环境因子对水蚯蚓呼吸速率的影响研究

水蚯蚓能通过摄食剩余污泥而使污泥减量.因此,本文以颤蚓科蠕虫 (Tubificidae)为研究对象,考察环境因子(水质、水蚯蚓投加量、温度、pH、溶解氧)对水蚯蚓呼吸速率的影响,以探明水蚯蚓生长和新陈代谢的最佳条件,揭示环境因子影响水蚯蚓污泥减量的机理.结果表明,水蚯蚓在"水蚯蚓-微生物"共生系统污泥减量装置出水中的呼吸速率最大,为81.72 mg·g^-1·h^-1·L^-1(以单位体积内每g干重水蚯蚓每小时消耗的O₂质量计(mg)),在蒸馏水中的呼吸速率最小,仅为18.31 mg·g^-1·h^-1·L^-1;在容积为1 L的系统中,水蚯蚓呼吸速率随着投加量增加而逐渐减小,当水蚯蚓投加量为0.25 g (以湿重计)时,呼吸速率最大,为81.72 mg·g^-1·h^-1·L^-1;在8~22℃范围内,水蚯蚓呼吸速率随温度升高而增大,在22~30℃范围内趋势则相反;当pH=8.00±0.05时呼吸速率最大,比其他pH值条件下测得的呼吸速率高1倍多;溶解氧在3.5~4.5 mg·L^-1范围内,水蚯蚓的呼吸速率较高,在此溶解氧范围之外时,水蚯蚓呼吸速率均较低. 该研究结果可为污泥减量中水蚯蚓的培养和应用提供可靠的理论依据,从内在层次上揭示了环境因子影响水蚯蚓生长及代谢,进而影响污泥减量的本质原因.     

汽油在西北黄土上吸附特性的研究

通过动力学和热力学吸附实验,研究了汽油在西北地区黄土上的吸附行为,同时研究了提取的天然腐植酸对汽油在黄土上吸附行为的影响.结果表明,汽油在黄土上的吸附在6h内达到平衡.无论是否加入腐植酸,汽油在黄土上的吸附动力学过程均符合Elovich方程,其热力学吸附符合Freundlich方程.腐植酸的存在使汽油在黄土上的吸附能力减小.反应温度从25℃升高到45 C,汽油在土壤上的饱和吸附量从6.300mg·g-1减小到1.365 mg·g-1,表明汽油在黄土上的吸附属于放热反应.溶液pH和土壤粒径的增大,均不利于汽油在黄土上的吸附,溶液pH和土壤粒径越大,其在黄土上的吸附量越小.另外,在室温下对吸附了汽油的土壤样品和纯汽油挥发行为的研究表明,吸附了汽油的土壤样品的汽油挥发比纯汽油慢,其挥发率与时间成对数关系.     

Quantitative analysis of microbial biomass yield in aerobic bioreactor

We have studied the integrated model of reaction rate equations with thermal energy balance in aerobic bioreactor for food waste decomposition and showed that the integrated model has the capability both of monitoring microbial activity in real time and of analyzing biodegradation kinetics and thermal-hydrodynamic properties. On the other hand, concerning microbial metabolism, it was known that balancing catabolic reactions with anabolic reactions in terms of energy and electron flow provides stoichiometric metabolic reactions and enables the estimation of microbial biomass yield (stoichiometric reaction model). We have studied a method for estimating real-time microbial biomass yield in the bioreactor during food waste decomposition by combining the integrated model with the stoichiometric reaction model. As a result, it was found that the time course of microbial biomass yield in the bioreactor during decomposition can be evaluated using the operational data of the bioreactor (weight of input food waste and bed temperature) by the combined model. The combined model can be applied to manage a food waste decomposition not only for controlling system operation to keep microbial activity stable, but also for producing value–added products such as compost on optimum condition.     

Degradation of monofluorophenols in water irradiated with gaseous plasma

Decomposition of aqueous monofluorophenols (MFPs) was investigated by contact glow discharge electrolysis (CGDE). During CGDE, both MFPs and the corresponding total organic carbon (TOC) in water were consumed smoothly, suggesting that carbon atoms of benzene nucleus could be eventually mineralized to inorganic carbon (IC). And all the fluorine atoms in the MFPs were equally converted to fluoride ions. Based on the primary intermediates from each starting materials, it showed that aromatic hydroxylation preferentially occurred at the para- or ortho- position to the phenolic OH group of each MFPs. The disappearance of both MFPs and TOC followed the first-order rate law. The apparent rate constants for the decay of MFPs were independent from the pK_a values of MFPs.     

日本交通部门碳排放与低碳交通相关因素研究

本文就日本向低碳社会体系转型的过程中,交通部门碳排放现状、都市交通体系构成、实施对策等方面进行了分析,探讨其交通运输领域低碳交通的相关因素及发展模式,为中国低碳交通体系的构建提供参考。     

亚微米颗粒在Sierpinski海绵模型中热泳沉积研究

亚微米颗粒由于其特殊的粒径尺度,具有很多不同于与传统细颗粒的物理和化学性质,同时极易吸入人体,对人体造成很大危害。谢尔宾斯基海绵模型作为一种理想化的结构模型,具有内比表面积大、多通道等特点。通过建立可工程应用的谢尔宾斯基海绵模型通道,并结合热泳沉积相关数学模型开展计算,可以发现:随着谢尔宾斯基海绵阶数的上升,内部通道的增加是引起亚微米颗粒热泳沉积率上升的主要因素;在海绵通道中运动的亚微米颗粒较之其他粒径的颗粒,更容易受到热泳沉积的影响;同时温差对其热泳沉积影响较为剧烈,呈现线性变化。建立具有工程特征的谢尔宾斯基海绵模型通道,可为研究亚微米颗粒沉积及脱除开辟一条新途径。     

ABR反应器中COD/SO_4~(2-)值和硫酸盐负荷对SO_4~(2-)去除影响

利用厌氧折流板反应器,分别考察了反应器启动,及不同COD/SO42-比值和硫酸盐负荷对模拟废水中SO42-去除的影响。实验在(32±0.1)℃,pH为6.0⁶.5的条件下连续运行。结果表明:ABR经过约90 d的启动驯化阶段后,进水硫酸盐及COD浓度分别为1 500 mg/L和3 000 mg/L,水力停留时间为12 h条件下,硫酸盐去除率达到了92%。固定COD/SO42-比值为2.5时,随着进水SO42-浓度的增加(1 5006.5的条件下连续运行。结果表明:ABR经过约90 d的启动驯化阶段后,进水硫酸盐及COD浓度分别为1 500 mg/L和3 000 mg/L,水力停留时间为12 h条件下,硫酸盐去除率达到了92%。固定COD/SO42-比值为2.5时,随着进水SO42-浓度的增加(1 500³ 500 mg/L),SO42-去除率逐渐下降,最低为60%,相反SO42-去除速率随着硫酸盐浓度的增加而增加,最大为7.98 kg(/m3.d);维持恒定的硫酸盐浓度(1 500 mg/L),逐渐缩短水力停留时间以提高反应器中硫酸盐负荷,SO42-去除率呈现先上升后下降的复杂变化趋势,当水力停留时间为6 h时,SO42-去除率达到最大;随着COD/SO42-比值的提高,硫酸盐去除能力增强,且反应体系对硫酸盐负荷的耐受能力也逐渐增强。     

Experimental investigation,intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix composite

Dry wire electrical discharge machining (WEDM) is an environmentally friendly modification of the oil WEDM process in which liquid dielectric is replaced by a gaseous medium. In the present work, parametric analysis has been fulfilled while dry WEDM of Al–SiC metal matrix composite. Experiments were designed and conducted based on L₂₇ Taguchi's orthogonal array to study the effect of pulse on time, pulse off time, gap voltage, discharge current, wire tension and wire feed on cutting velocity (CV) and surface roughness (SR). Firstly, a series of exploratory experiments has been conducted to identify appropriate gas and wire material based on the values of cutting velocity. After selection of best gas and best wire, they were used for later stage of experiments. Analysis of variances (ANOVA) has been performed to identify significant factors. In order to correlate relationship between process inputs and responses, an adaptive neuro-fuzzy inference system (ANFIS) has been employed to predict the process characteristics based on experimental observation. At the end, an artificial bee colony (ABC) algorithm has been associated with ANFIS models to maximize CV and minimize SR, simultaneously. Then the optimal solutions that obtained through ANFIS-ABC technique have been compared with numbers of confirmatory experiments. Results indicated that oxygen gas and brass wire guarantee superior cutting velocity. Also, according to ANOVA, pulse on time and discharge current were found to have significant effect on CV and SR. In modeling of CV and SR by ANFIS, it was resulted that the proposed method has superiority in prediction of them in the ranges of factors beyond the training condition. Also, association of ANFIS with ABC can find the optimal combination of process parameters accurately according to the confirmatory experiments.     

模拟氮沉降和CO2浓度增加对三江平原小叶章群落土壤总有机碳和氮素含量的影响

利用开顶气室(Open-Top Chamber,OTC),设置当前大气CO2浓度(370μmol.mol-1)、中等CO2浓度(550μmol.mol-1)和高CO2浓度(700μmol.mol-1)3个CO2浓度水平和不施氮(N1,0g N.m-2.a-1)、常氮(N2,5g N.m-2.a-1)、高氮(N3,10g N.m-2.a-1)3个氮素水平。研究了不同N沉降水平下,大气CO2浓度升高对以三江平原小叶章群落土壤有机碳和氮素含量的影响。结果表明:CO2浓度升高结合氮沉降连续运行两个生长季后,湿地土壤总有机碳含量没有显著变化,说明较短时间内大气CO2浓度升高和氮沉降不会使三江平原土壤有机碳含量产生变化。氮沉降引起各个土层的土壤全氮、铵态氮和硝态氮的含量增加,施氮水平越高土壤氮增加越多,但是全氮增加量不明显,铵态氮随施氮量的增加呈现极显著差异水平(P<0.01)。0～10cm,10～20cm土层土壤全氮、铵态氮的含量随着CO2浓度升高呈现出先增大后减小的趋势。土壤硝态氮含量在10～20cm土层含量变化与土壤全氮、铵态氮的变化趋势相同。说明大气CO2浓度一定程度的增加可以增加土壤的氮素含量,但是过量的大气CO2浓度反而会使得土壤氮素含量减少。     

城市排水系统沉积物特性研究

重点阐述了沉积物的来源和组成,沉积物的颗粒粒径、有机物含量(VSS/SS)、颗粒粘性和颗粒密度等物化性质,以及附着于沉积物上的金属污染物的相关特征。其粒度分布范围是D10为1.89～223.21μm,D50为12.38～437.30μm,D90为39.06～1 572.52μm;VSS/SS的范围是1%～38%;密度范围是1.80～2.47 g/cm3。金属污染物主要的附着对象是沉积物中的细小颗粒如生物膜上。以上沉积物性质对于解决排水系统的泥沙淤积问题以及水体污染的控制都具有重要意义。