Biodegradability: An assessment of commercial polymers according to the Canadian method for anaerobic conditions

The degradation of several biodegradable polymers was measured as a result of exposure to an anaerobic medium. The polymers investigated included materials based upon polylactic acid, polylactone, and poly(hydroxy butyrate/valerate) as well as those incorporating starch-based materials. The degradation was monitored by methane and carbon dioxide evolution. In addition, the physical and chemical changes were noted as a result of exposure. These measurements included changes in mass, dimension, and molecular weight. FTIR, UV-vis, proton, and¹³C NMR spectra were also recorded prior to and after exposure. The results clearly indicated that several biological and chemical degradation processes were occurring with the biodegradable polymers studied.Paper presented at the Bio/Environmentally Degradable Polymer Society—Second National Meeting, August 19–21, 1993, Chicago, Illinois.Issued as NRCC No. 37549.     

高浓度印染废水处理工程工艺条件与实例分析

研究以三相生物流化床作为工程化反应器处理印染废水的工程工艺条件及操作特性，分别测定流化床内的气相含率，兴体循环速度及体积氧传质系数。     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.     

MBBR处理低浓度污水的工程应用

用 2座体积 12 0m3的移动床生物膜反应器处理抚顺乙烯有限公司厂区的低浓度 (CODCr6 0～ 80mg L)生活污水 ,停留时间 2 4h ,出水通过高效纤维球过滤罐 ,CODCr降至 2 0mg L ,BOD5降至 5mg L ,SS降至 5mg L ,氨氮降至 1mg L ,达到了循环冷却水的回用标准。进水浓度过低 ,对MBBR挂膜不利 ,工程中采用外加营养物质的措施后 ,3d内反应器成功挂膜启动。     

厌氧处理原理及其在低浓度有机废水处理中的应用现状

介绍了厌氧处理原理，并对厌氧处理低浓度废水的最新进展进行了较全面的综速，高效厌氧反应器及组合工艺为这一发展提供了可能。高效厌氧反应器中以膨胀颗粒污泥床（ECSB）反应器为首选。其结构及远行特性决定了它在处理低浓度虚水方面具有潜在的优势，但中国EC,SB的应用仅处于研究阶段，尚未有生产规模的EGSB；组合工艺对低浓度废水中污染物去除率极高，出水中COD、NH3-N、TP和SS浓度均可达到较高的排放标准，对生活污水、稀释后的工业有机废水等低浓度有机废水处理具有广阔的前景。     

反静电场处理厌氧污泥的影响因素分析

在电场和电解副效应的共同作用下，选定0．5mA、1．0mA、1．5mA和1．95mA四种电流强度作为不同的运行条件，处理时间24h，分别测定反应开始和结束时厌氧污泥上清液COD、NH4^＋-N和VSS，其变化率随电流强度呈抛物线型变化。用反静电处理厌氧污泥时，电场对污泥参数的影响存在着最佳的工作电流强度，在本试验条件下，反静电处理厌氧污泥的最佳工作电流强度为1．5mA。反静电场可提高微生物的活性，使COD与NH4^＋-N得到一定程度的降解，同时，污泥的性质影响反静电场处理污泥的效果。     

己二胺有机废液在流化床中焚烧的实验研究

在实验室规模的热态流化床试验台上，进行了含5％己二胺有机废液的焚烧 实验研究，在700－900℃范围内，研究温度及空气过剩系数对NOx沿床高的变化规律，以及它们对NOx排放浓度的影响。实验结果表明，沿高度方向上NOx浓度 逐渐降低，并且存在NO2浓度大于NO浓度这一有趣现象，在900℃下氧量增加有利于密相区NO、NO2浓度的降低，说明在 有氧条件下NH2促进NOx的还原，在不同空气 过剩系数下和然相区出口NOx几乎为零 ，表明900℃是己二胺有机废液焚烧 的合适温度。     

水解酸化─厌氧─好氧─混凝─吸附工艺处理洁霉素生产丁提高浓度有机废水

采用水解酸化厌氧好氧混凝吸附工艺处理洁霉素生产丁提高浓度有机废水，工程实践表明，ＣＯＤＣｒ和ＢＯＤ５去除率在９９％以上，所排废水各项指标达到国家排放标准。     

A novel technology for quick acclimation of an anaerobic microbial consortia used for biodegrading teraphthalic acid (TA)

ＩｎｔｒｏｄｕｃｔｉｏｎＴｅｒａｐｈｔｈａｌｉｃａｃｉｄ (ＴＡ)ｉｓｏｎｅｏｆｔｈｅｐｅｔｒｏｃｈｅｍｉｃａｌｓｗｉｄｅｌｙｕｓｅｄｉｎｔｈｅｓｙｎｔｈｅｓｉｓｏｆｐｏｌｙｅｓｔｅｒｆｉｂｅｒ,ｖｉｄｅｏｆｉｌｍｓａｎｄｏｔｈｅｒａｐｐｌｉｃａｔｉｏｎｓ .Ｓｉｎｃｅｂｉｓ (2 ｅｔｈｙｌｈｅｘｙｌ)ｐｈｔｈａｌａｔｅ ,ｄｉｅｔｈｙｌｐｈｔｈａｌａｔｅａｎｄｄｉｍｅｔｈｙｌｐｈｔｈａｌａｔｅｈａｖｅｂｅｅｎｃｌａｓｓｉｆｉｅｄａｓｐｒｉｏｒｉｔｙｈａｚａｒｄｏｕｓｃｏｍｐｏｕｎｄｓｂｙＥＰＡｏｆｔｈｅ…     

厌氧折流板反应器处理有毒废水及其污泥特性的研究

在１６．２Ｌ厌氧折流板反应器中，处理以葡萄糖为共基质的含五氯酚钠（ＰＣＰ－Ｎａ）有毒废水，进水ＣＯＤ为１１００－１２００ｍｇ／Ｌ，ＨＲＴ为１d。结果表明，ＡＢＲ 对有毒物负荷变化的适应能力强，当进水ＰＣＰ－Ｎa小于８ｍｇ／Ｌ时，出水ＣＯＤ在８０ｍｇ／Ｌ以下，ＰＣＰ－Ｎa在０．２ｍｇ／Ｌ以下，运行稳定。在有毒物低于抑制浓度 下反应器内参形成颗粒污泥，颗粒污泥表面为发酵产酸菌，内部为产甲烷菌，自身形成良好