金属涂料生产中挥发性有机物（VOC）的污染及其防治

阐明了金属涂料生产中挥发性有机物（VOC）的危害性,介绍了一种工程造价低,处理效果较好的治理方法,供投资生产金属涂料的生产者参考。     

新疆315国道公路水毁病害形成机制与治理

水毁是新疆315国道主要病害类型。根据现场调查,将新疆315国道公路水毁分为淘底塌滑、冲蚀啃边、冲刷截断3种类型;从自然因素、气候、河床地质条件和公路自身建设缺陷系统分析了新疆315国道茫崖-且末段公路水毁的形成环境;开发了适用于该段公路的格宾箱体结构和格栅笼两类新技术,前者适用于干沟及冲沟地段的水毁防治,后者适用于戈壁滩地段的水毁防治,并分别依托工程得到了应用,通过室内物理模型试验验证了其防治效果。试验结果表明,所提治理技术具有较强的实用性及经济优势。     

Imazaquin degradation and metabolism in a sandy loam soil amended with farm litters

Irnazaquin applied in legume crops has a long residual time in soil, which often impacts safety of the susceptible crops. To increase safety of imazaquin application, two composted litters, bovine manure （BM） and chicken manure （CM）, were used to determine their effects on imazaquin environmental behavior by incorporating each kind of manure into the tested sandy loam soil at 10% （w/w）. The degradation of imazaquin in BM- and CM-amended soil was about 2.4 and 1.5 times, respectively, faster than that in unamended soil. The half-lives of imazaquin in BM-amended soil varied between 6.7 and 15.4 d over the temperature range of 20 to 40℃, and the degradation rate constant （k） increased by a factor of about 1.5 for every 10℃ change. Higher mix ratio did not significantly increase the degradation, and the optimal active degradation of imazaquin was observed approximately at the mix ratio of 10：1 of soil to BM. The different moisture levels had negligible effect on imazaquin degradation. In both unamended and BM-amended treatments, two metabolites were observed at 5, 10 and 30 d after treatment. One metabolite at retention time （RT） of 8.4 rain was identified as 2-（4- hydroxyl-5-oxo-2-imidazolin-2-yl） quinoline acid, originating from the loss of isopropyl group and hydroxylation at the 4-position of imidazolinone ring. The other at RT of 12.9 rain was identified as quinoline-2,3-dicarboxylic anhydride, resulting from detachment of imidazolinone ring and the forming of dicarboxylic anhydride. This finding suggested that the addition of farm litters into soil might be a good management option since it can not only increase soil fertility but also contribute to increase safety of imazaquin application to the following susceptible crops.     

双曲扁壳覆盖件抗凹刚度和稳定性的实验研究

此丈对不同成形条件下压制得到的矩形双曲扁壳进行了抗凹试验,分析了载荷--位移试验曲线的特征,零件凹陷特点及失稳模式,得到了反映抗凹刚度和稳定性的特征参数及其和零件几何的关系,并讨论了改善和提高覆盖件抗凹刚度和稳定性的措施。     

金属管件在液压机上用模具弯曲成形方法

介绍了金属管件在液压机上用模具弯曲成形的特点及优缺点。     

利用塑性介质挤胀成形三通管接头变形力的研究

此文对利用塑性介质挤胀成形三通管接头变形力进行了实验研究。设计了一套挤胀成形三通管接头的通用装置,并利用此装置进行了三通挤胀成形实验。此研究给出了影响成形过程的一些重要参数。将理论结果与实验结果进行了对比,两者吻合较好。     

极限变形程度下纯铝反挤压变形力的研究

针对具体工件对根限变形程度下纯铝反挤压的变形力进行研究,分析了各种计算方法的适用范围,并与工艺试验的实测值进行了比较.     

大直径薄壁钢筒变薄旋压成形工艺研究

论述大径比高精钢筒变薄旋压成形试验过程 ,通过确定合理工艺过程 ,选择最佳工艺参数 ,从而旋出了合格筒体。结果表明 ,D40 6A钢退火状态变薄旋压性能良好 ,旋压塑性变形稳定 ;有效控制扩径量和壁厚差是变薄旋压成形和获取高精钢筒的关键     

链条滚子精密成形新工艺

针对链条滚子成形存在的问题,提出了一种利用棒料以冷挤压成形为主,在连续模中进行多个工序连续成形的精密成形工艺方案,从而提高了材料的利用率和工厂的经济效益。     

盐酸酸洗废液制备复合聚合氯化硫酸铁

以盐酸酸洗废液和适量硫酸亚铁为原料 ,用盐酸或硫酸调节酸度 ,在一定的温度和压力条件下 ,经催化氧化、水解、聚合 ,反应约 3h即可制得复合聚合氯化硫酸铁。经检验 ,产品的铁 (Fe3 + )含量为 16 5 /g·L-1,亚铁 (Fe2 + )含量≤ 1.0 /g·L-1,盐基度≈ 10 .5 %。