OMS-2负载Pt催化剂的制备及其催化氧化性能研究

采用前掺杂法、沉积-沉淀法和浸渍法制备了氧化锰八面体分子筛(OMS-2)负载Pt催化剂(Pt/OMS-2),对所制催化剂进行了结构和织构表征。并研究了不同制备方法和沉积-沉淀法中不同制备(Pt负载量和溶液的pH值)对Pt/OMS-2催化氧化CO性能的影响。结果表明,沉积-沉淀法制备的Pt/OMS-2-DP催化剂活性最好(T100=100℃)。这与Pt/OMS-2-DP催化剂中Pt颗粒大小及OMS-2载体与Pt之间存在强相互作用有关。Pt负载量明显影响Pt/OMS-2-DP催化剂的催化活性,3Pt/OMS-2-DP催化剂(Pt=3.0 wt%)催化活性最高,这是由于适当Pt负载量,Pt颗粒较小,并与载体OMS-2的相互作用较强,能较好地活化OMS-2晶格氧。pH值对Pt/OMS-2-DP催化剂催化性能影响较大,这与OMS-2的等电点和Pt在不同溶液中存在不同Pt配位体形式有关。     

非均相类Fenton试剂的制备及其在焦化废水处理中的应用研究

利用浸渍法,将Fe3＋负载在经酸碱改性后的粉状活性炭上,当浸渍液浓度为2．5％,固化温度为270℃时,制成的催化剂催化活性较高。用自制的非均相类benton试剂降解焦化废水,通过正交试验和极差分析得出,影响因素的主次顺序为催化剂用量〉初始pH值〉反应时间〉H：0：投加量。结果表明,在100ml水样中。室温条件下,初始pH值为4．0,催化剂使用量为1．5g,H20：投加量为5ml（分两次投加）,反应时间为90min时,COD去除率可达99％。采用混凝＋化学沉淀＋非均相类Fenton试剂法处理焦化废水,各主要出水水质指标为：色度lO倍;COD浓度38．5mg／L;氨氮浓度8．4mg／L,达到国家一级排放标准。     

镉胁迫对虾夷扇贝抗氧化防御系统的影响

实验研究了虾夷扇贝在96 h的急性毒性效应,以及不同浓度Cd2+(0,0.005,0.025,0.050,0.150和0.300 mg/L)对虾夷扇贝内脏团超氧化物岐化酶(SOD)、过氧化氢酶(CAT)和谷胱甘肽-过氧化物酶(GSH-PX)活力的影响,以探讨其用于污染暴露的生物标记的可行性。结果表明:虾夷扇贝96 h的LC50为1.73 mg/L;其95%的置信区间是1.58～1.90 mg/L;安全浓度为0.0173 mg/L。酶活力:0.025 mg/L及以上的各实验组SOD活力先上升后下降,在第3 d时达到峰值,与对照组呈显著差异(P<0.05);处理第6 d,各浓度组SOD活力有所下降,到第9 d时受到抑制;CAT活力在处理0.5 d时,0.025mg/L0、.150 mg/L和0.300 mg/L三个浓度组均受到显著诱导(P<0.05),处理第6 d时,各实验组酶活力开始受到抑制。两种酶对实验设计的Cd2+浓度反应敏感,呈现出"诱导-抑制"规律,对海洋Cd2+早期污染具有指示作用。GSH-PX对Cd2+污染没有SOD和CAT那样敏感,GSH-PX的各个实验组与对照组相比差异均不显著,因而它作为对海洋Cd2+早期污染指示物的意义不大。     

Body mass estimations for <Emphasis Type="Italic">Plateosaurus engelhardti</Emphasis> using laser scanning and 3D reconstruction methods

Both body mass and surface area are factors determining the essence of any living organism. This should also hold true for an extinct organism such as a dinosaur. The present report discusses the use of a new 3D laser scanner method to establish body masses and surface areas of an Asian elephant (Zoological Museum of Copenhagen, Denmark) and of Plateosaurus engelhardti, a prosauropod from the Upper Triassic, exhibited at the Paleontological Museum in Tübingen (Germany). This method was used to study the effect that slight changes in body shape had on body mass for P. engelhardti. It was established that body volumes varied between 0.79 m³ (slim version) and 1.14 m³ (robust version), resulting in a presumable body mass of 630 and 912 kg, respectively. The total body surface areas ranged between 8.8 and 10.2 m², of which, in both reconstructions of P. engelhardti, ∼33% account for the thorax area alone. The main difference between the two models is in the tail and hind limb reconstruction. The tail of the slim version has a surface area of 1.98 m², whereas that of the robust version has a surface area of 2.73 m². The body volumes calculated for the slim version were as follows: head 0.006 m³, neck 0.016 m³, fore limbs 0.020 m³, hind limbs 0.08 m³, thoracic cavity 0.533 m³, and tail 0.136 m³. For the robust model, the following volumes were established: 0.01 m³ head, neck 0.026 m³, fore limbs 0.025 m³, hind limbs 0.18 m³, thoracic cavity 0.616 m³, and finally, tail 0.28 m³. Based on these body volumes, scaling equations were used to assess the size that the organs of this extinct dinosaur have.     

ZnOOH/O3催化臭氧化体系去除水中痕量对氯硝基苯

以实验室制备的羟基化锌（ZnOOH）为催化剂,考察了其催化臭氧化去除水中痕量对氯硝基苯（ppCNB能力.本实验条件下,蒸馏水中反应20　min时,催化臭氧化比单独臭氧化对pCNB的去除率提高了51 .3个百分点;催化过程遵循自由基反应机理,催化剂表面结合的羟基基团有利于催化反应;pCNB的去除效果随催化剂投量的增加而更佳,催化剂重复使用3次后,催化效果基本没有变化,水中的重碳酸盐以及缓冲溶液中的磷酸盐可以明显降低催化活性,中性条件下,催化作用最佳.     

催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

长期暴露于全氟十三酸的青鳉鱼体内分布和生物富集

研究了将青鳉鱼长期暴露于不同浓度的全氟羧酸类物质全氟十三酸(PFTriDA)后的器官分布和富集系数.结果显示, PFTriDA最高富集在性腺;其次是卵、肝脏;浓度最低的部分是残体.除了性腺之外,该器官分布与野生中华鲟的一致.在相同暴露浓度下,雄鱼体内各器官的PFTriDA的含量高于雌鱼,机理模型计算进一步表明高母子传递系数是造成雌雄差异的可能原因.随着PFTriDA暴露浓度的升高,鱼体内同一器官的生物富集系数(BCF)呈现下降趋势.     

Complete catalytic oxidation of o-xylene over Ce02 nanocubes

The activities of CeO2 nanocubes calcined at different temperatures were tested for catalytic oxidation of o-xylene. Using CeO2 nanocubes as catalysts, complete catalytic oxidation of o-xylene was achieved below 210℃. The CeO2 nanomaterials were characterized by means of BET, X-ray diffraction (XRD), transmission electron microscopy (TEM), and high-resolution transmission electron microscopy (HRTEM). From the TEM images, all Ce02 nanocubes displayed cubic morphology irrespective of calcination temperature. The HRTEM images revealed that these nanocubes were enclosed by reactive {001}planes, which may contribute to the intrinsically catalytic property of o-xylene oxidation. The higher activity of Ce02 nanocubes calcined at 550℃ than those calcined at above 550℃ was attributed to their smaller crystallite size and larger surface area. The influences of reaction conditions were also studied, which found that a higher reaction temperature was necessary for complete catalytic oxidation of o-xylene at higher weight hourly space velocity (WHSV) and o-xylene concentration.