蛋鸡粪便理化指标与其肥料成分含量相关关系研究

为了寻找快速、简便、精确地测量液体蛋鸡粪便中总氮(TN)、总磷(TP)、有机物(OM)、铵态氮(AN)和总钾(TK)含量的方法,研究了采样前将样品搅拌或静置对所取样品代表性的影响,并用75份生长期为4～6月龄蛋鸡的液体粪便样本建立了密度(SG)与TN、TP、OM,电导率(EC)与AN和TK的一元线性回归模型以及SG、EC、pH与TN、TP、OM、AN和TK的多元线性回归模型.结果表明,对于TN、TP、OM、AN,采样前将样品充分搅拌是获得代表性样本的前提条件,而搅拌与否并不影响TK代表性样本的获得.SG与TN、TP、OM,EC与AN和TK均存在显著的线性相关性(P＜0.001),模型的决定系数(R2)均较高,分别为0.94,0.94,0.95,0.94和0.94,多元线性模型的决定系数高于一元线性模型的决定系数.用另外15份样本对5个一元线性回归模型进行验证,并对模型系数b和常数项a进行t检验,得出在显著水平α=0.05上,假设Ha0:(a)=0和Hb0:(b)=1全部接受.由此认为,SG与TN、TP和OM,EC与AN和TK所建立的一元线性回归模型均具有较好的预测效果.     

矿山粉尘的湿式纤维层过滤阻力类比研究

为提高矿山粉尘收集效率,对除尘器湿式过滤层纤维丝过滤阻力进行理论分析,建立粉尘粒子通过除尘器湿式纤维丝时的阻力理论模型,自行设计了湿式纤维层过滤实验模拟系统,模拟矿山粉尘特点进行了实验研究,对理论模型参数进行了无量纲修正,进一步完善粉尘湿式过滤的阻力理论公式.实验表明,该理论在实际应用中具有较高的准确性.经修正后的理论曲线不仅与实验曲线的趋势保持一致,同时数值上也基本吻合,具有良好的代表性.     

兆欧表的禁忌分析与防范措施

通过对电气领域的电气安全问题长期研究以及对测试工作中经验、教训的总结,针对兆欧表在电气领域应用中的十六种不正确、不妥当的使用方法,对其错误及危害性逐项进行分析探讨,并提出了相应的改进办法及防范措施。实践表明,这些改进办法及防范措施在电气技术工作和安全生产管理中具有一定的实用价值。     

Influence of workpiece materials on aerosol emission from die sinking electrical discharge machining process

Simultaneous investigation of environmental emissions and machining aspects of electrical discharge machining process is essential for achieving hygienic and efficient machining. The main objective of the present work is to experimentally investigate and analyze the aerosol emission rate and the material removal rate from a die sinking electrical discharge machining process for three commonly used work piece materials viz., tool steel, mild steel and aluminum using Taguchi methodology of Experimental Design in order to suggest suitable process conditions for green manufacturing. The aerosol emission profile of all workpiece materials was found to be closely related to the material removal profile. A significant variation in emission and material removal rate was observed for workpiece materials which may be accorded to the variation in melting and vaporization temperatures. It was also observed that majority of aerosol constituents evolved from workpiece materials and that the constituents with low melting points were having high relative concentration in the aerosol emitted. The study introduced a parameter, the relative emission rate for comparing the emission for various process parameters and workpiece–tool material combinations. The favorable machining parameters for each material were then identified by employing signal to noise ratio analysis of the relative emission rate.     

ETU mineralization in soil under influence of organic carbon content,temperature, concentration,and depth

The mineralization of ¹⁴C‐ETU was measured by the evolution of ¹⁴CO₂ and described with a mathematical model consisting of two terms — one term describing the immediate mineralization of ¹⁴C‐ETU and another term describing the first order degradation of humus and/or biomass, where ¹⁴C had been built in. The influence of pesticide concentration, depth of soil, and incubation temperature showed combined interaction effects on the amount of ¹⁴CO₂ formed during the process and on the degradation rate of the pesticide. With the addition of soil extract, a combined effect between concentration and addition of organic extract was seen for the degradation rate, while a three‐way interaction between depth, concentration and organic extract was seen for the formation of ¹⁴CO₂. Degradation of ¹⁴C‐ETU can thus not be described only through investigations of one single of the mentioned parameters.     

受压浮煤自燃过程试验研究

矿井采空区遗煤自燃大部分为处于受压状态下的自燃。为观察压力对浮煤自燃过程的影响,采用自制的浮煤加载自燃试验装置对受压浮煤层与自然堆积状态下的自燃过程进行试验研究。结果表明:加载对浮煤的自燃过程确实存在一定影响。加载会加快浮煤层的升温速度,缩短自然发火期,降低最小浮煤层厚度,改变采空区"三带"的划分;加载对厚度介于0.8～1.2 m之间浮煤自燃过程影响最大;随着压力的增加,压力对浮煤自燃过程的影响逐渐减弱,当压力小于1 600 N时,压力的增加对浮煤自燃过程的影响较明显,当压力大于1 600 N时,压力的增加对浮煤自燃过程的影响变小,当压力大于2 600 N时,压力的增加对浮煤自燃过程几乎无影响。     

Horizontal diffusion by submeso motions in the stable boundary layer

Four networks of wind data are used to construct the first systematic estimates of the horizontal diffusivity from observations of submeso motions on scales often unresolved in numerical models. Currently, the horizontal diffusivity in numerical models is specified mainly for numerical reasons without observational support. The data analysis in this study emphasizes the stable boundary layer although results are briefly presented for the unstable boundary layer. The horizontal diffusivity is estimated from the horizontal gradient and the observed flux. Horizontal gradients of scalars are generally difficult to directly estimate from observations with sufficient accuracy for much of the data. As an alternative, simulated particles with conservative properties are introduced into the observed wind field in order to estimate the horizontal diffusivity for submeso motions. The sensitivity of the horizontal diffusivity to details of the method is examined. The horizontal diffusivity increases with the range of time and space scales that are included in the evaluation. The horizontal diffusivity is much larger with significant topography and may increase with wind speed, depending on the site location. The coarse station spacing or the small domain size is found to be a major limitation to the analysis.     

碾压混凝土层面抗剪强度的细观数值研究

碾压混凝土 (RCC)层面抗剪强度关系到碾压混凝土坝的安全。笔者采用随机骨料模型模拟碾压混凝土的细观结构 ,利用有限元方法数值模拟碾压混凝土试件的细观损伤断裂和抗剪强度 ,将所得数值结果与混凝土重力坝设计规范参考值比较 ,结果较为吻合。同时对直剪试验尺寸效应进行研究 ,并给出提高层面抗剪能力的措施。     

推制大口径弯头设计与制造工艺的研究

主要介绍了90°推制大口径弯头设计及成形的工艺过程、变形特点,分析了推制大口径弯头成形过程中金属的流动规律以及弯头内外弧壁厚与设计强度的关系。     

薄隔水层井筒底板突水的突变模型

在薄板理论的基础上,建立了立井井筒底板突水的突变模型。运用突变理论的分析方法,求得了井筒底板隔水层的最小理论安全厚度,这与典型案例实际情况基本相符。论文根据在大涨落存在的前提下突变发生所遵循的Ｍａｘｗ ｅｌｌ规则,对理论值和实际值的偏差作了合理的解释,还提出了解决该偏差的一种近似计算方法。所进行的研究工作,为井筒突水的预测及确定隔水层的安全厚度,提供一种新的理论方法和途径。