Particulate air pollution in Lanzhou China

Concentrations of total suspended particles (TSP) and PM(10) in Lanzhou China have been kept high for the past two decades. Data collected during the intensive observational period from October 1999 to April 2001 show high TSP and PM(10) concentrations. Starting from November, the PM(10) pollution intensifies, and reaches mid to high alert level of air pollution, continues until April next year, and is at low alert level in the summer. In the winter and spring, the TSP concentration is 2-10 times higher than the third-level criterion of air quality (severe pollution). Effects of intrinsic factors (sources of pollution) and remote preconditions (propagation of dust storms) for severe PM(10) and TSP pollution in Lanzhou are analyzed.     

Buses retrofitting with diesel particle filters: Real-world fuel economy and roadworthiness test considerations

Retrofitting older vehicles with diesel particulate filter(DPF) is a cost-effective measure to quickly and efficiently reduce particulate matter emissions. This study experimentally analyzes real-world performance of buses retrofitted with CRT DPFs. 18 in-use Euro III technology urban and intercity buses were investigated for a period of 12 months. The influence of the DPF and of the vehicle natural aging on buses fuel economy are analyzed and discussed. While the effect of natural deterioration is about 1.2%–1.3%, DPF contribution to fuel economy penalty is found to be 0.6% to 1.8%, depending on the bus type. DPF filtration efficiency is analyzed throughout the study and found to be in average 96% in the size range of 23–560 nm. Four different load and non-load engine operating modes are investigated on their appropriateness for roadworthiness tests. High idle is found to be the most suitable regime for PN diagnostics considering particle number filtration efficiency.     

Determination of the effective density and fractal dimension of PM emissions from an aircraft auxiliary power unit

Gas turbine particulate matter (PM) emissions contribute to air quality degradation and are dangerous to both human health and the environment. Currently, PM mass concentrations determined from gravimetric measurements are the default parameter for gas turbine emissions compliance with PM regulations. The measurement of particle size however, is of significant interest due to its specific effects on health and climate science. The mass concentration can be determined from the number-size distribution measurement but requires the experimental evaluation of effective density of a number of particles to establish the power-law relationship. In this study, the effective density of PM emissions from an aircraft Auxiliary Power Unit (APU) with petroleum diesel, conventional aviation fuel (Jet A-1) and a multicomponent surrogate fuel (Banner NP 1014) as combusting fuels have been compared. An experimental configuration consisting of a Differential Mobility Analyzer, a Centrifugal Particle Mass Analyzer and a Condensation Particle Counter (DMA-CPMA-CPC) was deployed for this purpose. Overall, a decrease in the effective density (220–1900 km? 3) with an increase in the particle size was observed and found to depend on the engine operating condition and the type of fuel undergoing combustion. There was a change in the trend of the effective densities between the PM emissions generated from the fuels burnt and the engine operating conditions with increasing particle size.     

Sources and processes affecting concentrations of PM10 and PM2.5 particulate matter in Birmingham (U.K.)

Hourly average concentrations of PM₁₀ and PM_2.5 have been measured simultaneously at a site within Birmingham U.K. between October 1994 and October 1995. Comparison of PM₁₀ and NO_x data with two other sites in the same city shows comparable summer and winter mean concentrations and highly significant inter-site correlations for both hourly and daily mean data. Over a four-month period samples were also collected for chemical analysis of sulphate, nitrate, chloride, ammonium and elemental and organic carbon. Analysis of the data indicates a marked difference between summer and winter periods. In the winter months PM_2.5 comprises about 80% of PM₁₀ and is strongly correlated with NO_x indicating the importance of road traffic as a source. In the summer months, coarse particles (PM₁₀−PM_2.5) account for almost 50% of PM₁₀ and the influence of resuspended surface dusts and soils and of secondary particulate matter is evident. The chemical analysis data are also consistent with three sources dominating the PM₁₀ composition: vehicle exhaust emissions, secondary ammonium salts and resuspended surface dusts. Coarse particles from resuspension showed a positive dependence on windspeed, whilst elemental carbon derived from road traffic exhibited a negative dependence.     

Phosphate adsorption performance of a novel filter substrate made from drinking water treatment residuals

Phosphate is one of the most predominant pollutants in natural waters. Laboratory experiments were conducted to investigate the phosphate adsorption performance of a(NFS) made from drinking water treatment residuals. The adsorption of phosphate on the NFS fitted well with the Freundlich isotherm and pseudo second-order kinetic models. At p H 7.0, the maximum adsorption capacity of 1.03 mg/g was achieved at 15°C corresponding to the wastewater temperature in cold months, and increased notably to 1.31 mg/g at 35°C.Under both acidic conditions(part of the adsorption sites was consumed) and basic conditions(negative charges formed on the surface of NFS, which led to a static repulsion of PO43-and HPO42-), the adsorption of phosphate was slightly inhibited. Further study showed that part of the adsorption sites could be recovered by 0.25 mol/L Na OH. The activation energy was calculated to be above 8.0 k J/mol, indicating that the adsorption of phosphate on NFS was probably a chemical process. Considering the strong phosphate adsorption capacity and recoverability, NFS showed great promise on enhancing phosphate removal from the secondary treated wastewater in the filtration process.     

大气污染物及AQI时空特征分析——以山西省2015年上半年为例

根据2015年上半年山西省11个地级市PM 2.5、PM 10、NO 2、SO2、CO、O 3的日污染浓度监测数据及AQI值,分析其污染特征。结果表明:全省11市PM 2.5、PM 10超标率较高;NO 2、SO 2、CO、O 3超标率则较低;全省PM2.5/PM1 0的比值范围在0.367 7~0.718 9,且PM 2.5和PM 10之间存在较显著的线性关系;PM 2.5、PM 10、NO 2、SO 2、CO以及AQI监测值在1~6月份逐渐递减,O3则呈总体上升趋势;AQI达标天数比例范围在61.88%~85.08%,平均比例为71.42%,平均超标天数比例为38.58%,其中重度及以上污染天数比例为1.50%。     

Experimental investigation on the performance and emission characteristics of a diesel engine by varying the injection pressure and injection timing using mixed biodiesel

Biodiesel is a promising fuel for compression ignition engines instead of diesel fuel. Due to the depletion of diesel fuel, an alternative fuel can be used in an engine. The experiments were conducted on a four-stroke, single cylinder CI engine. In this present investigation, an attempt has been made to study the influence of injection pressure (IP) and injection timing (IT) on the performance and emission characteristics of diesel engines by using mixed biodiesel (Thevetia peruviana, Jatropha, Pongamia, and Azadirachta indica). The injection pressure is varied from 200 to 230 bar and the injection timing is varied from 23 to 29° bTDC at an increment of 10 bar and 2° bTDC, respectively, and the results were compared with diesel. From this study, the results showed that the brake thermal efficiency (BTE) was increased by 2.4% with an increase in injection pressure and 1.5% with an increase in the injection timing for the maximum load, but lesser than diesel. Furthermore, a reduction of 5.08% of brake specific fuel consumption (BSFC) has been noticed for the rise in IP and IT with loads but higher than diesel. The reduction was 34.17%, 53.85%, and 29.7% and 29.17%, 53.85%, and 21.95% of hydrocarbons (HC), carbon monoxide (CO), and smoke emissions, respectively, at 230 bar injection pressure and at 27° bTDC injection timing. Also, a significant increase in nitrogen oxides (NO_x) and carbon dioxide (CO₂) emissions at the maximum load was observed by increasing the injection pressure and injection timing.     

The effect of low emission zones on air pollution and infant health

This paper investigates the effect of low emission zones on air quality and birth outcomes in Germany. The staggered introduction of the policy measure creates a credible natural experiment and a natural control group for births and air pollution measurements in cities that enact low emission zones. I show that the introduction of the most restrictive type of low emission zone decreases average levels of fine particulate matter by about 4 percent and by up to 8 percent at a city's highest-polluting monitor. Low emission zones also reduce the number of days per year on which legal pollution limits are exceeded by three. However, these reductions are too small to translate into substantial improvements in infant health. My results are not driven by changes in maternal or city specific characteristics, and are robust to variations in specification and to the choice of control group.     

Exponential Collapse of Benthic Depurative Capacity in A Eutrophic Tropical Marine Ecosystem: A Threshold Response to Organic Nitrogen Loading

Microbial decomposition of particulate organic matter in sediments can substantially modulate eutrophication of nearshore marine environments. Flux budgets for nitrogen compounds and quantification of rates of microbial transformation can provide important information on the process of eutrophication. This survey documents sediment nitrogen budgets for a eutrophic nearshore marine environment at La Parguera on southwest coast of Puerto Rico, including consideration of the organic fraction in addition to microbial transformations.

Sediments of the inshore channel at La Parguera denote the input of heavy organic loads with low redox potentials and high ammonium contents. Benthic fluxes of dissolved organic nitrogen are below those recorded for ammonium. These observations suggest that nearshore tropical sediments subject to heavy nitrogen loads act as a sink for organic nitrogen and that ammonification is a key process in the release of nitrogen from sediments to the water column. Nitrification and denitrification rates are low overall and inversely related to the redox potential. Depuration of excess nitrogen through denitrification is ineffective in these sediments. in contrast to more robust temperate environments, our work demonstrates that tropical marine systems are particularly susceptible to eutrophication given their limited capacity for depuration of excess nitrogen.     

Ultra-deep Desulfurization of Liquid Hydrocarbon Fuels: Chemistry and Process

Abstract

Recently, ultra-deep desulfurization of liquid hydrocarbon fuels is becoming very important worldwide not only because of the heightened interest for cleaner air and thus increasingly stringent environmental regulations for fuel sulfur content, but also because of the great need for making ultra-low-sulfur fuels used in hydrocarbon fuel process for fuel cell applications. This article is a selective review on chemistry and process concerning the ultra-deep desulfurization of liquid hydrocarbon fuels. The principles and problems for the existing hydrodesulfurization processes and the challenges, concepts, advantages, and disadvantages of various new approaches are discussed, including (1) sulfur compounds in liquid hydrocarbon fuels; (2) Reactivity and mechanistic aspect of various sulfur compounds; (3) Challenges in ultra-deep desulfurization processes; (4) Approaches to ultra-deep desulfurization process.