平流层臭氧深度侵入对典型城区的影响过程分析

中纬度平流层臭氧深度侵入是造成对流层至近地面臭氧浓度突增的原因之一。筛选春夏季臭氧浓度升高时段的高分辨率大气再分析数据ERA5,以位涡值的下沉趋势分析了对流层顶折叠位置及变化过程;以AIRS数据反演了臭氧浓度、一氧化碳浓度和相对湿度的垂直廓线,并估计了其分布及相关性;以近地表污染物浓度变化、HYSPLIT模型后向轨迹分析结果证实了臭氧侵入气团的运移轨迹和局地效应;通过激光雷达监测结果观测臭氧垂直浓度分布,确定了臭氧浓度最大值所处高度,判定了受影响近地点的浓度升高时刻;以边界层高度变化、气象条件分析结果及当地与周边城市地面监测数据的逐小时变化情况等综合信息,进行了区域确认和近地面影响判定。通过以上数值综合分析,对城市地区受平流层臭氧深度侵入影响的过程和具体时间进行了详细再现,可为排除非人为排放因素导致的近地表臭氧浓度增加提供回溯分析,为臭氧污染防控决策提供依据。     

焦化废水中多环芳烃的成分谱及污染特征

液-液萃取-高效液相色谱法分析了焦化废水中EPA优先控制的16种多环芳烃含量,总结出其成分谱及污染特征。结果表明:16种多环芳烃在焦化废水中浓度差异较大,主要以在水中溶解度较大的萘、苊、芴、菲、荧蒽、芘为主。其中萘对多环芳烃总量的贡献最大,占总量的36.70%~86.78%。焦化企业排放废水中6种多环芳烃的总量无超标现象,苯并[a]芘单体超标较普遍。     

休耕对抚仙湖周边农田土壤剖面和浅层地下水中氮累积的影响

减少外源氮投入能有效降低农田土壤氮累积和地下水氮污染,休耕是减少外源氮投入的重要措施之一.为探讨农田休耕对土壤剖面和浅层地下水中氮累积的影响,以抚仙湖周边农田土壤剖面和浅层地下水为研究对象,分析了休耕前（2017年12月）和休耕后（2020年8月和2021年4月）农田0~100 cm土壤剖面氮累积和浅层地下水中氮浓度的变化及其两者的关系.结果表明:休耕显著降低了土壤剖面氮含量和储量,休耕后0~30、30~60和60~100 cm土壤剖面TN、ON、DTN、NO₃ ^--N和NH₄ ⁺-N含量分别降低18.4 %~36.5 %、16.1 %~26.8 %、54.0 %~130.2 %、59.5 %~90.8 %和60.1 %~110.6 %.休耕前0~100 cm土壤TN、ON、DTN、 NO₃ ^--N和NH₄ ⁺-N储量分别为（17.20 ±0.97）t·hm^-2、（15.50 ±1.23）t·hm^-2、（0.68 ±0.06）t·hm^-2、（266.8 ±31.17）kg·hm^-2和（18.7 ±3.04）kg·hm^-2,休耕后各形态氮储量分别下降了25.5 %、23.3 %、44.7 %、80.1 %和59.9 %.休耕也改变了浅层地下水中氮浓度和形态构成,休耕后地下水中TN、ON、NO₃ ^--N和NH₄ ⁺-N浓度分别下降了88.4 %、82.7 %、92.1 %、65.8 %,ON/TN和NH₄ ⁺-N/TN从休耕前的26 %和6 %升高至休耕后的39 %和17 %,而NO₃ ^--N/TN从休耕前的61 %降至休耕后的41 %.地下水氮浓度和形态变化与休耕前后土壤中DTN、NH₄ ⁺-N、NO₃ ^--N和地下水中pH、ORP、DO等因素密切相关.可见,休耕有效降低了农田土壤剖面氮累积,缓解了浅层地下水氮污染,有利于防止高原湖泊的水质恶化.     

Source profiles of particulate organic matters emitted from cereal straw burnings

Cereal straw is one of the most abundant biomass burned in China but its contribution to fine particulates is not adequately understood. In this study, three main kinds of cereal straws were collected from five grain producing areas in China. Fine particulate matters （PMzs） from the cereal straws subjected to control burnings, both under smoldering and flaming status, were sampled by using a custom made dilution chamber and sampling system in the laboratory. Element carbon （EC） and organic carbon （OC） was analyzed. 141 compounds of organic matters were measured by gas chromatography-mass spectrum （GC-MS）. Source profiles of particulate organic matters emitted from cereal straw burnings were obtained. The results indicated that organic matters contribute a large fraction in fine particulate matters. Levoglucosan had the highest contributions with averagely 4.5% in mass of fine particulates and can be considered as the tracer of biomass burnings. Methyloxylated phenols from lignin degradation also had high concentrations in PM2.5, and contained approximately equal amounts of guaiacyl and syringyl compounds. 13-Sitostrol also made up relatively a large fraction of PMz5 compared with the other sterols （0.18%-0.63% of the total fine particle mass）. Normal alkanes, PAHs, fatty acids, as well as normal alkanols had relatively lower concentrations compared with the compounds mentioned above. Carbon preference index （CPI） of normal alkanes and alkanoic acids showed characteristics of biogenic fuel burnings. Burning status significantly influenced the formations of EC and PAHs. The differences between the emission profiles of straw and wood combustions were displayed by the fingerprint compounds, which may be used to identify the contributions between wood and straw burnings in source apportionment researches.     

室内多环芳烃污染源的化学组成特征研究

运用环境舱模拟源排放的方法采集了烹调油烟与环境烟草烟雾的样本,对18种PAHs进行了定量分析.比较了不同食用油与不同品牌香烟产生PAHs组成特征的差异,初步建立了2类室内PAHs来源的化学成分谱.结果表明:烹调油烟中3环以下的PAHs为主体,Fluo,Pyr和Flu相对含量较为稳定;香烟烟雾以3～4环组分为主体,Flu,Phe,InP和BaA较为稳定,Cor含量较烹调油烟而言显著增加.2类源的ρ(BaA)/ρ(Chy),ρ(BeP)/ρ(BaP)与ρ(InP)/ρ(BghiP)稳定且存在显著差异,可以用来解析室内PAHs以及PAHs暴露的来源.运用等效毒理学因子估算了其危害程度,结果表明:每100 g食用油在烹调过程(60 min)中释放产生PAHs的毒理学效应仅为吸烟过程中每g烟草所产生PAHs毒理效应的一半.      

Initial Adjustments Within a New River Channel: Interactions Between Fluvial Processes, Colonizing Vegetation, and Bank Profile Development

A conceptual model of the morphological development of the riparian margins of newly cut river channels is presented, suggesting early feedbacks between vegetation growth and bank form. To test the model, observations of long and cross profiles, bank sediment and seed deposition, and bank vegetation development were collected over the first 2 years of river flows through a reach of the River Cole, West Midlands, UK. The newly created channel had a sinuous planform and varying asymmetric trapezoidal cross section in sympathy with the planform. No imposed bedforms or bank reseeding were included in the design. Over the 2 years, development of bedforms was rapid, with bed sediment sorting and bank profile adjustment occurring more steadily and progressively. Six classes of bank profile were identified by the end of the study period, illustrating close associations with sediment aggradation, vegetation colonization, and growth patterns. Vegetation colonization of the banks was seeded predominantly from local sources during the summer and from hydrochory (transport by the river) during the winter. Colonizing vegetation on the riverbanks appeared to act as a significant propagule source by the second summer and as an increasingly important roughness element, trapping both propagules and sediment, within the second year and providing early feedback into bank evolution. As a result, the time required for riparian margin development in the conceptual model was found to be considerably longer than observed in the study river. In addition, the role of surface wash/bank failure in modifying the bank profile and transporting seeds onto the upper bank face during the first year of bank development was found to be important in initiating rapid bank vegetation colonization and surface stabilization. This set of processes had not been incorporated in the initial conceptual model. In relation to channel restoration, this research illustrates that in small temperate rivers of modest energy the provision of an initial, sinuous corridor is sufficient to induce rapid development of fluvial features and vegetation cover without the need to construct bed forms or to seed the banks.     

油田含油污泥深度调剖技术研究

针对目前油田联合站中含油污泥处理难的问题,提出了利用含油污泥开展深度调剖技术,通过对含油污泥组分和颗粒粒径分布测试分析,研制出合适的含油污泥深度调剖剂,室内评价结果表明:该调剖剂抗剪切能力强,热稳定性好,适用于80℃以下油藏,可提高驱油效率31.8%,不仅提高了注水开发效果,而且为解决油田含油污泥污染环境问题提供了一个途径。     

地空导弹发射飞行可靠度试验剖面生成方法

本研究在明确地空导弹武器装备寿命剖面、任务剖面的基础上,利用已经收集到的19发导弹的冲击、振动遥测数据和6发导弹的弹上温度遥测数据以及已经掌握的大量地面温度、电应力数据,进行数据分析与归纳,生成地空导弹环境剖面,并根据我国现有试验条件,将其转化为可靠性试验剖面。     

Design and Testing of a Turbulence Probe for Harsh Flows

The force of wind on the ground created by turbulent eddies is commonly used to describe the horizontal flux of material during wind erosion. Here we present the Murdoch Turbulence Probe, an instrument for use in both clean and eroding flows which uses pressure differences to measure the three components of wind velocity. Correlation techniques calculate the forces near the ground and turbulence statistics in nearly real time, including turbulent velocity fluctuations from less than 0.1 Hz to 200 Hz, mean flow velocities, Reynolds stresses as well as the integral length and time scales. In the portable wind-tunnel used by Agriculture Western Australia, turbulence statistics were recorded over stable surfaces and in blowing sand from the initiation of erosion up to the time the sand supply was exhausted. Estimates of the friction velocity derived from the turbulence probe were compared with estimates obtained from the wind speed profile measured with a rake of pitot and static tubes. The Murdoch Turbulence Probe appears to work well in sandblasting conditions. Relative turbulence intensities ranged from 0.11 to 0.2 and are in close agreement with values in the literature. The ratio of the turbulence to the friction velocity (3 to 3.2) is at the high end of the reported range. The Reynolds stress measurements agree closely with predictions of the threshold friction velocities of the sand and estimates from the wind speed profile with a von Kármán constant of about 0.3, lower than the commonly accepted value of 0.4. We suggest that the wind-tunnel profile represents the `outer layer' of the boundary-layer that may best be described by a `Wake Law' or `Defect Law'. At about 54 mm above the surface, the friction velocity decreases from 0.64 m/s to 0.39 m/s and the mean velocity increases from 9.6 m/s to 11.6 m/s as the supply of sand is depleted. In addition to the friction velocity, other scales may be necessary to characterise the overriding effect of the wind and in extending wind-tunnel results to the field.