Adsorption of As(III) on chitosan-Fe-crosslinked complex (Ch-Fe)

It was reported the adsorption of As(III) on the surface of the chitosan-Fe-crosslinked complex. Theoretical correlation of the experimental equilibrium adsorption data for As(III)/Ch-Fe system is best explained by the non-linearized form Langmuir-Freundlich isotherm model. At optimum conditions, pH 9.0, the maximum adsorption capacity, calculated using the Langmuir-Freundlich isotherm model was 13.4 mg g⁻¹. The adsorption kinetics of As(III) onto Ch-Fe are described by the pseudo-first-order kinetic equation. The results of the Mössbauer spectroscopy showed that there is no redox process on the surface of the adsorbent.     

Dechlorination of PCBs in the simulative transformer oil by microwave-hydrothermal reaction with zero-valent iron involved

The conventional hydrothermal reaction with iron powder, NaOH and H₂O as reactants was reported to occur at temperature above 423 K, and iron oxides (Fe₃O₄ and NaFeO₂) and hydrogen were produced. In this study, microwave heating was adopted to take the place of conventional heating to induce the hydrothermal reaction. Under microwave irradiation, NaOH and H₂O absorbed microwave energy by space charge polarization and dipolar polarization and instantly converted it into thermal energy, which initiated the hydrothermal reaction that involved with zero-valent iron. X-ray diffraction (XRD) analysis found Fe₃O₄/NaFeO₂ and confirmed the occurrence of microwave-induced hydrothermal reaction. The developed microwave-hydrothermal reaction was employed for the dechlorination of PCBs. Hexadecane containing 100 mg L⁻¹ of Aroclor1254 was used as simulative transformer oil, and the dechlorination of PCBs was evaluated by GC/ECD, GC/MS and ion chromatography. For PCBs in 10 mL simulative transformer oil, almost complete dechlorination was achieved by 750 W microwave irradiation for 10 min, with 0.3 g iron powder, 0.3 g NaOH and 0.6 mL H₂O added. The effects of important factors including microwave power and the amounts of reactants added, on the dechlorination degree were investigated, moreover, the dechlorination mechanism was suggested. Microwave irradiation combined with the common and cheap materials, iron powder, NaOH and H₂O, might provide a fast and cost-effective method for the treatment of PCBs-containing wastes.     

Zero-valent iron nanoparticles in treatment of acid mine water from in situ uranium leaching

Acid mine water from in situ chemical leaching of uranium (Straz pod Ralskem, Czech Republic) was treated in laboratory scale experiments by zero-valent iron nanoparticles (nZVI). For the first time, nZVI were applied for the treatment of the real acid water system containing the miscellaneous mixture of pollutants, where the various removal mechanisms occur simultaneously. Toxicity of the treated saline acid water is caused by major contaminants represented by aluminum and sulphates in a high concentration, as well as by microcontaminants like As, Be, Cd, Cr, Cu, Ni, U, V, and Zn. Laboratory batch experiments proved a significant decrease in concentrations of all the monitored pollutants due to an increase in pH and a decrease in oxidation-reduction potential related to an application of nZVI. The assumed mechanisms of contaminants removal include precipitation of cations in a lower oxidation state, precipitation caused by a simple pH increase and co-precipitation with the formed iron oxyhydroxides. The possibility to control the reaction kinetics through the nature of the surface stabilizing shell (polymer vs. FeO nanolayer) is discussed as an important practical aspect.     

铁炭微电解法预处理超高盐榨菜腌制废水

超高盐榨菜腌制废水是高盐、高氮磷及高有机物废水,目前常采用生物方法进行处理,但因高污染物浓度及高盐度影响,处理效果不够理想;因此,选用铁炭微电解法对超高盐榨菜腌制废水进行预处理。通过静态烧杯实验,研究了反应时间、初始pH、铁炭体积比和铁水体积比对COD和氨氮去除率的影响。单因素实验的最佳处理条件：原水pH4～4．5,反应时间为30min,铁炭体积比为1：1,铁水体积比为2：1,出水COD和氨氮的去除率分别为57．29％和53．11％,盐度由原水的6．62％下降为3．63％,去除率达45．17％,pH由原水4．01升高为6．38。正交实验结果表明,影响COD和氨氮去除率的因素从大到小的顺序为：铁水体积比、初始pH、反应时间、铁炭体积比。实验表明,采用铁炭微电解法能够对超高盐榨菜腌制废水中的COD和氨氮进行有效去除,出水的pH升高和盐度下降,能满足后续生物处理的预处理要求。     

超声波-铁粉协同降解五氯酚

通过超声波-铁粉联合体系协同降解废水中的五氯酚(PCP).实验结果表明:降解120 min后,PCP去除率可达90.4％;在该体系中铁粉被逐渐腐蚀成Fe2+,随降解时间的延长,Fe2+浓度逐渐增加;体系中的Fe2+可以促进·OH的产生,并且可以与超声空化作用下产生的H2O2发生Fenton试剂氧化反应降解PCP;超声波...     

土壤中零价铁还原3-氯硝基苯的作用

利用零价铁在常温常压下对土壤中的3-氯硝基苯的还原,对反应物和产物随时间的变化及反应的各个影响因素进行了研究。实验结果表明,零价铁能够有效地将3-氯硝基苯还原为3-氯苯胺,反应过程中没有检测到脱氯产物。其反应速率随铁粉用量、反应体系含水量的增加以及反应温度的升高而升高,随土壤初始pH值的升高而降低。在土壤中3-氯硝基苯含量约为2.5×10^-6 mol/g,铁粉使用量为25 mg/g,反应体系中含水量为0.75 mL/g,pH值为6.8时,在恒温生化培养箱(25±1)℃反应5 h后,3-氯硝基苯的还原率达到92.75％。     

铁改性海泡石除锑的影响因素研究

选择廉价海泡石, 用氯化铁对其改性。研究铁改性海泡石对锑的吸附特性。结果表明,氯化铁浓度、吸附时间、初始锑浓度以及温度等因素对锑的吸附影响较大,溶液初始pH影响不明显。在初始锑浓度50 mg/L,pH 6.8,5%氯化铁改性海泡石投加量为2 g/L,吸附90 min, 温度35℃下,吸附量可达21.6 mg/g。海泡石对吸附锑具有缓冲特性,溶液的初始pH值在3.1～10.1范围时,吸附后溶液的最终pH值为8～8.5。IMS吸附锑是放热过程。改性后海泡石比表面积增大,表面羟基数量增加,导致其吸附能力增强。通过XRD谱图并未发现铁晶体的存在。     

Ecogenetic features and functions of solods in transural forest-steppes (within Sverdlovsk Oblast)

Specific ecogenetic features of solods in the forest-steppe zone has been studied, and the role of biotic and abiotic factors of soil formation has been estimated. Differentiation of soil horizons with respect to the physical clay fraction accounts for specific features of their moistening, which is reflected in the ratio of strongly and weakly crystallized forms of iron. Periodic changes in redox conditions results in iron segregation, and a high content of fulvic acids accounts for its eluvial migration. These processes are controlled by soil geochemical barriers.     

Degradation of pentachlorobiphenyl by a sequential treatment using Pd coated iron and an aerobic bacterium (H1)

The reductive dechlorination and biodegradation of 2,2^′4,5,5^′-pentachlorobiphenyl (PCB#101) was investigated in a laboratory-scale. Palladium coated iron (Pd/Fe) was used as a catalytic reductant for the chemical degradation of 2,2^′4,5,5^′-pentachlorobiphenyl, and an aerobic bacteria was used for biodegradation following the chemical reaction in this study. Dechlorination was affected by several factors such as Pd loading, initial soil pH and the amount of Pd/Fe used. The results showed that higher Pd loading, higher dosage of Pd/Fe and slightly acid condition were beneficial to the catalytic dechlorination of 2,2^′,4,5,5^′-pentachlorobiphenyl. In laboratory batch experiments, 2,2^′4,5,5^′-pentachlorobiphenyl was reduced in the presence of Pd/Fe bimetal, which was not further degraded by aerobic bacteria. 2,2^′,4-trichlorobiphenyl (PCB#17), a reduction product from 2,2^′4,5,5^′-pentachlorobiphenyl, was readily biodegraded in the presence of a aerobic bacterial strain. It is suggested that an integrated Pd/Fe catalytic reduction-aerobic biodegradation process may be a feasible option for treating PCB-contaminated soil.     

废钢铁切割加工烟尘的治理

介绍了氧-乙炔火焰切割加工废钢铁产生的烟尘治理系统的设计和系统设备选型,重点介绍了烟尘捕集罩的设计和除尘器、电磁脉冲阀、风机的选型和PLC自动控制以及系统实际运行效果,为废钢铁加工企业治理污染提供一套简单、经济、实用的除尘系统作参考.