酿酒酵母吸附Pb(Ⅱ)的表面特性研究

为深入探讨酿酒酵母吸附Pb（Ⅱ）的微观作用机制,本文利用表面显微分析技术（SEM-EDS、TEM-EDS、AFM）研究了酿酒酵母细胞吸附重金属离子Pb（Ⅱ）前后的细胞表面变化.研究结果表明,酿酒酵母细胞与Pb（Ⅱ）作用后,细胞表面除吸附Pb（Ⅱ）外,同时产生大量更高浓度的含Pb（Ⅱ）沉淀,导致Pb（Ⅱ）从溶液中被去除.酵母与Pb（Ⅱ）反应前,酵母细胞表面可检测到的主要元素包括C、O、N、P、S、K、Mg;酵母与Pb（Ⅱ）作用后,细胞表面始终保持C、O、P吸收峰,而N、K、Mg、S吸收峰随反应条件不同而减弱、消失或增强.P作为细胞表面组分可能与Pb（Ⅱ）结合.酵母与Pb（Ⅱ）作用过程中,重金属离子促进酵母细胞释放细胞内含物.原子力显微镜（AFM）证实,云母片表面对酵母吸附Pb（Ⅱ）后细胞的铺展变形作用明显增大.     

脱水污泥等温干燥特性实验研究及回归分析

利用热重差热分析仪（DTG）对脱水污泥进行干燥实验,测定干燥参数和干燥条件对脱水污泥等温干燥特性的影响,研究了3个温度水平（85℃,100℃,120℃）,5个空气流速（10mL/min,20mL/min,40mL/min,50mL/min,70mL/min）和3个升温速率（15℃/min,20℃/min,40℃/min）。结果表明,样品的干燥速率随着终温的升高、升温速率和空气流速的增大而加快。脱水污泥的干燥过程主要分为加速、恒速和降速3个阶段,且降速干燥段在整个干燥过程中所占的比例较大。其干燥数学模型符合Page方程,经拟合得到 。验证表明,拟合方程算得的MR值与实验结果比较接近。该模型方程可用于描述城市污水污泥的干燥。     

闽江下游突发性水污染事故时空模拟

以闽江下游为例,基于有限元法建立闽江下游水动力模型及水质模型,通过对模型进行率定和验证,表明该模型具有较理想的模拟效果.在此基础上,利用闽江下游2004年的水文情况,模拟了突发性水污染事故中污染物的运移扩散过程.定量模拟了突发性水污染事故发生后,闽江下游不同地点处污染物到达的时间和浓度值,并对突发风险事故的影响范围、程...     

Sustainability issues in sheet metal forming processes: an overview

Environmental sustainability in manufacturing is nowadays an urgent and remarkable issue and the main concerns are related to more efficient use of materials and energy.In sheet metal forming processes there is still a lack of knowledge in this field mainly due to the need of a proper modelling of sustainability issues and factors to be taken into account. The aim of this paper is mainly to underline the state of the art from a forming point of view about the sustainability contributions offered in any phase of a product life cycle. Actually, a lack in terms of comprehensive contributions is present in the technical literature, thus, the authors try to give a sort of holistic vision aimed to provide basic guidelines in order to help in identifying the possible solutions with regard to all the phases of a forming product life cycle. The main attention was paid to sheet metal forming technologies. The paper gives an overview of the main topics concerning sheet metal forming problems related to energy and resource efficiency with the aim to stress the principal contributions which may derive from such processes to environmental performances of manufacturing.     

南方重金属矿区重金属的污染特征及评价

 采用全面踏查和典型调查相结合的方法,对福建主要重金属矿区的尤溪铅锌矿、连城铅锌矿和连城锰矿不同片区重金属污染状况进行调查。结果表明：福建重金属矿区重金属污染极其严重,矿区中Mn、Zn、Pb、Cd最高含量分别达92 546、27 454、23 792和248 mg/kg,是对照区的几倍至上百倍。根据国家土壤环境质量三级标准,按照重金属单项污染指数标准进行的污染评价表明：南方重金属矿区Zn、Pb、Cd均达到重度污染标准,污染程度表现为尤溪铅锌矿区>连城铅锌矿区>连城锰矿区。按照综合污染指数评价标准,福建连城铅锌矿、连城锰矿和尤溪铅锌矿的综合污染指数也达到重度污染标准,分别是重度污染临界标准的16.5、10.6和53.6倍,不同矿区的重金属污染程度大小排序为尤溪铅锌矿区>连城铅锌矿区>连城锰矿矿区。     

赤水河流域生物多样性保护现状和对策

基于对赤水河流域生物多样性的综合调研,分析了赤水河流域生物多样性的主要特征、流域生物多样性保护的现状、面临的机遇和潜在的压力,探讨了赤水河流域生物多样性保护的基本对策。提出赤水河流域生物多样性保护应在国家政策框架内,在流域综合管理理念指导下兼顾重点区域保护和生态廊道建设,探索流域尺度上生物多样性保护与流域社会经济协调有序发展的新型管理模式。     

汉江下游水污染协同控制探讨

以一维河流单种污染物的水污染协同控制理论为基础,以汉江武汉段水质达到国家III级为目的,探讨了河流的水污染控制量。根据各排污口的实测CODCr、BOD5、NH3-N浓度和排放流量,结合河流的流量和水质标准,得出汉江武汉段的水污染协同控制量。计算结果表明,汽配排污口BOD5排放量需削减198 t/a,汉正下河街排污口BOD5排放量需削减617 t/a,其它排污口BOD5排放量在允许值范围以内;各排污口的CODCr排放量均在允许值范围以内;国棉三厂排污口NH3-N排放量需削减57 t/a,汉正下河街排污口NH3-N排放量需削减95 t/a,其它排污口NH3-N排放量在允许值范围以内。该方法充分考虑各污染源合理利用环境的自然降解能力,比简单要求每个污染源都达标排放更合理,对各污染源也更加公平,也容易被排污企业接受,具有一定的实用价值。     

1株脱氮除磷菌的筛选及其特性研究

采用YG培养基,结合蓝白斑筛选、异染粒染色及好氧除磷能力检测等实验,从城市生活污水处理厂好氧生化池的活性污泥中分离出7株好氧除磷菌;再经硝酸盐还原产气和缺氧培养实验,筛选出1株高效脱氮除磷菌;通过16S rRNA基因同源性比较和生理生化鉴定,初步将其鉴定为Pseudomonas grimontii,命名为C18.菌株C18在好氧培养24h后,培养基中上清液磷浓度从38.7mg/L降低到2.28mg/L,除磷率达94.1%.C18在缺氧培养24h后,培养基中上清液磷浓度从44.5mg/L降低到5.21mg/L,除磷率达88.3%;上清液硝酸盐氮浓度从184.2mg/L降低到30.6mg/L,脱氮率达83.4%.菌株C18最适脱氮除磷温度为30℃;最适脱氮除磷pH为7.5.     

220kV变压器噪声及其传播特性浅析

变压器噪声呈中低频特性,距离衰减率低,传播影响范围大。通过对上海某220kV露天变电站变压器噪声的实测数据进行简要分析,论述了220kV变压器噪声的强度及其频率特性,并探讨了变压器噪声在不同距离范围内的传播衰减特性。     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).