Disinfection byproducts in drinking water and regulatory compliance: A critical review

Disinfection by-products (DBPs) are regulated in drinking water in a number of countries. This critical review focuses on the issues associated with DBP regulatory compliance, including methods for DBP analysis, occurrence levels, the regulation comparison among various countries, DBP compliance strategies, and emerging DBPs. The regulation comparison between China and the United States (US) indicated that the DBP regulations in China are more stringent based on the number of regulated compounds and maximum levels. The comparison assessment using the Information Collection Rule (ICR) database indicated that the compliance rate of 500 large US water plants under the China regulations is much lower than that under the US regulations (e.g. 62.2% versus 89.6% for total trihalomethanes). Precursor removal and alternative disinfectants are common practices for DBP regulatory compliance. DBP removal after formation, including air stripping for trihalomethane removal and biodegradation for haloacetic acid removal, have gained more acceptance in DBP control. Formation of emerging DBPs, including iodinated DBPs and nitrogenous DBPs, is one of unintended consequences of precursor removal and alternative disinfection. At much lower levels than carbonaceous DBPs, however, emerging DBPs have posed higher health risks.     

Optimizing synthesis conditions of nanoscale zero-valent iron (nZVI) through aqueous reactivity assessment

Nanoscale iron particles (nZVI) is one of the most important engineered nanomaterials applied to environmental pollution control and abatement. Although a multitude of synthesis approaches have been proposed, a facile method to screen the reactivity of candidate nZVI materials produced using different methods or under varying synthesis conditions has yet been established. In this study, four reaction parameters were adjusted in the preparation of borohydride-reduced nZVI. The reductive properties of the resultant nanoparticles were assayed independently using two model aqueous contaminants, Cu(II) and nitrate. The results confirm that the reductive reactivity of nZVI is most sensitive to the initial concentration of iron precursor, borohydride feed rate, and the loading ratio of borohydride to ferric ion during particle synthesis. Solution mixing speed, in contrast, carries a relative small weight on the reactivity of nZVI. The two probing reactions (i.e., Cu(II) and nitrate reduction) are able to generate consistent and quantitative inference about the mass-normalized surface activity of nZVI. However, the nitrate assay is valid in dilute aqueous solutions only (50 mg·L⁻¹ or lower) due to accelerated deactivation of iron surface at elevated nitrate concentrations. Additional insights including the structural and chemical makeup of nZVI can be garnered from Cu(II) reduction assessments. The reactivity assays investigated in this study can facilitate screening of candidate materials or optimization of nZVI production parameters, which complement some of the more sophisticated but less chemically specific material characterization methods used in the nZVI research.     

Effects of nano-silicon and common silicon on lead uptake and translocation in two rice cultivars

The current study investigated the effects of nano-silicon (Si) and common Si on lead (Pb) toxicity, uptake, translocation, and accumulation in the rice cultivars Yangdao 6 and Yu 44 grown in soil containing two different Pb levels (500 mg·kg⁻¹ and 1000 mg·kg⁻¹). The results showed that Si application alleviated the toxic effects of Pb on rice growth. Under soil Pb treatments of 500 and 1000 mg·kg⁻¹, the biomasses of plants supplied with common Si and nano-Si were 1.8%–5.2% and 3.3%–11.8% higher, respectively, than those of plants with no Si supply (control). Compared to the control, Pb concentrations in rice shoots supplied with common Si and nano-Si were reduced by 14.3%–31.4% and 27.6%–54.0%, respectively. Pb concentrations in rice grains treated with common Si and nano-Si decreased by 21.3%–40.9% and 38.6%–64.8%, respectively. Pb translocation factors (TFs) from roots to shoots decreased by 15.0%–29.3% and 25.6%–50.8%, respectively. The TFs from shoots to grains reduced by 8.3%–13.7% and 15.3%–21.1%, respectively, after Si application. The magnitudes of the effects observed on plants decreased in the following order: nano-Si treatment>common Si treatment and high-grain-Pb-accumulating cultivar (Yangdao 6)>low-grain-Pb-accumulating cultivar (Yu 44) and heavy Pb stress (1000 mg·kg⁻¹)>moderate Pb stress (500 mg·kg⁻¹)>no Pb treatment. The results of the study indicate that nano-Si is more efficient than common Si in ameliorating the toxic effects of Pb on rice growth, preventing Pb transfer from rice roots to aboveground parts, and blocking Pb accumulation in rice grains, especially in high-Pb-accumulating rice cultivars and in heavily Pb-polluted soils.     

Combined Effects of Levels of Protection and Environmental Variables at Different Spatial Resolutions on Fish Assemblages in a Marine Protected Area

Abstract: The links between species–environment relations and species’ responses to protection are unclear, but the objectives of marine protected areas (MPAs) are most likely to be achieved when those relations are known and inform MPA design. The components of a species’ habitat vary with the spatial resolution of the area considered. We characterized areas at two resolutions: 250 m² (transect) and approximately 30,000 m² (seascape). We considered three categories of environmental variables: substrate type, bottom complexity, and depth. We sought to determine at which resolution habitat characteristics were a better predictor of abundance and species composition of fishes and whether the relations with environmental variables at either resolution affected species’ responses to protection. Habitat features accounted for a larger proportion of spatial variation in species composition and abundances than differences in protection status. This spatial variation was explained best by habitat characteristics at the seascape level than at the transect level. Species’ responses to protected areas were specific to particular seascape characteristics, primarily depth, and bottom complexity. Our method may be useful for prioritizing marine areas for protection, designing MPAs, and monitoring their effectiveness. It identified areas that provided natural shelter, areas acting as buffer zones, and areas where fish species were most responsive to protection. The identification of such areas is necessary for cost‐effective establishment and monitoring of MPAs.     

十二烷基磺酸钠(SDS)对刺参幼参的急性毒性

为探究表面活性剂对海洋棘皮动物的影响,测定了十二烷基磺酸钠(SDS)对刺参(Stichopus japonicas)幼参的急性毒性。结果显示,SDS对刺参幼参的72h-LC_(50)和96h-LC_(50)分别为15.03和10.89mg·L~(-1)。刺参幼参相对于常见的几种水生生物对SDS的敏感性较高,其生命周期较长,活动能力较弱,生活相对固定于一定的区域,因此,在监测海洋水体SDS污染时,刺参幼参是一种值得关注的生物。     

Effects of a diesel oxidation catalyst on gaseous pollutants and fine particles from an engine operating on diesel and biodiesel

The effects of a diesel oxidation catalytic (DOC) converter on diesel engine emissions were investigated on a diesel bench at various loads for two steady-state speeds using diesel fuel and B20. The DOC was very effective in hydrocarbon (HC) and CO oxidation. Approximately 90%–95% reduction in CO and 36%–70% reduction in HC were realized using the DOC. Special attention was focused on the effects of the DOC on elemental carbon (EC) and organic carbon (OC) fractions in fine particles (PM_2.5) emitted from the diesel engine. The carbonaceous compositions of PM_2.5 were analyzed by the method of thermal/optical reflectance (TOR). The results showed that total carbon (TC), OC and EC emissions for PM_2.5 from diesel fuel were generally reduced by the DOC. For diesel fuel, TC emissions decreased 22%–32% after the DOC depending on operating modes. The decrease in TC was attributed to 35%–97% decrease in OC and 3%–65% decrease in EC emissions. At low load, a significant increase in the OC/EC ratio of PM_2.5 was observed after the DOC. The effect of the DOC on the carbonaceous compositions in PM_2.5 from B20 showed different trends compared to diesel fuel. At low load, a slight increase in EC emissions and a significant decrease in OC/EC ratio of PM_2.5 after DOC were observed for B20.     

Municipal solid waste management in Dalian: practices and challenges

The fast growing of urban areas in developing countries has brought serious problems on municipal solid waste (MSW) management. It will be rational to adopt an integrated approach to deal with such a challenge so that the overall eco-efficiency of MSW management could be improved. To better examine how attributes of integrated MSW management are being interpreted and put into practice, and to explore what changes should be made to improve the application of integrated MSW management, we employ a case study method so that lessons learned could be used to inform initiatives in other cities and the potential solution may offer feasible strategies. The case study city is Dalian, a typical seaport city with fast growing rate in economy. The outcomes of this case study show us that fragmented management structure, ineffective and inefficient enforcement of relevant regulations, backward technologies, limited financial resources and lack of public participation are main barriers for the implementation of integrated MSW management. Consequently, in order to overcome these barriers, we propose an integrated management framework on MSW management, aiming to maximize the overall eco-efficiency of MSW management.     

Determination of persistent organic pollutants by gas chromatography/laser multiphoton ionization/time-of-flight mass spectrometry

An authentic mixture of polychlorinated biphenyls was measured using a short wide-bore capillary column for the group separation of major components present in an actual sample of Kanechlor. The limits of detection were improved by ca. 2 fold in comparison with those obtained using a conventional capillary column, since the retention time was reduced and the amount of analytes introduced into the mass spectrometer per unit time could be increased. On the other hand, surface-water and sediment samples containing polycyclic aromatic hydrocarbons (PAHs) were collected from the river located in the vicinity of a waste water treatment plant. Even acenaphthylene, a minor component of the mixture could be measured for the sediment sample, and the concentrations were determined for several heavy PAHs. As demonstrated, a technique involving laser multiphoton ionization/time-of-flight mass spectrometry was useful as a sensitive and selective analytical tool for the trace analysis of persistent organic pollutants in an environmental sample.     

A new polystyrene-latex-based and EPS-containing synthetic sludge

Since the living microorganisms in activated sludge continuously change, it is difficult to conduct controlled experiments and achieve reproducible results for evaluating sludge characteristics. Synthetic sludge, as a chemical surrogate to activated sludge, could be used to investigate the sludge physicochemical properties, and it is desirable to prepare synthetic sludge with similar structure and properties to real activated sludge to explore the flocculation and settlement processes in activated sludge systems. In this work, a high-strength synthetic sludge was prepared with functional polystyrene latex particles as the framework and extracellular polymeric substances (EPS) to modify its surface. The flocculation and settling characteristics of the microspheres and the prepared synthetic sludge were tested. Compared with other three functional polystyrene latex microspheres, the synthetic sludge prepared with EPS-modified polystyrene latex microspheres showed good settling characteristics and a significantly higher strength. They could be used for studying the physicochemical properties of activated sludge.     

Characterization of soil low-molecular-weight organic acids in the Karst rocky desertification region of Guizhou Province, China

Soil low-molecular-weight (LMW) organic acids play important roles in the soil-forming process and the cycling of nutrients in Karst regions. In this study, we quantified the contents of LMW organic acids (including lactate, acetate, formate, malate, and oxalate) in soil solution over the Karst region of Guizhou Province, China using ion chromatography. The concentration of total LMW organic acids in topsoil solution ranged from 0.358 to 1.823 μmol·g^-1, with an average of 0.912 μmol·g^-1. The mean concentrations of lactate, acetate, formate, malate, and oxalate were 0.212±0.089, 0.302±0.228, 0.301±0.214, 0.014±0.018 and 0.086±0.118 μmol·g^-1, respectively. There were also significant difference in the contents of these acids among four phases of rocky desertification, and their concentrations decreased with the aggravation of rocky desertification. The concentrations of the LMW organic acids were significantly positive correlated each other. Significant positive correlations were also observed among individual LMW organic acids in soil solution, and between them and soil available P, available K, exchangeable Ca, respectively. Furthermore, the concentrations of LMW organic acids were significantly positively correlated with inorganic anions (chlorides, nitrates, and sulfates) in Karst topsoil solution. Therefore, the concentrations of soil LMW organic acids might be one of driving force in the Karst rock desertification process in Guizhou Province.