SO2-4/TiO2光催化降解苯酚

以工业硫酸氧钛为原料水解制得SO42-/TiO2光催化剂,并以苯酚为目标降解物,考察了SO24-/TiO2的光催化性能。结果表明:随着SO42-/TiO2制备过程中焙烧温度的升高,其光催化活性逐渐增加,650℃焙烧获得的SO24-/TiO2的光催化活性最好,此后再升高温度会因催化剂中硫的挥发而下降;在确定苯酚原液初始浓度为50 mg/L条件下,SO42-/TiO2的光催化降解苯酚的最佳工艺条件为反应时间2 h、苯酚pH为7、催化剂用量1 g/L。XRD、SEM和FTIR的分析结果显示实验温度下制得的SO42-/TiO2均为锐钛型TiO2;其间掺杂的SO24-在TiO2表面分散性较好,没有聚集成大的颗粒;红外分析的结果初步判定低温(<550℃)焙烧制得的催化剂SO42-在TiO2表面是螯合双配位吸附,高温焙烧时(>550℃)SO42-在TiO2表面是桥式配位吸附。     

电催化氧化技术处理制革综合废水

选择DSA电极中的钛基掺硼金钢石膜电极(Ti/BDD),用于制革综合废水的电催化氧化处理研究,考察了在不同的电流密度、电压、电解质、pH值和电解时间等因素对COD去除率和电流效率的影响。结果表明,控制电流密度为30mA/cm2,电压为8.0 V,电解质(NaCl)浓度为2.0 g/L,pH为4.0,电催化氧化处理2 h后,废水的COD和NH4+-N的去除率分别达到了83.6%和90.3%,BOD/COD为0.45,比能耗为35.34 kWh/kg COD,电流效率为37%。     

UV/Fenton技术处理某工厂高浓度乳化油废水

研究了UV/Fenton技术对高浓度金属清洗乳化油废水的处理效果,考察了亚铁与双氧水浓度、pH、反应时间和搅拌对COD去除效果的影响。实验结果表明,UV/Fenton技术对高浓度乳化油废水(COD平均浓度为35 000 mg/L)具有较高的去除效果,最佳工艺条件为:亚铁与双氧水浓度分别为2 400 mg/L和6 000 mg/L,pH为3,经过2 h反应,COD可降低至1 050 mg/L,去除率为97%。搅拌会降低COD的去除率。研究表明,UV/Fenton技术对高浓度乳化油废水具有很好的降解效果,且药品消耗较低,为目前此类高浓度有机废水的处理提供了技术参考。     

Ce-PbO_2/C电极的制备及其去除水中酸性红B

采用电沉积法制备铈修饰的PbO2/C电极,通过SEM、XRD、XPS及循环伏安对PbO2/C、Ce-PbO2/C电极进行表征,结果表明,Ce-PbO2/C电极比PbO2/C颗粒细小,表面均匀致密,电化学氧化能力较强,修饰电极中Ce以CeO2的形态存在。以Ce-PbO2/C为工作电极,电解浓度为1 000 mg/L的高盐酸性红B模拟活性染料废水,考察了电压、pH、电解质浓度、极间距对脱色率、氨氮去除率及COD去除率的影响。确定适宜工艺条件为：初始酸性红B溶液浓度为1 000 mg/L,pH值为6,电压10 V,电解时间1 h,电极间距1.5 cm,该条件下脱色率、氨氮去除率和COD去除率分别为99.98%、97.23%和90.17%。通过UV-Vis及GC-MS初步分析了降解过程可能存在的中间产物及降解途径。     

A/O+MBR工艺处理玉米深加工废水的中试研究

实验基于企业污水站的改造工程,研究了MBR对玉米深加工废水的处理效果并对工艺运行参数优化提出建议.结果表明,该工艺对COD的去除率可以达到90％以上,出水稳定在26 mg/L左右;出水NH4-N达到1 mg/L以下;TN去除率达到70％以上,出水TN达到10 mg/L以下,出水完全达到排放标准.通过4种工况的比较,说明在污泥浓度8 g/L左右,曝气池内DO在3 mg/L左右,MBR内DO＞4 mg/L,好氧段停留时间13.5 h,并保证3h以上的缺氧段水力停留段时间的条件下,A/O+ MBR工艺可以有效去除玉米深加工废水中的污染物.     

Matrine and oxymatrine in corroborant plant extracts and fertilizers: HPLC/MS-MS method development and single-laboratory validation

A reversed phase high-performance liquid chromatographic method (HPLC/MS-MS) has been developed and validated for detection of alkaloids matrine and oxymatrine in fertilizer with labeled enhancer plant defense activities. The analytical method was validated statistically. The results show a strong matrix effect, requiring quantification by standard addition method. The regression lines showed r² > 0.994. Recoveries ranging from 97 to 104% were obtained for the fortification level of 0.01% wt wt^?1 and the relative standard deviations ranged from 3 to 4% (n = 10). The limits of detection were below 0.0001% wt wt^?1, while the limits of quantification did not exceed 0.0004% wt wt^?1. The method is currently applied in ICQRF Laboratory of Catania on fertilized and corroborant plant extract collected in the Italian market in the frame of MIPAAF institutional quality control activity, with the aim to dectect these unpermitted active substances.     

The electron density distribution in pyridinium and bipyridylium compounds and its relevance to their adsorption by expanding lattice clays

Abstract

Charge distributions in 1, 1'‐ethylene‐2, 2'‐bipyridylium (diquat), 1,1'‐dimethyl‐4,4'‐bipyridylium (paraquat) and 1‐methylpyridinium organocations were calculated by a Complete Neglect of Differential Overlap semi‐empirical quantum mechanical procedure. The data show that the positive charges in the organocations are distributed around the molecules and are greatest in the positions ortho and para to the heterocyclic nitrogen atoms. Earlier interpretations of the mechanisms of adsorption of paraquat and diquat by soils and clays assumed that the charges were located in the heterocyclic nitrogen atoms. Here some consideration is given to the influence of the charge delocalizations on the processes of adsorption by montmorillonite and vermiculite clay preparations.     

Co-composting of Paper Mill Sludge and Hardwood Sawdust Under Two Types of In-Vessel Processes

Abstract

Recycling of organic residues by composting is becoming an acceptable practice in our society. Co-composting dewatered paper mill sludge (PMS) and hardwood sawdust, two readily available materials in Canada, was investigated using uncontrolled and controlled in-vessel processes. The composted materials were characterized for total C and N, water-soluble, acid-hydrolyzable, and non-hydrolyzable N, extractable lipids, and by Fourier Transform Infrared (FT-IR) spectrophotometry. In the controlled scale process, the loss of organic matter was approximately 65% higher than in the uncontrolled process. After undergoing initial fluctuations in N fractions during the first two days of composting, by the end of the process, concentrations of water-soluble N decreased while those of acid-hydrolyzable and nonhydrolyzable N increased in the controlled process, whereas in the uncontrolled process, water-soluble N increased, but N in the other two fractions decreased continuously, indicating that the biochemical transformations of organic matter were not completed. Data on extractable lipids and FT-IR spectra suggest that the compost produced from the controlled process was bio-stable after 14 days, while the uncontrolled process was not stabilized after 18 days. In addition, FT-IR data suggest the biological activity during composting centered mainly on the degradation of aliphatic structures while aromatic structures were preserved. The co-composting of the PMS and hardwood sawdust can be successfully achieved if aeration, moisture, and bio-available C/N ratios are optimized to reduce losses of N.     

Analysis of Herbicide Krovar I™ by Liquid Chromatography with Atmospheric Pressure Chemical Ionization Mass Spectrometry

Abstract

A simple, very efficient method is presented for routine analysis of herbicide Krovar I? (active components bromacil and diuron) in water and soil samples. Water samples were extracted by liquid–liquid extraction with dichloromethane (DCM) as extraction solvent. For soil samples two different extraction techniques were compared: microwave-assisted solvent extraction and a shaking technique using a platform shaker. Extracts were analyzed by high performance liquid chromatography using a water:methanol gradient. Liquid chromatography was coupled with atmospheric pressure chemical ionization mass spectrometry (LC-APCI-MS) for quantification of bromacil and diuron. Optimization of the APCI-MS was done by using standards in the flow injection analysis mode (FIA). Method detection limit for liquid samples for bromacil is 0.04 µg L^?1 and for diuron 0.03 µg L^?1. Method detection limit for soil samples is 0.01 µg g^?1 dry weight for both compounds. Results of analysis of field samples of water and soil are also presented.     

Parental phenols exposure and spontaneous abortion in Chinese population residing in the middle and lower reaches of the Yangtze River

Widespread use of phenols has led to ubiquitous exposure to phenols. In experimental animals, phenols increased resorptions, reduced live litter size and fetal body weights. However, there are limited epidemiological evidences of the relationships between exposure to phenols and pregnancy outcomes. We evaluated the associations between parental urinary levels of various phenols and spontaneous abortion in a Chinese population residing in the middle and lower reaches of the Yangtze River. A case-control study was conducted that included 70 case couples with medically unexplained spontaneous abortion and 180 control couples who did not have a history of spontaneous abortion and had at least one living child. Both parental urinary phenols were measured by ultra-high performance liquid chromatography-tandem mass spectrometry including bisphenol A (BPA), benzophenone-3 (BP-3), 2,3,4-trichlorophenol (2,3,4-TCP), pentachlorophenol (PCP), 4-n-octylphenol (4-n-OP) and 4-n-nonylphenol (4-n-NP). Compared with the low exposure group, there was an increased risk of spontaneous abortion with high paternal urinary PCP concentration [odds ratio (OR) = 2.09, 95% Confidence Interval (CI), 1.05–4.14], and maternal exposure to 4-n-OP and alkylphenol(s) also significantly increased the risk of spontaneous abortion (OR = 2.21, 95% CI, 1.02–4.80; OR = 2.81, 95% CI, 1.39–5.65, respectively). Our study firstly provides the evidence that paternal PCP exposure, maternal 4-n-OP and alkylphenol(s) exposure are associated with spontaneous abortion in humans.