温度对氨法脱硫率影响的实验研究

对使用氨（NH3）脱除烟气中气态污染物的技术进行了分析和总结，认为氨洗涤法洗涤净化烟气是一种很有前景的方法，并就温度对SO2脱除率的影响进行了实验研究。实验研究结果显示，当温度超过54℃时，NH3对SO2仍有很高的脱除率。并根据实验结果建议，在实际氨法脱硫工程中，脱硫过程温度宜控制在60℃以下或在80℃以上。     

区域(城市)水体中主要有机毒物的筛选

本研究发展了区域(或城市)水体中主要有毒化学品的筛选方法。 在城市下游采集大体积水样,用CH_2Cl_2洗脱,再用有机溶剂萃取,用硅胶柱把有机物分成许多馏分,馏分最终变为水溶液。每个馏分中有机物浓度比原水大1000倍。用这种馏分水溶液进行溞的急性毒性试验和Ames试验。只对毒性大的馏分进行色谱/质谱/数据系统的鉴定和定量分析,然后根据各个化合物的急性毒性、降解难易和“三致”物质的资料及原水样中有机物的浓度资料,就可筛选出一个区域(城市)水体中的主要有毒化学品。     

Characteristics and source apportionment of PM2.5 under the dual influence of the Spring Festival and the COVID-19 pandemic in Yuncheng city

Based on the online and membrane sampling data of Yuncheng from January 1st to February 12th, 2020, the formation mechanism of haze under the dual influence of Spring Festival and COVID-19 (Corona Virus Disease) was analyzed. Atmospheric capacity, chemical composition, secondary transformation, source apportionment, backward trajectory, pollution space and enterprise distribution were studied. Low wind speed, high humidity and small atmospheric capacity inhibited the diffusion of air pollutants. Four severe pollution processes occurred during the period, and the pollution degree was the highest around the Spring Festival. In light, medium and heavy pollution periods, the proportion of SNA (SO₄²⁻, NO₃⁻ and NH₄⁺) was 59.6%, 56.0% and 54.9%, respectively, which was the largest components of PM_2.5; the [NO₃⁻]/[SO₄²⁻] ratio was 2.1, 1.5 and 1.7, respectively, indicating that coal source had a great influence; the changes of NOR (nitrogen oxidation ratio, 0.44, 0.45, 0.61) and SOR (sulphur oxidation ratio, 0.40, 0.49, 0.65) indicated the accumulation of secondary aerosols with increasing pollution. The coal combustion, motor vehicle, secondary inorganic sources and industrial sources contributed 36.8%, 26.59%, 11.84% and 8.02% to PM_2.5 masses, respectively. Backward trajectory showed that the influence from the east was greater during the Spring Festival, and the pollutants from the eastern air mass were higher, which would aggravate the pollution. Meteorological and Spring Festival had a great impact on heavy pollution weather. Although some work could not operate due to the impact of the COVID-19 epidemic, the emission of pollutants did not reduce much.     

Dynamic fate modeling of γ-hexachlorocyclohexane in the lower reaches of the Liao River

A QWASI model dependent on temperature is parameterized to describe the long-term fate of persistent organic pollutants (POPs) in the Liao River. The model parameters, namely fugacity capacity, degradation rate, and transfer coefficient, are profoundly affected by temperature. This model is used to simulate the fate of γ-hexachlorocyclohexane (γ-HCH) in the lower reaches of the Liao River from 1998 to 2008. Modeling results show that γ-HCH fugacity capacities in air, water, and sediment increase as temperature decreases, and the transfer and transformation rate coefficients increase as temperature increases. The variations of transfer and transformation parameter D values depend on fugacity capacities, and transfer and transformation coefficients simultaneously. The performance of the model is evaluated by comparing the predicted and observed concentrations in the water and sediment of the Liao River. The predicted values agree well with the observed value in the order of magnitude, in most cases within the factor of 3. It is believed that the model is appropriate for simulating the long term fate of POPs in the Liao River. Translated from Environmental Science, 2006, 27(1): 121–125 [译自: 环境科学]     

战略环境评价及其应用初探

概述了战略环境价的概念、产生原因、研究现状及其工作程序，结合川南矿肥工程项目对它进行了应用初探，提出了计划、规划层次ＳＥＡ的方法和指标，并对我国环评工作提出了建议。     

沉淀物和生物中U,Th和226Ra的联合测定

用放射化学法对U,Th,~(226)Ra等核素进行联合测定,国外已有不少报道,只是所用的分离方法和所测的介质不同而已。我国学者也做过一些这方面的工作。本工作建立了用三正辛胺-二甲苯萃取分离法对沉积物和生物样中U,Th和~(226)Ra的联合测定方法。 二、主要仪器与试剂     

气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

铁炭内电解法处理染料废水的试验

文章采用铁屑一活性炭内电解法作为光合细菌生化处理染料废水的预处理方法，考查了3个主要影响因素（铁炭比、停留时间、初始pH值）。结果表明，最佳的处理条件为：铁炭比为7：3，pH值为5，停留时间为60min。在上述最佳处理条件下，对初始COD为6790mg／L的染料废水处理效率可以达到66．1％，并且废水经预处理后可生化性得到大大提高，有利于后续生化处理的进行。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.