Treatment of wastewater from red and tropical fruit wine production by zeolite anaerobic fluidized bed reactor

A study of the anaerobic treatment of wastewaters derived from red (RWWW) and tropical fruit wine (TFWWW) production was carried out in four laboratory-scale fluidized bed reactors with natural zeolite as bacterial support. These reactors operated at mesophilic temperature (35°C). Reactors R1 and R2 contained Chilean natural zeolite, while reactors R3 and R4 used Cuban natural zeolite as microorganism support. In addition, reactors R1 and R3 processed RWWW, while reactors R2 and R4 used TFWWW as substrate. The biomass concentration attached to zeolites in the four reactors studied was found to be in the range of 44–46 g volatile solids (VS)/L after 90 days of operation time. Both types of zeolites can be used indistinctly in the fluidized bed reactors achieving more than 80%–86% chemical oxygen demand (COD) removals for organic loading rates (OLR) of up to at least 20 g COD/L d. pH values remained within the optimal range for anaerobic microorganisms for OLR values of up to 20 and 22 g COD/L d for RWWW and TFWWW, respectively. Toxicity and inhibition levels were observed at an OLR of 20 g COD/L d in reactors R1 and R3 while processing RWWW, whereas the aforementioned inhibitory phenomena were not observed at an OLR of 24 g COD/L d in R2 and R4, treating TFWWW as a consequence of the lower phenolic compound content present in this substrate. The volatile fatty acid (VFA) levels were always lower in reactors processing TFWWW (R2 and R4) and these values (< 400 mg/L, as acetic acid) were lower than the suggested limits for digester failure. The specific methanogenic activity (SMA) was twice as high in reactors R2 and R4 than in R1 and R3 after 120 days of operation when all reactors operated at an OLR of 20 g COD/L d.     

Removal of tetrabromobisphenol A by conventional activated sludge, submerged membrane and membrane aerated biofilm reactors

The goal of this study was to compare removal efficiencies of tetrabromobisphenol A (TBBPA) using typical wastewater treatment technologies, and to identify the most significant mechanisms of removal. Two types of municipal wastewater reactors were studied: a full-scale conventional activated sludge (CAS) reactor with tertiary treatment; and three pilot-scale membrane bioreactors (MBRs) having different sludge retention times (SRTs). All four reactors were fed the same influent. A third reactor type, a membrane aerated biofilm reactor (MABR) was fed tap water, ammonia, and TBBPA. TBBPA in municipal influent ranged from 1 to 41 ng L⁻¹ (n = 10). The CAS effluent had an average TBBPA concentration of 0.7 ± 1.3 ng L⁻¹ (n = 3). Effluent concentrations from the MBRs were an average of 6 ± 6 ng L⁻¹ TBBPA (n = 26). Significant TBBPA removal was observed in the MABR throughout the 5 week of study (p ? 0.05). Removal of TBBPA from wastewater treatment was found to be due to a combination of adsorption and biological degradation. Based on experimental results, nitrification is likely a key process therein. No significant relationship between removal of TBBPA and SRT was identified (p ? 0.05).     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

常温条件下2种厌氧折流板反应器处理淀粉废水的启动实验

为了研究厌氧折流板反应器在常温下的启动情况,在22.5～30.2℃条件下,对不加填料的5隔室厌氧折流板反应器和加填料的4隔室复合式厌氧折流板反应器同步进行了启动实验。实验用水为高浓度淀粉废水,两反应器采用相同的启动策略,即梯度增加进水COD浓度与降低水力停留时间相结合的方式。两反应器有效容积均为47.8 L,启动初始负荷为0.6 kg COD/(m3.d),逐渐增加到10 kg COD/(m3.d)。实验表明,经过6个阶段87 d的运行,反应器启动完成,并成功培养出颗粒污泥,两反应器对COD的去除率都能达到85%以上。在启动过程中两反应器对COD的去除效率相近。     

外循环式UASB反应器处理高浓度酒精废水

利用改进型上流式厌氧污泥床反应器在中温条件下处理高浓度酒精废水,研究反应器的启动影响因素及颗粒污泥形成过程,分析反应器运行特性。在容积负荷为10.39 kg COD/(m3.d),COD去除率达90.2%,VFA在300 mg/L以下,平均产气率为0.328 m3/kg COD,取得最佳的运行效果,为高浓度酒精废水的处理应用提供科学依据。     

曝气生物流化床处理高氨氮粪便污水

应用好氧曝气生物流化床反应器处理动车集便器粪便污水,研究反应器同步硝化反硝化脱氮及去除COD效能,以及DO对处理效能的影响,通过镜检观察反应器内微生物特性,探究反应器同步硝化反硝化脱氮机理。结果表明,反应器维持DO在2.5 mg/L左右时,对粪便污水中氨氮、TN和COD的去除率分别达99.8%、84.1%和95.5%,在好氧曝气生物流化床反应器中,实现同步硝化反硝化脱氮并去除有机物。分析认为,反硝化脱氮主要发生在生物膜内的厌氧微环境,反硝化反应主要由厌氧反硝化菌完成,曝气生物流化床反应器同步硝化反硝化脱氮机理主要从微环境理论解释。     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。     

复合生物膜-活性污泥反应器同步脱氮除磷

通过实验研究比较了复合生物膜-活性污泥反应器(HY)和传统活性污泥反应器(AS)的脱氮除磷效果。结果表明,在水力停留时间(HRT)16 h、污泥龄12～15 d、水温19～21℃、pH 6.3～7.8的条件下,复合生物反应器比活性污泥反应器运行更稳定,未发生污泥膨胀。在相同运行条件下,复合生物反应器对COD、TN和TP的去除率分别为95%、91%和98%,而活性污泥反应器对COD、TN和TP的去除率分别为85%、84%和90%。稳定工况下复合生物反应器的比硝化、比反硝化速率,比吸磷、比释磷速率均高于活性污泥反应器,且微生物相更加丰富。通过建立16S rDNA克隆文库发现生物膜和活性污泥的微生物群落结构均具有高度多样性,但生物膜微生物的微生物相比活性污泥更复杂。     

好氧颗粒污泥同时脱氮除磷技术研究

采用序批式活性污泥法(SBR)处理新疆油田公司准东石油基地污水,作为生物膜的一种特殊形式,介绍了该工艺的优点,在适宜的运行条件下进行实验。讨论了好氧颗粒污泥脱氮以及除磷的过程,分析了该工艺对氮、磷的去除率及好氧颗粒污泥在好氧、缺氧条件下的吸磷情况,当进水氨氮、磷和乙酸碳浓度分别为38.2 mg/L、27.7 mg/L和134.6 mg/L,MLSS和MLVSS分别为7.0 mg/L、6.4 mg/L时,氨氮、总无机氮、磷、乙酸碳的平均去除率分别达到98.8%、90.2%、98.9%、97.2%.     

连续流反应器中培养好氧颗粒污泥的运行效能研究

在连续流完全混合反应器(CSTR)中,采用不同进水方式,以乙酸钠作为碳源配制的人工配水作为原水,对好氧颗粒污泥的运行效能进行了试验研究。研究表明,采用不同进水方式运行的2个反应器在颗粒污泥出现后,运行效能差别不大;好氧颗粒污泥反应器运行高效稳定,在水力停留时间为1.5h、COD容积负荷为1.0kg/(m3·d)的条件下,对COD、TP、NH4+-N和TN的去除率分别为90%、85%、95%和60%,并具有明显的脱氮除磷效果;反应器中存在同步硝化反硝化现象。