Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

大型空间环境模拟器真空系统配置技术研究

分别对国内外大型空间环境模拟器的真空系统配置进行了介绍,并对真空系统各个子系统的配置与技术特点进行了分析,重点针对大型空间环境模拟器真空系统中所需的真空抽气策略进行了研究,为后续超大型环境试验设备的研制和试验测试提供了参考。     

油气集输管道内防腐技术应用进展

针对油气田集输管道的内腐蚀问题,分别介绍了耐蚀材料、衬里技术、涂镀层技术与药剂防腐技术等管道内防腐技术及其现场应用效果,指出了耐蚀金属材料防腐效果显著,但存在经济效益差的缺点。为降低成本,选用双金属复合管替代耐蚀金属材料,但其焊缝位置腐蚀失效频发,成为制约其应用的薄弱环节。耐蚀非金属材料防腐效果显著,但耐高温性能与力学性能较差,受温度、压力与CO_2、H_2S、固体颗粒等介质成分的影响,衬里技术与涂镀层技术的应用范围受到限制。药剂防腐技术的防护效果与药剂类型、加药工艺密切相关,需要根据腐蚀工况监测结果进行实时调整。针对上述内防腐技术存在的问题,提出了未来内防腐技术的发展方向为改进现有内防腐技术存在的不足,提升其防护效果。同时,应开发防腐效果显著、经济成本低、施工简便、易于推广应用的防腐材料与防腐工艺技术。     

碳量子点掺杂氮化碳提高的光电化学阴极保护性能研究

目的研究g-C_3N_4/C-Dots-M复合材料的光电化学阴极保护性能。方法采用X射线衍射(XRD)、扫描电子显微镜(SEM)和紫外可见漫反射光谱技术对样品的晶体结构、微观形貌和光吸收性能进行表征。通过电化学测试可见光照射下g-C_3N_4/C-Dots-M复合材料光电极偶联316L不锈钢后的光电化学阴极保护电流密度和电位变化曲线,研究材料的光电化学阴极保护性能。结果可见光照射下,该偶联体系的光致混合电位下降至-0.43 V(vs. Ag/AgCl),光电化学阴极保护电流密度达到4.3μA/cm。结论得益于碳量子点优异的电子传导特性,g-C_3N_4/C-Dots-550复合材料的光电化学阴极保护性能比纯g-C_3N_4的明显增强。该复合材料在光电化学阴极保护方面展现了较大的应用潜力。     

喷丸强化技术在某型作动筒延寿修理中的应用

目的将某型作动筒的寿命由6000±150起落延长至12 000±150起落。方法采用喷丸强化技术对作动筒的主要承力零件进行喷丸强化处理,提高零件的抗疲劳和抗应力腐蚀性能。通过疲劳寿命试验验证对比喷丸强化处理前后典型零件和作动筒的寿命指标是否达到了预期目标。结果喷丸强化处理前的3件前耳环螺栓试验循环次数均未超过1.8×10~6即断裂,喷丸强化后达到3.6×10~6时仍未断裂。喷丸强化处理后的4件主耳环螺栓与喷丸强化处理前对比,断裂时的试验循环次数均有不同程度的提高,均值寿命比值大于2.36。喷丸强化处理前后的主前作动筒疲劳寿命试验达到预期的循环次数时,均没有出现断裂或者损坏。结论喷丸强化处理能有明显提高作动筒的抗疲劳和抗应力腐蚀性,强化处理后的零件疲劳寿命能够超过处理前的2倍,可以采用喷丸强化技术延长作动筒的使用寿命。     

DZ125合金HY3包覆型涂层退除研究

目的 研究化学法退除DZ125合金HY3包覆型涂层。方法 采用真空电弧镀技术（AIP）在定向凝固镍基高温合金DZ125上制备包覆型涂层HY3,利用化学方法完全退除基体上的涂层,通过失重法研究对比1#和2#退除溶液退除HY3涂层和DZ125合金的退除速率,采用扫描电镜（SEM）对退除后的HY3涂层和DZ125基体的微观组织进行观察。结果 经过100 min,2#溶液可以将20 ?m左右的HY3涂层完全退除,采用1#溶液需要超过100 min才能完全退除涂层。两种对DZ125合金的腐蚀性很小,对于同一种合金而言,1#溶液和2#溶液对合金的腐蚀速率比值为1︰13。在1#溶液中,合金与涂层腐蚀速率的比值为1︰87.65;在2#退除溶液中,合金与涂层腐蚀速率的比值为1︰6.81。结论 1#溶液更加适合退除DZ125合金上的HY3涂层。     

水稻土中五氯酚的降解转化动态及其对微生物群落的影响

采用室内培养实验,研究厌氧条件下水稻土中五氯酚(Pentachlorophenol,PCP)的还原转化与微生物群落组成变化。结果表明,室内培养实验条件下,PCP在水稻土样品中降解比较迅速,在反应17 d时,实验添加的PCP能够完全被还原转化。高通量测序结果显示PCP的添加明显改变了水稻土壤的微生物群落结构,其微生物多样性显著下降,在PCP降解完之后逐渐恢复。原始土壤以及添加PCP的土壤样品中其优势微生物主要分布在变形菌门(Proteobacteria)。PCP添加刺激了水稻土中伯克氏菌科(Burkholderiaceae)、丛毛单胞菌科(Comamonadaceae)、地杆菌科(Geobacteraceae)、红环菌科(Rhodocyclaceae)和假单胞菌科(Pseudomonadaceae)等脱氯相关的微生物菌群繁殖,成为PCP降解过程中的优势菌群,有利于PCP还原降解。本研究结果可为水稻土中有机氯农药污染物的微生物降解脱毒提供理论依据。     

FRP加固金属结构技术应用研究进展

从FRP加固金属结构设计研究、界面性能研究、工艺研究、耐久性研究等4个方面回顾了FRP加固金属结构技术的发展历程。探讨了FRP加固技术的优势,总结了现阶段FRP修复技术取得的成就和现阶段发展存在的不足。最后,对未来FRP修复技术的发展做了总结。可以预见,随着高性能FRP的不断研制成功以及研究的深入,FRP修复技术必将得到更广泛的应用。     

Land Degradation Monitoring in Namibia: A First Approximation

This paper presents development of a first approximation of a Namibian, national level, land degradation monitoring system. The process involved a large number of stakeholders and led to the definition of four primary indicators that were regarded as related to land degradation in Namibia: population pressure, livestock pressure, seasonal rainfall and erosion hazards. These indicators were calculated annually for the period 1971–1997. Annual land degradation risk maps were produced for the same period by combining the indicators. A time series analysis of results generated by indicators was undertaken at two sites. The analysis revealed a general trend towards an increased land degradation risk over the period 1971–1997. A decrease in annual rainfall and an increase in livestock numbers caused this negative trend at one site, while decreased annual rainfall and increased human population were the causes at a second site. Evaluation of resulting maps through direct field observations and long-term monitoring at selected study sites with different conditions relevant for the indicators defined, is an essential next step.     

发展我国环境监测技术产业的探讨

本文从发展我国环境监测技术产业的角度论述了环境监测技术产业的主要内容，分析了我国环境监测技术产业的发展和存在的问题，对发展我国环境监测技术产业提出了建议。