非常稳定,可用于长期自然风化油样来源鉴别,金刚烷化合物诊断比值对于溢油鉴别具有重要的意义.     

淹水对酸性红壤磷吸附解吸特性的影响——以江西省旱地红壤和水稻土为例

采用室内培养法研究了淹水对2种酸性红壤（旱地红壤、水稻土）磷吸附解吸特性及草酸可提取态P的影响。淹水培养实验中,2种土壤分别淹水0（对照）,1、2、3、4、8周,淹水培养结束后进行P吸附解吸实验,解吸实验结束后测定土样中草酸可提取态P。结果表明：与氧化状态相比,淹水后旱地红壤P吸附量减少,水稻土淹水1、2、3周P吸附量高于氧化状态,继续淹水4和8周后P吸附量减少。淹水前后旱地红壤P吸附量均大于水稻土。用简单Langmuir方程拟合P等温吸附曲线,除淹水4周外,P最大缓冲容量（MBC）随淹水时间延长而降低。结合能常数（K）淹水前后的变化规律性差。2种土壤P解吸量随加入P量增加而增加。氧化、还原状态下,2种土壤酸性草酸铵可提取P均远远大于CaCl2解吸P,虽然水稻土吸附P量低于旱地红壤,但P解吸量无论是CaCl2解吸P还是酸性草酸铵可提取P均大于旱地红壤,主要原因在于水稻土全P及速效P含量大于旱地红壤。淹水后草酸可提取态P增加,吸附P的释放和被新近形成的铁氧化物再吸附是淹水后草酸可提取态P增加的主要原因。     

不同改良剂对重金属污染农田水稻产量和重金属吸收的影响

探讨了石灰、过磷酸钙和有机物等改良剂的应用对水稻(oryzasativa)产量和重金属吸收的影响。实验共四种处理:T1,对照;T2,石灰(0.25kg·m-2);T3,石灰 过磷酸钙(0.40kg·m-2);T4,石灰 过磷酸钙 有机物(0.90kg·m-2)。叶面喷施的处理方法研究不多,因此结合在水稻的孕穗期喷施KH2PO4(0.3%)溶液研究喷施途径的处理效果。结果显示,T3处理即石灰 过磷酸钙(0.40kg·m-2),对于降低水稻体内的重金属含量效果最好,与对照相比,米中的Pb、Zn和Cd分别下降了61.8%、14.1%和45.1%,同时也使水稻茎叶中的Pb和Zn分别比对照下降8.1%和4.3%。另外,在水稻的叶面喷施KH2PO4溶液将水稻的产量从0.61kg·m-2提高到0.68kg·m-2,并且这种喷施措施也能有效地降低水稻中的重金属含量。     

四川省卧龙地区土壤中二噁英类化合物和多氯萘的海拔梯度分布及对牦牛的毒性风险评价

初步研究了四川省卧龙地区5个不同海拔高度的表层土壤和2个牦牛样品中二噁英/呋喃(PCDD/Fs)、共平面多氯联苯(co-PCBs)和多氯萘(PCNs)的分布特征、来源、毒性当量以及生态风险状况.土壤样品中总2,3,7,8-PCDD/Fs的含量范围为2.48-4.30 pg·g-1dw,平均3.50 pg·g-1dw,最高含量在海拔3927 m的塘房.co-PCBs的总含量平均为9.14 pg·g-1dw,最高值在海拔4487 m的垭口.总2,3,7,8-PC-DD/Fs和总co-PCBs含量随海拔高度的变化表现出正相关关系.不同海拔高度土壤中的PCDD/Fs和co-PCBs异构体的分布相似,表明具有相同的来源.总PCNs与海拔梯度呈负相关关系,最高含量出现在海拔3345 m的贝母坪,平均21.4 pg·g-1dw,主要以3.氯为主.土壤中PcDD/Fs毒性当量浓度范围为0.29-0.43pg TEQ·g-1dw.牦牛肉和牦牛组织中PcDD,/Fs总浓度分别为27.5和23.6 pg·g-1脂肪,毒性当量浓度为4.04和4.07 pg TEQ·g-1脂肪.结果表明,牦牛中的PCDD/Fg,co-PcBs和PCNs不大可能对卧龙地区人群导致严重的负面效应.     

多溴联苯醚、六溴环十二烷和四溴双酚A在环境中污染现状的研究进展

作为最主要的三大传统溴系阻燃剂(BFRs),多溴联苯醚(PBDEs)、六溴环十二烷(HBCD)、四溴双酚A(TBBPA)具有半挥发性、环境持久性和远距离传输性,目前在全球各种环境介质、生物体内广泛存在.毒理学研究表明,PBDEs、HBCD、TBBPA均具有明显的生物毒性和致癌性,对生态环境和人体健康存在潜在危害.本文简...     

Abating whey organic load through ethanol and lactic acid production by kefir

Abstract

The extent to which selected ethanol and lactic acid production bioprocesses contribute to whey waste abatement was examined. Alcoholic fermentation of whey was carried out by kefir cells immobilized on grape stalks, delignified cellulosic materials, or brewer's spent grains. Lactic acid fermentation was also performed by free kefir cells with or without addition of brewer's spent grains as promoting material. Since whey fermentation rate is affected by the lactose uptake rate, ¹⁴C-labeled lactose was used to study the fermentation ability of kefir. The highest reductions in biochemical oxygen demand and chemical oxygen demand of whey, about 68% and 52%, respectively, were achieved by lactic acid fermentation in 6 h at 37 °C and pH 5.5, in the presence of 120 g brewer's spent grains. Additionally, at the same conditions, the highest ¹⁴C-labeled lactose uptake rate by kefir and consequently the highest alcoholic fermentation rate were also recorded. However, greater reductions in biochemical oxygen demand and chemical oxygen demand of whey are required prior to final disposal.     

C/N比和曝气量影响MBR同步硝化反硝化的研究

通过连续运行MBR研究了C/N比和曝气量对同步硝化反硝化的影响,结果表明,在环境温度13～23℃,MLSS为6.0～6.8 g/L,进水NH⁺₄-N浓度50 mg/L,曝气量0.5 m³/h,HRT为6 h实验条件下,总氮去除率随着进水C/N比的增加而增加,在C/N比为6∶1～8∶1时,TN去除率达到79%～89%,低的C/N比抑制反硝化,过高的C/N比增加了碳源补加的成本。改变反应曝气量,当C/N比为6∶1,曝气量为0.4 m³/h时,TN的去除率达到了最大值85%。曝气量过高或过低,TN去除率均下降。并对在不同曝气量下MBR 内的DO 值分布进行了初步研究。     

Estimation and characterization of PCDD/Fs and dioxin-like PCBs from Chinese iron foundries

The iron foundry industry is considered to be a potential source of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). This study investigated the emission factors and total emission amounts of PCDD/Fs and dioxin-like polychlorinated biphenyls (DL-PCBs) from iron foundries in China. The concentrations and the World Health Organization toxicity equivalents (WHO-TEQs) are presented and the congener profiles are discussed in this paper.In the present work, 26 fly ash samples were collected and tested to quantify the PCDD/Fs and DL-PCBs generated by 14 plants of different scales, and five stack gas samples were collected from two (named as EFG and LFG) of those plants. The emission levels of PCDD/Fs and DL-PCBs indicated that hot-air cupolas had lower emissions than cold-air cupolas. When iron ore lump and sinter were used as raw material, the emission factors were about 250 ng TEQ t⁻¹ of product. However, if the raw material was scrap, the emission factors varied owing to the different contents of organic materials in the raw materials. It was found that the mean WHO-TEQ values of PCDD/Fs and DL-PCBs were 144 and 34.2 pg Nm⁻³ in stack gas and 20.0 and 1.58 pg g⁻¹ in fly ash. In multiple tests, it was estimated that the mean emission factors of PCDD/Fs and DL-PCBs were 365 and 10.9 ng WHO-TEQ t⁻¹ released to residue and 2719 and 555 ng TEQ t⁻¹ released to air. The total emission amounts of PCDD/Fs and DL-PCBs from Chinese iron foundries with cupola furnaces released to residue and air were 16.8 and 146 g WHO-TEQ in 2008, respectively.     

Removal of PAHs with surfactant-enhanced soil washing: influencing factors and removal effectiveness

PAH removal with surfactant enhanced washing was investigated through a series of laboratory tests to examine the effect of stirring speed, washing time, surfactant concentration, liquid/solid ratio, temperature, and on-and-off mode. The first four factors show significant influence on the PAH removal while the latter two do not. Total removal ratio and a new proposed parameter, solubilization percentage, are used to evaluate the effectiveness quantitatively.     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.