中国NOx控制制度研究

中国NOx污染呈现总量逐年增加的趋势,已成为大气污染治理的主要内容.从NOx的控制制度、排放指标上对我国现行NOx控制体系进行了分析,并对我国进一步完善NOx控制制度及标准提出了建议.主要建议有(1)降低NOx控制标准适应当前环境状况;(2)应用科学方法,制订合理的NOx总量控制标准和制度;(3)制订氮氧化物排放标准;(4)浓度控制和总量控制结合.总量控制的实施要注意污染物排放标准制定的政策取向;总量控制法的基本原理和程序;总量控制结合排放标准控制.     

Reviews of emission of biogenic volatile organic compounds (BVOCs) in Asia

Biogenic volatile organic compounds (BVOCs) in the atmosphere play important roles in the formation of ground-level ozone and secondary organic aerosol (SOA) in global scale and also in regional scale under some condition due to their large amount and relatively higher reactivity. In places with high plant cover in the tropics and in China where air pollution is serious, the effect of BVOCs on ozone and secondary organic aerosols is strong. The present research aims to provide a comprehensive review about the emission rate, emission inventory, research methods, the influencing factors of BVOCs emissions, as well as their impacts on atmospheric environment quality and human health in recent years in Asia based on the summary and analysis of literatures. It is suggested to use field direct measurement method to obtain the emission rate and model method to calculate the emission amount. Several recommendations are given for future investigation and policy development on BVOCs emission.     

油松排放萜烯类化合物浓度的日变化及排放速率的研究

 采用封闭式采样和气相色谱法分析监测了北京主要树种油松排放的萜烯类化合物，其中包括α和β蒎烯、蒈烯、松油烯、柠檬烯和罗勒烯，以及少量异戊二烯。松油烯、B蒎烯、柠檬烯和蒈烯的排放量之和占油松排放碳氢总量的94％以上。萜烯和异戌二烯排放速率随日照和温度的升高而增加。萜烯等浓度的日变化表明在正午和午夜油松有两个排放高峰。在日均气温为18℃时油松的碳氢化合物平均总排放速率约为8.7μh/h.g。     

Numerical model to quantify biogenic volatile organic compound emissions: The Pearl River Delta region as a case study

This article compiles the actual knowledge of the biogenic volatile organic compound (BVOC) emissions estimated using model methods in the Pearl River Delta (PRD) region, one of the most developed regions in China. The developed history of BVOC emission models is presented briefly and three typical emission models are introduced and compared. The results from local studies related to BVOC emissions have been summarized. Based on this analysis, it is recommended that local researchers conduct BVOC emission studies systematically, from the assessment of model inputs, to compiling regional emission inventories to quantifying the uncertainties and evaluating the model results. Beyond that, more basic researches should be conducted in the future to close the gaps in knowledge on BVOC emission mechanisms, to develop the emission models and to refine the inventory results. This paper can provide a perspective on these aspects in the broad field of research associated with BVOC emissions in the PRD region.     

黄土高原生态环境的恶化及其对策

由于种种原因,黄土高原生态环境脆弱现象日益扩张,水土流失、沙漠化、干旱、沙尘暴等灾害频繁发生,生态环境的可持续性引起了科技工作者的关注。利用历史资料,从黄土高原2000a左右的自然灾害发生频率、森林植被的严重破坏、土壤侵蚀的不断加剧、人口的无限制增长以及近几十年来黄河的频繁断流等几个方面出发,说明了黄土高原生态环境在这些重要因素的影响下,表现出明显的不可持续性发展,并提出了相应的防治对策,包括加强人口控制、加快植被的恢复与重建、节约利用水资源以及提高利用效率等。该研究的目的并非消极悲观,而是正确认识黄土高原生态环境的演变历史,树立国民的环境忧患意识和可持续发展的思想,为实现黄土高原的生态安全和持续发展提供科学依据。     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

电子受体类型对聚磷污泥胞外聚合物的影响研究

采用3种电子受体(硝氮、亚硝氮、氧),在SBR反应器中分别驯化了具有稳定除磷能力的聚磷污泥。对比研究了不同聚磷污泥胞外聚合物(EPS)的组分与含量,结合三维荧光光谱对EPS中有机物质进行分析。研究表明,以硝氮、亚硝氮为电子受体的聚磷污泥EPS平均浓度较为接近,分别为115.6mg/gVSS、133.5 mg/gVSS,由厌氧段至缺氧段,EPS总浓度有所下降。以氧为电子受体聚磷污泥的EPS平均浓度相对较高,为194.5 mg/gVSS,由厌氧段至好氧段,EPS总浓度略有升高。不同聚磷污泥的EPS组分均以胞外蛋白为主,占EPS总量的53%~65%,多糖与核酸占EPS总量28%~34%、5%~7%。三维荧光光谱显示3种聚磷污泥EPS均具有芳香结构蛋白质、可溶性代谢物的荧光峰,另外,以硝氮为电子受体的聚磷污泥还具有明显的腐殖酸类物质的荧光峰。研究结果表明电子受体对聚磷污泥EPS的组分、浓度、有机质类别有一定的影响。     

Estimation and characterization of PCDD/Fs and dioxin-like PCBs from Chinese iron foundries

The iron foundry industry is considered to be a potential source of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). This study investigated the emission factors and total emission amounts of PCDD/Fs and dioxin-like polychlorinated biphenyls (DL-PCBs) from iron foundries in China. The concentrations and the World Health Organization toxicity equivalents (WHO-TEQs) are presented and the congener profiles are discussed in this paper.In the present work, 26 fly ash samples were collected and tested to quantify the PCDD/Fs and DL-PCBs generated by 14 plants of different scales, and five stack gas samples were collected from two (named as EFG and LFG) of those plants. The emission levels of PCDD/Fs and DL-PCBs indicated that hot-air cupolas had lower emissions than cold-air cupolas. When iron ore lump and sinter were used as raw material, the emission factors were about 250 ng TEQ t⁻¹ of product. However, if the raw material was scrap, the emission factors varied owing to the different contents of organic materials in the raw materials. It was found that the mean WHO-TEQ values of PCDD/Fs and DL-PCBs were 144 and 34.2 pg Nm⁻³ in stack gas and 20.0 and 1.58 pg g⁻¹ in fly ash. In multiple tests, it was estimated that the mean emission factors of PCDD/Fs and DL-PCBs were 365 and 10.9 ng WHO-TEQ t⁻¹ released to residue and 2719 and 555 ng TEQ t⁻¹ released to air. The total emission amounts of PCDD/Fs and DL-PCBs from Chinese iron foundries with cupola furnaces released to residue and air were 16.8 and 146 g WHO-TEQ in 2008, respectively.     

Emission characterization of unintentionally produced persistent organic pollutants from iron ore sintering process in China

Emission of unintentionally produced persistent organic pollutants (Unintentional POPs), including polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), polychorinated biphenyls (PCBs), hexachlorobenzene (HxCBz) and pentachlorobenzene (PeCBz), were investigated in four typical iron ore sintering plants in China. The emission factors and annual mass releases of the Unintentional POPs were calculated. The results indicated that PCDFs contributed more than 60% to the overall toxic equivalent quantity (TEQ) values, while the contribution of the dl-PCBs is relatively low, and only in the range of 8-9%. The dominant congeners of PCDD/Fs and dl-PCBs contributing most to the total TEQ were 1,2,3,7,8-PeCDD, 2,3,4,7,8-PeCDF and PCB-126. With regard to the TEQ contributions, the most abundant homologues were PeCDFs and HxCDD/Fs, followed by PeCDDs and non-ortho dl-PCB, whereas HpCDD/Fs, OCDD/Fs and mono-ortho dl-PCBs almost made no contributions. Due to the massive use of recycled waste in the feeding materials, the average emission factor of PCDD/Fs and dl-PCBs of the four plants was 3.95 μg WHO-TEQ ton⁻¹. Based on the results, the annual release of PCDD/Fs and dl-PCBs in 2007-2009 were estimated to be 2070 g, 2212 g, and 2307 g WHO-TEQ, respectively.     

Investigation on the relationship between the fine particle emission and crystallization characteristics of gypsum during wet flue gas desulfurization process

The relationship between the fine particles emitted after desulfurization and gypsum crystals in the desulfurization slurry was investigated, and the crystallization characteristics varying with the operation parameters and compositions of the desulfurization slurry were discussed. The results showed that the fine particles generated during the desulfurization process were closely related to the crystal characteristics in the desulfurization slurry by comparison of their morphology and elements. With the higher proportion of fine crystals in the desulfurization slurry, the number concentration of fine particles after desulfurization was increased and their particle sizes were smaller, indicating that the optimization of gypsum crystallization was beneficial for the reduction of the fine particle emission. The lower pH value and an optimal temperature of the desulfurization slurry were beneficial to restrain the generation of fine crystals in the desulfurization slurry. In addition, the higher concentrations of the Fe^3 + ions and the F⁻ ions in the desulfurization slurry both promoted the generation of fine crystals with corresponding change of the morphology and the effect of the Fe^3 + ions was more obvious. With the application of the desulfurization synergist additive, it was beneficial for the inhibition of fine crystals while the thinner crystals were generated.