微电解-Fenton氧化联用去除高盐废水COD研究

通过正交实验法、单因素实验、连续实验等方法,验证微电解-Fenton氧化联用处理高盐难降解废水的可行性及探索最佳运行参数。结果表明微电解-Fenton氧化可以高效去除高盐废水COD,微电解最佳运行参数为pH值3,气水比15：1,反应时间(HRT)120 min,固液比1：1,Fenton反应最佳运行参数为 H2O2浓度3．5‰,反应时间(HRT)90 min,该工艺对COD整体去除率达到90%以上,处理后的废水可生化性大大提高。本工艺实验进水含盐量高,具有适应高盐度废水和快速分解COD的特点。     

Joint Effects of Inbreeding and Local Adaptation on the Evolution of Genetic Load after Fragmentation

Abstract: Disruption of gene flow among demes after landscape fragmentation can facilitate local adaptation but increase the effect of genetic drift and inbreeding. The joint effects of these conflicting forces on the mean fitness of individuals in a population are unknown. Through simulations, we explored the effect of increased isolation on the evolution of genetic load over the short and long term when fitness depends in part on local adaptation. We ignored genetic effects on demography. We modeled complex genomes, where a subset of the loci were under divergent selection in different localities. When a fraction of the loci were under heterogeneous selection, isolation increased mean fitness in larger demes made up of hundreds of individuals because of improved local adaptation. In smaller demes of tens of individuals, increased isolation improved local adaptation very little and reduced overall fitness. Short‐term improvement of mean fitness after fragmentation may not be indicative of the long‐term evolution of fitness. Whatever the deme size and potential for local adaptation, migration of one or two individuals per generation minimized the genetic load in general. The slow dynamics of mean fitness following fragmentation suggests that conservation measures should be implemented before the consequences of isolation on the genetic load become of concern.     

Assessment of Physical Load at Work Sites: A Finnish–German Concept

The aim of this article is to introduce a set of work physiology methods for the assessment of physical load at the work site and to consider (a) their relevance for different types of muscular work, and (b) their feasibility for occupational health and safety practitioners. The results of an ergonomic intervention study for the reduction of workload associated with various manual materials handling tasks were used for the evaluation of the feasibility and sensitivity of the measurements of heart rate, the Edholm and OWAS methods, and the ratings of overall and local perceived exertion. The methods proved feasible, although time consuming, and their sensitivity for the quantification of small changes in physical workload was limited. Despite these shortcomings, these methods can be used by occupational health and safety practitioners when their strategy and data collection techniques are developed further. In conclusion, there are relevant and feasible methods fora reliable work-site assessment of cardiorespiratory and postural load related to the activation of large muscle masses. On the other hand, field methods for the quantification of local static workload and repetitive type of workload with small muscle masses are scarce.     

Aluminium: The Need for a Re-Evaluation of Its Toxicity and Solubility in Mature Forest Stands

Aluminium (Al) is a key element in critical loadcalculations for forest. Here, we argue for re-evaluating theimportance of Al. Effects of two levels of enhanced Alconcentrations and lowered Ca:Al ratios in the soil solutionin a field manipulation experiment in a mature spruce stand(1996–1999) on tree vitality parameters were tested. Inaddition, Al solubility controls were tested. Various loads ofAl were added to forest plots by means of an irrigationsystem. Potentially toxic Al concentrations and criticalratios of Ca to inorganic Al were established. The ratio of Cato total Al was not a suitable indicator for unfavourableconditions for plant growth. No significant effects on crowncondition, tree growth and fine root production were observedafter three years of treatment. In 1999, foliar Mg content inthe highest Al addition treatment had declined significantly.This agreed with the known response to Al stress of seedlingsin nutrient solution experiments. No support was found forusing the chemical criterion Ca:Al ratio in soil solution,foliar and root tissue as an indicator for forest damage dueto acidification. Al solubility was considerably lower thanimplied by the assumption of equilibrium with gibbsite,particularly in the root zone. The gibbsite equilibrium iscommonly used in critical load models. Substitution of thegibbsite equilibrium with an Al-organic matter complexationmodel to describe Al solubility in soil water may have largeconsequences for calculation of critical loads. The resultsindicate that critical load maps for forests should bereconsidered.     

An Analysis of the Structure of the Simple Mass Balance Equation: Implications for Testing National Critical Loads Maps

The critical loads concept is used by the UN-ECEConvention on Long Range Transboundary Air Pollution(CLRTAP) for setting pollution reduction targets.Increasing numbers of countries are adopting the SimpleMass Balance equation (SMB) to calculate critical loads ofacidifying S and N for forest soils. The equation is madeup of a series of mass balances each of which is used tocalculate a leaching flux. The assumptions in the SMBequation were investigated by testing its ability topredict current sulphur load and by comparing each of thecalculated leaching fluxes to measured rates. It was notpossible to predict current sulphur load at our sites usingthe SMB equation. The leaching tests demonstrated that,primarily due to its steady state assumptions, the SMBequation generates critical loads that are theoretical longterm estimates of risk, and are untestable. Thesimplifying assumptions sometimes lead to illogicalresults. Some of these can be improved by adding a final,simple but dynamic, calculation step to determine theexpected time until effects are observed. Theacceptability of combining annual average data, which bestapproximates steady state, with a biological indicator isquestionable. It is not possible to test critical loadscalculated using the SMB equation when applied with all ofits assumptions but it is possible to test its fundamentalapproach using non steady state data.     

How are Results from Critical Load Calculations Reflected in Lake Water Chemistry?

The Steady State Water Chemistry Model (SSWCM) is a common method for determinations of critical loadof acid and subsequently of critical loadexceedance for lakes. One way to verify the modeloutput, is to compare with chemical indicatorssuch as pH-value, alkalinity or ANC. When themedian chemical status (as ANC) is used 65% ofthe lakes responded according to the exceedancevalue. For these the calculated exceedanceresulted in violation of the critical chemicalvalue while non-exceedance gave no violation.Since biota react on extreme conditions a morecorrect evaluation should be based on minimumvalues for the chemical indicator. This raises thefraction of lakes responding to 78%. Non-exceedance is seldom found inlakes with acid conditions. The evaluationindicates that the calculation of critical load ofacidity by means of SSWCM is very reliable.     

水解酸化-SBR工艺处理印染废水的研究

用水解酸化-SBR工艺处理印染废水的实验结果表明,出水COD平均为102mg/L,COD去除率平均为89.9%,色度去除率平均为70%.在实际工程中应用水解酸化(A)-好氧(O)-SBR工艺处理印染废水,出水COD平均为67mg/L,COD去除率平均为81.5%,色度去除率平均为66.7%.表明以水解酸化为预处理手段可有效提高印染废水的可生化性,提高整个工艺的COD去除率.     

河流污染物通量估算方法分析(Ⅱ)——时空平均离散通量误差判断

提出了一个简单的通量误差判断公式,对于采用以时空平均的一维对流量方式估算河流通量,提出了限制的条件,即排除不可靠的通量估值的方法,就河流离散通量对于通量估算的影响提供了误差判断分析方法.      

以控制资源消耗量为突破口做好环境保护规划

提出了稳态、非稳态社会经济系统在环境方面的基本关系式.着重说明了资源消耗量是源头上的"因",而环境质量是最终的"果".提出了以控制资源消耗量为重点,进一步完善末端治理,提高环境自净能力,标本兼治的环境保护工作思路.介绍了编制环保规划要掌握的2个基本公式.强调了单位(以104元计)GDP环境负荷及其年下降率的重要性.穿越"环境高山",应成为制定规划的目标.按计划管理模式,编制环境保护规划,在我国可能是完全必要的.      

172nm真空紫外辐射降解水相有机染料的机理研究

研究了氙准分子灯的172nm真空紫外辐射对水相有机染料枣红的分解机理.氙准分子灯为平面状结构,反应溶液作为灯的一端电极直接与灯表面接触.分别在枣红溶液中通入氧气和氮气以及加入KCl,以具体确定172nm辐射对枣红分子的降解是通过直接光分解还是自由基起作用.研究结果表明,在枣红的降解过程中,直接光分解起主要作用,光降解过程符合准一级动力学反应,光量子产率为6 8×10 - 3mol·eistein- 1 .在HO·、HO2 ·和O2 ·- 自由基作用下,枣红的降解在10min后偏离了准一级反应.枣红降解效率达到约80 %后,COD去除率开始增大.GC MS分析表明,在光分解和热氧化作用下,枣红分子在降解过程中形成了许多小分子碎片.