A comparison of hydrocarbons emission from engine running 85# gasoline and M-100 methanol fuel

Increasing global interest in methanoi fuel has led us to investigate the exhaust emissionsof its engine. Analysis of its inorganic and organic emissions. such as CO. NO_x and hydrocarbons(total HC) have been widely reported. This paper presents an analysis of more than 20 kinds ofhydrocarbons in the emissions obtained from a spark-ignition Shanghai car running 85^# gasoline anda comparison with emission from a Santana test car running M-100 methanol fuel. A set ofenrichment method has also been described. Test results show that at the current stage of methanolengine development the concentration of individual hydrocarbon including some poisonous substancesis lower than those of normal gasoline engine.     

活性污泥外循环SBR系统循环污泥释磷能力研究

本试验以HAc作为厌氧释磷的碳源有机物，以SBR系统外循环污泥作为研究对象，探索外循环活性污泥的厌氧释磷能力和获取高浓度富磷污水的途径，试验表明：厌氧过程中聚磷菌吸收HAc和释放PO4^3 的分子比为1：1。即吸收2．06mgHAc-COD将诱导1mgP释放，单位时段比污泥的平均释磷速率Vp=6.54.t^0.76，理想的厌氧时间为60－180min，减少循环污泥释磷系统的反应容积可以提高富磷污水磷酸盐的浓度。     

我国城市污泥中醚类和卤代烃类有机污染物的初步研究

应用GC／MS联机检测技术对我国大陆和香港共11个城市污泥中4种醚类和4种卤代烃类化合物进行分析。结果表明，醚类化合物的总含量在0－7．743mg/kg之间，以双（2－氯异丙基）醚为主，主要分布在兰州污泥和广州污泥中；卤代烃类化合物的总含量在0．007－3．237mg/kg之间，以六氯环戊二烯为主，主要分布在兰州污泥、佛山污泥和沙田（香港）污泥中。污泥中醚类和卤代烃类化合物的种类及其含量与污水来源、污水处理方式、污泥类型、化合物的结构和理化性质等因素有关。     

HA-SBR法在制药废水中的应用

介绍SBR法在制药废水中的应用及工艺流程.通过处理COD从3600mg/l降到130mg/l.COD总去除率达到96%,出水可以达标排放.     

城市污水厂污泥堆肥中试实验研究

城市污水厂污泥由于产生量大且成分复杂，如何对它进行稳定化、无害化处理已越来越受到人们的关注。本研究基于好氧发酵仓式堆肥系统，研究了城市污泥处理过程中温度、含水率、pH、有机质、水溶性有机碳、总氮和发芽指数等指标参数的变化规律。研究结果表明：当物抖初始含水率控制在65％左右时，在强制通风量112．5m^3／12hr，搅拌频率30min/24hr的工艺条件下，堆肥过程可以实现顺利升温并在55℃以上维持3天，满足杀灭致病茵要求的条件；14天反应用期结束时，物抖含水率、水溶性有机碳和有机质含量显著降低，堆肥产品腐熟，卫生学指标达到了美国EPA污泥产品A类标准；得列的污泥产品成为性质优良的土壤质量调节荆。     

三价砷和五价砷对活性污泥几种酶活性的影响

应用静态试验,研究了As(Ⅲ),As(Ⅴ)对活性污泥脱氢酶活性、脲酶活性、蛋白酶活性的影响。其结果:抑制10%脱氢酶、脲酶、蛋白酶活性的As(Ⅲ)浓度分别为10.0mg/gMLSS,13.4mg/gMLSS,2.6mg/gMLSS;As(Ⅴ)的浓度则分别为552.6mg/gMLSS,464.4mg/gMLSS,193.7mg/gMLSS。As(Ⅲ)对活性污泥的毒性比As(Ⅴ)平均大53倍。     

Insights into the mechanism of the deterioration of mainstream partial nitritation/anammox under low residual ammonium

Residual ammonium is a critical parameter affecting the stability of mainstream partial nitritation/anammox (PN/A), but the underlying mechanism remains unclear. In this study, mainstream PN/A was established and operated with progressively decreasing residual ammonium. PN/A deteriorated as the residual ammonium decreased to below 5 mg/L, and this was paralleled by a significant loss in anammox activity in situ and an increasing nitrite oxidation rate. Further analysis revealed that the low-ammonium condition directly decreased anammox activity in situ via two distinct mechanisms. First, anammox bacteria were located in the inner layer of the granular sludge, and thus were disadvantageous when competing for ammonium with ammonium-oxidizing bacteria (AOB) in the outer layer. Second, the complete ammonia oxidizer (comammox) was enriched at low residual ammonium concentrations because of its high ammonium affinity. Both AOB and comammox presented kinetic advantages over anammox bacteria. At high residual ammonium concentrations, nitrite-oxidizing bacteria (NOB) were effectively suppressed, even when their maximum activity was high due to competition for nitrite with anammox bacteria. At low residual ammonium concentrations, the decrease in anammox activity in situ led to an increase in nitrite availability for nitrite oxidation, facilitating the activation of NOB despite the dissolved oxygen limitation (0.15–0.35 mg/L) for NOB persisting throughout the operation. Therefore, the deterioration of mainstream PN/A at low residual ammonium was primarily triggered by a decline in anammox activity in situ. This study provides novel insights into the optimized design of mainstream PN/As in engineering applications.     

城市污水高效低耗生物脱氮工艺研究

采用活性污泥与生物膜法相结合工艺处理城市生活污水，可以高效去除污水中的有机物和NH4^ -N。研究结果表明：水力停留时间为7．5h、回流比为1．5、无外加碳源时，COD的去除率大于90％，NH4^ -N的去除率大于99％；平均出水COD小于40mg／L，NH4^ -N小于1mg／L，TN的去除率60％左右；反硝化过程的适宜C／N为4～5。     

Recovery of heavy metals from electroplating sludge and stainless steel pickle waste liquid by ammonia leaching method

１　ＩｎｔｒｏｄｕｃｔｉｏｎＥｌｅｃｔｒｏｐｌａｔｉｎｇｓｌｕｄｇｅ，ｃｏｎｔａｉｎｉｎｇＣｕ，Ｎｉ，Ｚｎ，Ｃｒ，Ｆｅ，ｅｔｃ．，ｉｓｈａｒｍｆｕｌｗａｓｔｅｍａｔｅｒｉａｌｐｒｏｄｕｃｅｄｂｙｇａｌｖａｎｉｚａｔｉｏｎｉｎｄｕｓｔｒｙ．Ｔｈｅｒｅｉｓｓｔｉｌｌｎｏｅｆｆｅｃｔｉｖｅｍｅｔｈｏｄｔｏｒｅｃｏｖｅｒｒｅｓｏｕｒｃｅａｎｄｃｏｎｔｒｏｌｐｏｌｌｕｔｉｏｎｂｏｔｈａｔｈｏｍｅａｎｄａｂｒｏａｄ．Ｔｈｅｍｅｔａｌｓｄｉｓｃａｒｄｅｄｂｙｇａｌｖａｎｉｚａｔｉｏｎｉｎｄｕｓｔｒｙａｍｏｕｎ…     

电镀重金属污泥的处理及综合利用现状

简要综述了目前工重金属污泥近几年的处理及综合利用状况，包括固化，填海等方法，其中重点介绍了铁氧化体法固化电镀污泥重离子的湿法、干法工艺流程，以及用污泥生成的铁氧体为原料，可生产颜料、油漆和磁性探伤粉等较高档产品。