Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.     

Adsorption of chlorpyrifos,penconazole and metalaxyl from aqueous solution by modified clays

Sorption of three pesticides (chlorpyrifos, metalaxyl and penconazole) has been measured on a commercial clay montmorillonite and on the same mineral modified with either of two cationic-surfactant micelles. Both micelle–clay complexes, commercial names Cloisite 20A and Cloisite 30B, showed a good capacity to sorb all three pesticides from water, whereas their sorption on the natural montmorillonite was not described by an isotherm. Modelling sorption on both micelle–clay complexes showed that the Freundlich sorption constant (K _F) was higher for chlorpyrifos on Cloisite 20A (K _F = 7.76) than on Cloisite 30B (K _F = 5.91), whereas the sorption of metalaxyl was stronger on Cloisite 30B (K _F = 1.07) than on Cloisite 20A (K _F = 0.57). Moreover the micelle–clay complex Cloisite 20A also showed a good affinity for penconazole, the maximum quantity adsorbed (q _m) of 6.33 mg g^?1 being 45% more than that on Cloisite 30B. Single-batch adsorption of each pesticide onto both micelle–clay complexes was studied using the Freundlich isotherm for chlorpyrifos and metalaxyl and the Langmuir isotherm for penconazole. The Cloisite 20A micelle–clay complex was predicted to require 23% less adsorbent to treat certain volumes of wastewater containing 30 mg L^?1 chlorpyrifos, 43% more to treat metalaxyl similarly and 57% less to treat penconazole compared with Cloisite 30B.     

改良型AO法组合工艺中有机物的三维荧光分析

采用三维荧光(EEM)光谱技术,对上海竹园第二污水处理厂改良型AO法组合工艺运行过程中的各种溶解性有机物(DOM)进行分析,并对比研究传统好氧活性污泥法曝气池出水和A/O脱氮工艺硝化池出水DOM的EEM光谱的迁移变化特性.结果表明,各种DOM中主要的荧光物质有类蛋白质(荧光峰A和B)及类腐殖质(荧光峰C),经改良型AO法组合工艺处理后,荧光峰的强度降低了14％～60％,同时类蛋白质和腐殖质的结构也发生了变化;腐殖酸溯源表明DOM中的腐殖酸以微生物代谢产生的带有荧光基团的腐殖酸类为主.     

Fenton氧化-序批式膜生物反应器耦合处理干法腈纶废水

采用Fenton氧化-序批式膜生物反应器(SBMBR)组合工艺处理干法腈纶废水。结果表明,在废水初始pH值为3.0,H2O2投加量为90.0 mmol/L,Fe2+投加量为20.0 mmol/L,反应时间为2.0 h的条件下,Fenton氧化预处理对腈纶生产废水的COD去除率达到47.0%以上,COD由1 091 mg/L降至560 mg/L,废水的BOD5/COD由0.32升至0.69,废水的可生化性得到显著提高。Fenton处理出水与丙烯腈废水等比例混合后,采用SBMBR进行生化处理,在水力停留时间为24 h,90 min缺氧/150 min好氧交替运行的条件下,COD、NH4+-N和TN的平均去除率分别为71.7%、97.2%和47.4%,碳源不足是限制TN去除效果的主要影响因素。在无外加碳源的条件下,组合工艺处理后出水COD和NH4+-N浓度分别为117 mg/L和1.7 mg/L,出水水质可以稳定达到国家一级排放标准(GB8978-1996)。     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

页岩气开采中压裂废液处理技术的发展及应用

作为新型的天然气资源,近年来页岩气的开采力度不断增加。文章广泛调研页岩气开采过程中的场地修复、压裂废液处理等方面的环境污染风险,国内外现行压裂废液的处理工艺,系统分析了中和法、絮凝法和氧化法等处理工艺,并结合实际应用效果和企业需求对技术发展方向进行了预测,可为非常规油气资源开发领域提供理论参考。     

污水处理厂AB法工艺改造方案的探讨

针对漳州市东区污水处理厂AB法工艺改造的目标,分析了AB法工艺的局限性,结合该污水处理厂AB法工程的现有设施,从技术上探讨了5种具有脱氮除磷功能的工艺改造方案的可行性,并得到了适合于该污水处理厂AB法工艺改造的方案。     

氨/硫铵法烟气脱硫技术特点及市场前景分析

通过对我国二氧化硫污染现状及控制要求的分析,提出了氨/硫铵法作为一种资源回收型脱硫方法,具有反应速度快、工艺流程简单、吸收剂利用率高、适用范围广及可实现资源回收利用的特点;以工程案例的形式分析了氨/硫铵法的技术经济指标,并对氨/硫铵法的应用前景和市场需求进行了预测。     

海上平台采油工艺设计浅析

文章通过实例,简要阐述了滩海、浅海、深海三种开发模式的特点、主要工艺及其适用性。指出各自存在的问题,并提出相应的建议,为海上勘探开发提供借鉴。     

唐山排污权交易模式浅析

对开展排污权交易的目的、意义、关键因素进行了分析,对唐山排污权交易的工作进程以及交易指标、交易主体、交易程序、指导价格、申购数量、交易范围、优先及限制条件等模式特点进行了阐述,以期为同类型城市开展排污权交易提供参考。