钒和钨负载量对V2O5-WO3/TiO2表面形态及催化性能的影响

采用浸渍法制备了一系列不同钒和钨负载量的V₂O₅-WO₃/TiO₂催化剂样品,对样品NH₃选择性催化还原NO性能进行了评价,并用BET、XRD、XPS等手段对催化剂样品的表面形态进行了表征.研究发现,钒的负载量对催化剂的比表面积和催化活性有显著影响,当钒负载量从1％升高到8％时,催化剂比表面积下降了16 m²/g,最高活性温度降低了约100℃.钨起到稳定剂和助剂的双重作用,当钒负载量为1％时,钨负载量从0升高到6％,催化剂比表面积仅下降了3 m²/g,而活性温度窗口向高温和低温各拓宽了约50℃.研究表明钒和钨负载量都能影响催化剂表面的VO_x物种,但对催化剂的表面晶型没有明显影响.     

Dechlorination of carbon tetrachloride by the catalyzed Fe-Cu process

The electrochemical reduction characteristics of carbon tetrachloride (CT) were investigated using cyclic voltammetry in this study. In addition, the difference in reduction mechanisms of CT between Master Builders' iron and the catalyzed Fe-Cu process was discussed. The results showed that CT was reduced directly on the surface of copper rather than by atomic hydrogen produced at the cathode in the catalyzed Fe-Cu process. The reduction was realized largely by atomic hydrogen in Master Builders' iron. The entire CT in 350 ml aqueous solution with 320 mgL was reduced to trichloromethane and dichloromethane in 2.25 h when 100 g of scrap iron with FeCu ratio of 10:1 (ww) were used. Moreover, the reduction rate slowed with time. CT could be reduced at acidic, neutral and alkaline pH from solution by Fe-Cu bimetallic media, but the mechanisms were di?erent. The degradation rate was not significantly in?uenced by pH in the catalyzed Fe-Cu process; in Master Builders' iron it clearly increased with decreasing pH. The kinetics of the reductions followed pseudo-first order in both cases. Furthermore, the reductions under acidic conditions proceeded faster than that under the neutral and alkaline conditions. The catalyzed Fe-Cu process was superior to Master Builders' iron in treating CT-containing water and this advantage was particularly noticeable under alkaline conditions. The reduction was investigated in the cathode (Cu) and anode (Fe) compartments respectively, the results showed that the direct reduction pathway played an important role in the reduction by the catalyzed Fe-Cu process. The catalyzed Fe-Cu process is of practical value.     

Arsenic uptake and transport of Pteris vittata L. as influenced by phosphate and inorganic arsenic species under sand cu｜ture

In order to understand the similarity or difference of inorganic As species uptake and transport related to phosphorus in As-hyperaccumulator, uptake and transport of arsenate (As(Ⅴ)) and arsenite (As(Ⅲ)) were studied using Pteris vittata L. under sand culture. Higher concentrations of phosphate were found to inhibit accumulation of arsenate and arsenite in the fronds of P. vittata. The reduction in As accumulation was greater in old fronds than in young fronds, and relatively weak in root and rhizome. Moderate increases, from 0.05 to 0.3 mmol/L, in phosphate reduced uptake of As(Ⅲ) more than As(Ⅴ), while the reverse was observed at high concentrations of phosphate (≥ 1.0 mmol/L). Phosphate apparently reduced As transport and the proportion of As accumulated in fronds of P. vittata when As was supplied as As(Ⅴ). It may in part be due to competition between phosphorus and As(Ⅴ) during transport. In contrast, phosphate had a much smaller effect on As transport when the As was supplied as As(Ⅲ). Therefore, the results from present experiments indicates that a higher concentration of phosphate suppressed As accumulation and transport in P. vittata, especially in the fronds, when exposure to As(Ⅴ); but the suppression of phosphate to As transport in the root or rhizome may be insignificant when P. vittata when exposure to As(Ⅲ) under sand culture conditions. The finding will help to understand the interaction of P and As during their uptake process in P. vittata.     

载Pt石墨催化臭氧化降解水中草酸的研究

以石墨为催化剂载体,以H₂PtCl₆·6H₂O为贵金属活性组分前驱物,采用等体积浸渍法制备了Pt/石墨催化剂.对Pt/石墨催化臭氧化、石墨催化臭氧化以及单独臭氧氧化降解草酸的效果进行了研究.结果表明,在本实验条件下,单独臭氧氧化、石墨催化臭氧化和Pt/石墨催化臭氧化草酸的去除率分别为3.0%、47.6%和99.3%.Pt的负载可以显著地提高石墨催化臭氧化的效果.以草酸的去除效率为催化活性指标对Pt/石墨催化剂的制备条件进行了优化.结果表明,石墨载体的预处理没有提高Pt/石墨催化剂的活性.Pt/石墨催化剂最佳制备条件为：以水为溶剂,浸渍时间24　h,活性组分Pt的负载量为1.0%,氢还原温度为350℃.所制备催化剂经重复使用5次,草酸去除率仍超过90％.     

ACF负载金属氧化物及尿素低温去除NO

以活性炭纤维(ACF)负载NiO以及NiO-CeO2制备了一系列催化剂,并在催化剂上负载尿素作为还原剂,研究其在30～120℃范围内的催化还原NO的活性.通过SEM、BET、XRD等表征实验选择性地对催化剂进行了理化特征研究.结果表明,3种不同质量分数的NiO催化剂中,5%NiO/ACF效率较低,10%NiO的催化剂活性以及活性稳定性较好,在90℃即可达到50%左右的NO净化效率,15%NiO/ACF的催化活性稳定性较差.在3种不同质量分数的NiO-CeO2/ACF催化剂中,5%NiO-5%CeO2/ACF的活性以及活性稳定性最好,在110℃可达到55%以上的NO净化效率.10%CeO2-5%NiO/ACF活性高于5%CeO2-10%NiO/ACF;活性金属的最佳负载量为10%,过多的负载量会引起催化剂比表面积的减少从而导致催化剂活性下降;金属氧化物是催化反应的活性中心.对10%CeO2/ACF、10%NiO/ACF和5%CeO2-5%NiO/ACF的研究显示,5%CeO2-5%NiO/ACF的催化活性最好,CeO2和NiO的协同作用使催化剂的活性优于2种单独负载的催化剂.本研究还对催化剂的低温催化机制进行了分析和讨论.     

小白菜对猪粪中高Cu和Zn的富集与转运

近年来,规模化养猪中Cu和Zn广泛应用于饲料添加剂,导致猪粪含大量的cu和Zn.猪粪土地利用中高Cu和Zn导致的环境污染和植物效应已引起了人们的高度关注.研究高Cu和Zn的猪粪施入土壤后典型蔬菜对Cu和Zn的富集和转运,可为有机蔬菜安全生产和品质提高提供科学依据,对粪便中重金属的健康风险评价具有重要的参考价值.本研究以...     

劣质原油加工过程中重金属污染控制方案

重金属污染是我国污染防控的难点和重点。随着劣质原油加工量的增加,劣质原油加工过程中重金属的环境影响正日益受到关注。根据加工过程中重金属的分布情况及所采用的加工工艺,对劣质原油加工过程中的重金属污染进行控制有重要意义。     

Modification of CeO2-ZrO2 catalyst by potassium for NOx-assisted soot oxidation

Potassium-modified ceria-zirconia catalyst was synthesized by wetness impregnation method.The ageing treatment was performed in static air at 800°C for 20 hr to evaluate the thermal stability of the catalyst.The catalysts were characterized by X-ray diffraction,BET surface area,oxygen storage capacity,NOx-temperature programmed desorption and soot-temperature programmed oxidation measurements.By introduction of potassium,the maximum soot oxidation rate temperature(Tm) of the ceria-zirconia based catalyst de...     

钙基CO2吸收剂的锆改性研究

实验采用共沉淀法以Ca(Ac)2·H2O作为CaO前驱体,经NH3·H2O沉淀、静置、醇洗、烘干制备锆改性钙基高温二氧化碳吸收剂,并考察锆添加量、反应温度及时间、CO2分压等因素列其吸收性能的影响.经锆改性后,吸收剂中掺杂ZrO2形成了良好的介孔结构,可维持较高的碳酸化转化率,提高吸收剂的循环热稳定性.测试结果表明,当...     

粉煤灰基催化剂深度处理印染废水的研究

采用粉煤灰基催化剂催化臭氧氧化深度处理印染废水。通过正交试验考察了O3输出体积分数、催化剂的投加量、pH值、反应时间对处理效果的影响,影响程度从大到小依次为:O3输出体积分数>pH值>催化剂投加量>反应时间。并通过单因素实验确定在最佳反应条件下:O3的输出体积分数为40%(即质量浓度为9.22 mg/L),催化剂的投加量为4 g,pH值为6.5,反应时间为60 min;COD的去除率能从单独臭氧氧化的41.44%提高到73.87%,色度去除率也能达到98%。各项指标均达到了印染废水的回用要求。