吸附-混凝-紫外光催化氧化法处理医药废水的研究

采用吸附—混凝—紫外光催化氧化法对医药废水进行处理。在废水pH为6.8、聚合氯化铝（PAC）和阳离子聚丙烯酰胺（PAM）的和量分别为400和12mg/L条件下，废水COD、色度去除率分别为37.8%、72.7%；在废水（混凝处理后）pH为3、分3次加入H2O2（投加量为2.5g/L）条件下，紫外光照射6h后，废水COD、色度去除率分别为97.6%、100%。用该法处理后的医药废水，其COD、色度去除率分别为99.1%、100%，出水水质达到医药行业废水二级排放标准。     

冷凝-催化燃烧法处理乙烯厂富含水蒸气的恶臭废气

采用冷凝-催化燃烧法处理乙烯厂富含水蒸气的恶臭废气,冷凝过程能够有效地脱除废气中的水蒸气、联苯和联苯醚,催化燃烧过程能够有效地脱除不凝气中的烃类化合物.催化燃烧反应器内装填Pr、Pd、Ce多组分蜂窝状催化剂,在床层空速为15900～40000h-4、反应器入口气温度为30～350℃的条件下,反应器入口气中总烃的体积分数为64.9×10-6～691.0×10-6时,出口总烃的体积分数可降至5.2×10-6～20.0×10-6,总烃的去除率为90%以上,处理后的气体符合国家排放标准.     

催化燃烧法处理聚对苯二甲酸乙二醇酯生产废气

采用催化燃烧法处理聚对苯二甲酸乙二醇酯生产过程排放的含乙醛、2-甲基-1，3-二氧戊烷、乙二醇的废气，用进口Pt Pd／Al2O3-CeO2球状催化剂作废气催化燃烧的催化剂。在催化燃烧反应器床层空速为20000h^-1、催化剂用量为935mL、反应器入口温度为250℃、进口废气总烃质量浓度为2555～5099mg／m^3的条件下，处理后废气的总烃质量浓度为1～38mg／m^3，远低于120mg/m^3的国家排放标准，且总烃去除率达到98．6％～100％，乙醛质量浓度小于99mg／m^3,低于125mg／m^3的国家排放标准。     

Kinetics study on catalytic wet air oxidation of phenol by several metal oxide catalysts

Four metal oxide catalysts composed of copper (Cu), stannum (Sn), copper-stannum (Cu-Sn) and copper-cerium(Cu-Ce) respectively were prepared by the co-impregnation method, and γ-alumina(γ-Al2O3 ) is selected as support. A first-order kinetics model was established to study the catalytic wet air oxidation of phenol at different temperature when these catalysts were used. The model simulations are good agreement with present experimental data. Results showed that the reaction rate constants can be significantly increased when catalysts were used, and the catalyst of 6% Cu-10% Ce/γ-Al2 O3 showed the best catalytic activity. This is consistent witht he result of catalytic wet air oxidation of phenol and the COD removal can be arrived at 98.2% at temperature 210℃, oxygen partial pressure 3 MPa and reaction time 30 rain. The activation energies of each reaction with different catalysts are nearly equal, which is found to be about 42 kJ/mol and the reaction in this study is proved to be kinetics control.     

Catalytic degradation of methylene blue by Fenton like system: model to the environmental reaction

To develop more efficient chemical methods for the demineralization of organic pollutants from water bodies, which one was also mimic to the nature, a degradation of methylene blue by Fe( Ⅲ ) and H2O2 in the absence of light instead of Fe( Ⅱ ) and H2O2 was studied. Results showed that use of Fe ( Ⅲ ) is more promising than Fe( Ⅱ ). The present study reflects that Fenton reaction is more efficient, in the presence of a small amount of salicylic acid is added which is a one of the priority pollutant.     

纳米Co-B-P非晶态合金的合成及其对PH_3分解的催化作用

用化学还原法合成了纳米Co-B-P非晶态合金,用电感耦合等离子体光谱(ICP)、X射线粉末衍射(XRD)、透射电子显微镜(TEM)和差热分析(DSC)等手段对其进行了物性表征,并用微型催化反应装置考察了其对PH_3分解的催化作用。结果表明,非晶态合金Co-B-P对PH_3的分解具有良好的催化作用。在420℃分解率达到85%, 480℃达97%,500℃达100%,而且温度继续升高至600℃,分解率没有下降趋势,说明催化剂有比较高的热稳定性。     

Degradation of atrazine by catalytic ozonation in the presence of iron scraps: performance,transformation pathway,and acute toxicity

Degradation of atrazine by catalytic ozonation in the presence of iron scraps (ZVI/O₃) was carried out. The key operational parameters (i.e., initial pH, ZVI dosage, and ozone dosage) were optimized by the batch experiments, respectively. This ZVI/O₃ system exhibited much higher degradation efficiency of atrazine than the single ozonation, ZVI, and traditional ZVI/O₂ systems. The result shows that the pseudo-first-order constant (0.0927?min^?1) and TOC removal rate (86.6%) obtained by the ZVI/O₃ process were much higher than those of the three control experiments. In addition, X-ray diffraction (XRD) analysis indicates that slight of γ-FeOOH and Fe₂O₃ were formed on the surface of iron scrap after ZVI/O₃ treatment. These corrosion products exhibit high catalytic ability for ozone decomposition, which could generate more hydroxyl radical (HO^?) to degrade atrazine. Six transformation intermediates were identified by liquid chromatography-mass spectrometry (LC-MS) analysis in ZVI/O₃ system, and the degradation pathway of atrazine was proposed. Toxicity tests based on the inhibition of the luminescence emitted by Photobacterium phosphoreum and Vibrio fischeri indicate the detoxification of atrazine by ZVI/O₃ system. Finally, reused experiments indicate the approving recyclability of iron scraps. Consequently, the ZVI/O₃ system could be as an effective and promising technology for pesticide wastewater treatment.     

VOCs催化燃烧的非贵金属催化剂研究进展

挥发性有机化合物（ VOCs） 是大气污染的主要来源之一,催化燃烧是有效的VOCs处理技术,而非贵金属催化剂是催化燃烧技术研究的热点。综述了多种结构形式的非贵金属催化剂的种类、活性组分及其催化性能的研究进展,探讨了水含量、杂质气体等因素对催化剂活性的影响。指出：将催化剂的制备和机理研究与实际应用中的工艺计算和设计相结合,开发用于VOCs催化燃烧的高活性、高稳定性、价格低廉的催化材料和工艺是今后的研究方向。     

活性炭复合材料负载催化剂催化臭氧氧化处理石化废水

采用催化臭氧氧化深度处理某石化厂炼油废水,制备了活性炭复合材料负载催化剂(Fe_2O_3/ACNT),与几种常见负载催化剂进行了物性和COD去除效果的对比,并对Fe_2O_3/ACNT的催化效果和稳定性进行了详细分析。结果表明:催化剂的催化臭氧氧化活性由高到低的顺序为Fe_2O_3/ACNTFe_2O_3/活性炭Fe_2O_3/Al2O3Fe_2O_3/陶粒;Fe_2O_3/ACNT催化剂具有较高的比表面积、孔体积、强度和吸水率,使COD去除率由单独臭氧氧化时的约20%提高到66.8%。在催化剂填充量200 m L、废水pH 7.6、臭氧投加量200 mg/L、体积空速1 h~(-1)的条件下运行30d,COD去除率平均达65.1%,出水COD均值为40.8 mg/L,最高值为44.3 mg/L,满足外排水COD小于50 mg/L的指标。催化剂稳定性良好,运行30 d活性未见明显降低,具有在环保领域应用的前景。     

泥磷液相催化氧化氮氧化物

采用磷化工行业的固体废物泥磷液相催化氧化氮氧化物。实验结果表明,该方法是可行且有效的。随着温度的升高,泥磷吸收液的脱硝效率提高,当温度达到泥磷熔点时脱硝效率最佳。泥磷吸收液的脱硝效率随固液比的增大而有所下降,而随着NO体积分数和气体流量的增大,泥磷吸收液的脱硝效率呈先升后降的趋势。各因素对脱硝率的影响大小顺序为：气体流量>反应温度>固液比>NO体积分数。在反应温度60 ℃、固液比1∶4、NO体积分数0.03%、气体流量0.3 L/min的最佳工艺条件下,反应160 min的平均脱硝率可达97.38%。