活性污泥性质对短期膜污染影响的解析研究

采用统计分析方法研究了16种不同性质活性污泥混合液对膜生物反应器膜污染的影响机理.结果表明,胞外聚合物(extracellular polymeric substances,EPS)、溶解性有机物(soluble microbial products,SMP)、上清液胶体颗粒(suspended solids insupernatant,SS_s)、污泥混合液粘度(μ)、相对疏水性(relative hydrophobicity,RH)、Zeta电位(Zeta potential)均对膜生物反应器膜渗透性能有显著的影响作用,其与膜污染阻力的皮尔逊相关系数r_p分别为:0.898、0.712、0.810、0.691、0.837、-0.881;同时发现,胞外聚合物是影响活性污泥中溶解性有机物含量(r_p=0.682)、污泥粘度大小(r_p=0.633)、上清液胶体颗粒含量(r_p=0.783)、Zeta电位(r_p=-0.953)及相对疏水性大小(r_p=0.877)的主要因素;在活性污泥性质中胞外聚合物是影响膜污染的根本原因,是膜生物反应器膜污染的重要影响因素.     

微涡旋絮凝-逆流气浮-纳滤集成工艺去除水中腐殖酸的研究之二——以聚合氯化铁(PFC)为絮凝剂

试验研究了微涡旋絮凝-逆流气浮-纳滤集成工艺去除水中腐殖酸的工艺特征和效果.试验结果表明,微涡旋絮凝-逆流气浮工艺去除水中腐殖酸时,在聚合氯化铁(PFC)的最佳投药点0.62 mmol·L-1(Fe3 )下,出水水质符合纳滤膜系统预处理单元的要求,而且该工艺需要PFC絮凝剂的量较低.该预处理系统与纳滤系统组合的集成工艺可以使水中的腐殖酸有机物浓度大大降低,且含TQ56-36FC型纳滤膜的流程1比含M-N1812A型纳滤膜的流程2效果好.前者出水的TOC值可达0.48 mg·L-1,CODMn值为0.64～0.69mg·L-1,UV254值为0,且有95%以上的脱盐率.后者出水的TOC值为0.61～1.00mg·L-1,CODMn值为0.72～0.97mg·L-1,UV254值为0～0.0109,脱盐率很低.另外,尽管保安过滤/活性炭预处理有利于纳滤膜出水水质的提高,但活性炭柱的存在也降低了纳滤膜对有机物的去除率.动态实验结果表明,该集成工艺在本试验中运行周期为72h.水中颗粒物粒度分布表明,原水、絮凝后和气浮出水中颗粒物粒度分布的中位直径(d50)分别为2～5 μm、21 μm和16μm;经过保安过滤器或保安过滤器/活性炭柱,水样中的颗粒物的d50为0到几个μm;经过纳滤膜后,出水基本无颗粒物.初步研究表明,微涡旋絮凝过程中投药量对絮体的分形维数有着显著影响.     

Effect of biocides on the precipitation of calcium fluoride in the presence of anionic copolymeric inhibitors

The inhibitory efficiency of anionic copolymers and the effect of the biocides sodium hypochlorite, glutaraldehyde, and tris(hydroxymethyl)nitromethane on the precipitation behavior of calcium fluoride (CaF₂) were studied. The efficiency of polymeric inhibitors was traced from conductivity measurements by using half-life (t_1/2) method. X-ray diffraction parameters have been measured for calcium fluoride scale minerals. An anionic copolymer (K-798) acts as one of the best inhibitors for the precipitation process of the calcium fluoride in water as compared to K-775. It is assigned to the fact that the copolymer (K-798) contains both sulfonic acid and sulfonated styrene groups while the polymer (K-775) having only the sulfonic acid group. It was further observed that the biocides have no appreciable effect on the performance of the anionic polymeric inhibitors.     

Integrated energy view of wastewater treatment: A potential of electrochemical biodegradation

• Energy is needed to accelerate the biological wastewater treatment. • Electrical energy input in traditional technology is indirect and inefficient. • Direct injection of electricity can be a game changer to maximize energy efficiency. • Microbial electrochemical unit for decentralized wastewater treatment is proposed. It has been more than one century since the activated sludge process was invented. Despite its proven stability and reliability, the energy (especially the electrical energy) use in wastewater treatment should evolve to meet the increasingly urgent demand of energy efficiency. This paper discusses how the energy utilized in conventional biological wastewater treatment can be altered by switching the indirect energy input to a direct electricity injection, which is achieved by the electrode integration providing extra thermodynamic driving force to biodegradation. By using electrodes instead of oxygen as terminal electron acceptors, the electrical energy can be utilized more efficiently, and the key of direct use of electrical energy in biodegradation is the development of highly active electroactive biofilm and the increase of electron transfer between microbes and the electrode. Furthermore, the synergy of different microbial electrochemical units has additional benefit in energy and resource recovery, making wastewater treatment more sustainable.     

酸去除剩余活性污泥重金属效果及农用安全性

污水处理厂剩余污泥中的重金属是污泥农用的潜在危害之一,因此如何有效去除污泥中的重金属以保证其农用安全性是当前迫切需要解决的问题。采集污水处理厂二沉池的活性污泥,比较不同物质的量比的盐酸和硝酸(1∶2、1∶1、2∶1)浸取污泥中重金属Pb、Zn、Cd、Cu和Mn的效果,采用Tessier连续提取方法定时检测污泥重金属相态分布,分析混合酸对污泥EPS结构和质量比的影响,并检验了处理后污泥对菠菜生长及重金属富集的影响。结果表明:1)盐酸/硝酸物质的量比为2∶1时效果最佳,重金属浸出率从高到低依次为Pb、Zn、Cd、Mn、Cu;2) Pb的可交换态和碳酸盐结合态比例最高,Cu的残渣态比例最大,可交换态、碳酸盐结合态和FeMn氧化物结合态比例越大,重金属的浸出率越高;3)酸浸试验期间EPS总量减少,黏液层和LB-EPS层易脱落;最后盆栽试验表明处理后污泥中重金属的潜在迁移性风险大大减弱,且污泥对菠菜生长有明显的促进作用。因此混合酸处理后污泥可以安全用于农业种植,且污泥与土壤干重比为1∶1时效果最佳。     

复合型混凝剂聚磷氯化铁的混凝机理及应用

对工业废水及生活污水的处理实验对经研究以及对PPFC形态结构的研究结果表明，PPFC对几种废水的浊度和COD去除率均超过聚氯化铝、氯化铁、聚氨化铁，与聚硫酸铁效果相当。与聚氯化铁相比，PPFC形态分布及结构也发生了很大变化，特别是PPFC中Fe(b)的量大大增多，这睚是PPFC混凝性能提高的原因。     

大孔树脂吸附法在含酚废水处理中的应用

综述了近１０多年来应用大孔树脂吸附法处理各种含酚工业废水的研究成果和应用实例，包括各种废水的由来与概况、处理工艺条件和应用效果，结果表明，吸附树脂具有吸附效果好，脱附再生容量、性能稳定、适用范围宽、实用性好、可实现综合利用等特点，是处理含酚工业废水的有效方法。     

一种研究絮凝过程的新方法——透光脉动检测技术

采取电解法制备聚合絮凝剂可望通过控制过程的电化学与溶液化学条件，克服化学法制备中的缺陷，以获取最优的絮凝剂形态和效果。极化是影响电解制备的最主要问题之一。它将产生过电位，增加电解槽压，降低电流效率。     

电解法制备高效聚合絮凝剂的研究进展

本文从现代絮凝剂及其絮凝作用原理出发，系统阐述了电解合成高效聚合氯化铝的基本原理、现有方法以及尚存的关键理论和技术问题，并预计它能克服现有化学制备方法的局限性，提高产品质量，有着重要的科学意义，实用价值和广阔的应用前景。     

Al-Ferron逐时络合比色法研究PACS中铝的水解聚合形态

制备了碱化度(B)及不同Al~(3+)/SO_4~(2-)摩尔比的系列PACS,用Al-Ferron逐时络合比色法研究了铝的形态分布,考察了碱化度(B)、Al~(3+)/SO_4~(2-)摩尔比、稀释作用及pH值对铝的形态分布的影响.实验结果表明,Al~(3+)/SO_4~(2-)摩尔比及溶液的pH值对铝的形态分布有较大的影响,稀释作用对铝的形态分布影响较小.Al~(3+)/SO_4~(2-)摩尔比愈小,pH值愈高,铝的水解聚合大分子及胶体粒子所占的比例就愈大.