Recovery of solid fuel from municipal solid waste by hydrothermal treatment using subcritical water

Hydrothermal treatments using subcritical water (HTSW) such as that at 234 °C and 3 MPa (LT condition) and 295 °C and 8 MPa (HT condition) were investigated to recover solid fuel from municipal solid waste (MSW). Printing paper, dog food (DF), wooden chopsticks, and mixed plastic film and sheets of polyethylene, polypropylene, and polystyrene were prepared as model MSW components, in which polyvinylchloride (PVC) powder and sodium chloride were used to simulate Cl sources.While more than 75% of carbon in paper, DF, and wood was recovered as char under both LT and HT conditions, plastics did not degrade under either LT or HT conditions. The heating value (HV) of obtained char was 13,886-27,544 kJ/kg and was comparable to that of brown coal and lignite. Higher formation of fixed carbon and greater oxygen dissociation during HTSW were thought to improve the HV of char.Cl atoms added as PVC powder and sodium chloride to raw material remained in char after HTSW. However, most Cl originating from PVC was found to converse into soluble Cl compounds during HTSW under the HT condition and could be removed by washing.From these results, the merit of HTSW as a method of recovering solid fuel from MSW is considered to produce char with minimal carbon loss without a drying process prior to HTSW. In addition, Cl originating from PVC decomposes into soluble Cl compound under the HT condition. The combination of HTSW under the HT condition and char washing might improve the quality of char as alternative fuel.     

重钢LF炉除尘系统工艺分析与改建

论述了关于重庆钢铁股份有限公司炼钢厂LF炉除尘工艺的现状和系统的不足,并且就相关技术问题进行了分析与研讨,提出了相应的处理方案。     

SRT影响MBR有机污染物去除速率研究

通过考察污泥停留时间(SRT)对膜生物反应器(MBR)和粉末活性炭膜生物反应器(PAc-MBR)降解有机物速率的影响,探讨了污泥活性与胞外聚合物(EPS)的关系.结果表明:MBR和.PAC-MBR中COD降解速率随SRT延长均呈先上升后下降的趋势,分别在39～48d和48d时达到最快,对应速率常数为2.586和3.856,PAC-MBR中COD降解速率普遍高于MBR,说明投加PAC使污泥活性提高,SRT对污泥活性影响较大;MBR和PAC-MBR中胞外聚合物质量浓度与COD降解速率常数K1变化趋势一致,且胞外聚合物质量浓度与K1呈良好正相关关系,说明系统的胞外聚合物质量浓度可以作为衡量污泥活性的指标.     

纳米二氧化钛处理含砷废水的研究

研究了无机纳米材料二氧化钛对含砷废水的处理效果.实验主要从纳米二氧化钛的溶液pH值、不同投加量、实验温度、吸附搅拌时间、静置时间等方面对除砷效率进行了研究,并通过模拟水样和实际水样的对比,分析了纳米二氧化钛处理含砷废水的实际可行性.     

烟气脱汞技术现状简述

火力发电厂是我国最主要的烟气排放源, 期间微量元素汞将以不同的形式排放到大气中,对环境造成很大的危害.汞控制技术一般分为燃烧前脱汞,燃烧中脱汞及燃烧后脱汞.燃烧后脱汞是汞控制技术的主要方式,近些年研究异常活跃,主要表现在2个方面:一方面加强了各种吸收剂的研究,另一方面加强利用现有的脱硫装置脱汞的研究.     

抗生素废水的铁屑微电解预处理研究

研究了采用铁屑微电解法预处理抗生素废水.在进水COD质量浓度为6.2 g/L时,试验结果表明,经微电解处理后的废水,COD和色度的去除率分别达到68.3%和79.3%,BOD5/COD从0.306提高到0.56,废水的可生化性得到显著提高.通过正交试验考察pH、反应时间及铁屑用量对处理效果的影响,并对各因素作了单因素影响试验,确定了最佳工艺条件.     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

多管文丘里烟气除尘脱硫装置

根据引射扩散原理,对文丘里洗涤器进行了理论分析和设计计算,在此基础上研究开发了新型多管文丘里烟气脱硫除尘装置,并用于燃煤锅炉烟气的净化。实际运行表明,该装置的脱硫效率达到90%以上。     

控制游离氨实现单级自养生物脱氮的研究

通过实时调控SBR反应器内的游离氮浓度的控制策略,实现以亚硝化作用和厌氧氨氧化作用协同的单级自养生物脱氮工艺.实验分成亚硝酸菌富集和厌氧氨氧化菌混合接种2个阶段,SBR内的温度始终保持在(31±2)℃.亚硝酸菌富集阶段,pH值稳定在7.8左右,通过调节进水氩氮浓度(56～446 mg·L-1)实现FA浓度的变化,从而实...     

用锅炉冲渣水为水源的湿式除尘器脱硫

通过对大连重工集团五台文丘里—麻石除尘器脱硫率的测定、各关键点pH值的测定、渣池中各金属含量的测定，说明了以锅炉冲渣水为水源进行湿法除尘，既经济又可达到稳定脱硫的目的。