复合生物膜-活性污泥反应器同步脱氮除磷

通过实验研究比较了复合生物膜-活性污泥反应器(HY)和传统活性污泥反应器(AS)的脱氮除磷效果。结果表明,在水力停留时间(HRT)16 h、污泥龄12～15 d、水温19～21℃、pH 6.3～7.8的条件下,复合生物反应器比活性污泥反应器运行更稳定,未发生污泥膨胀。在相同运行条件下,复合生物反应器对COD、TN和TP的去除率分别为95%、91%和98%,而活性污泥反应器对COD、TN和TP的去除率分别为85%、84%和90%。稳定工况下复合生物反应器的比硝化、比反硝化速率,比吸磷、比释磷速率均高于活性污泥反应器,且微生物相更加丰富。通过建立16S rDNA克隆文库发现生物膜和活性污泥的微生物群落结构均具有高度多样性,但生物膜微生物的微生物相比活性污泥更复杂。     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。     

曝气生物流化床处理高氨氮粪便污水

应用好氧曝气生物流化床反应器处理动车集便器粪便污水,研究反应器同步硝化反硝化脱氮及去除COD效能,以及DO对处理效能的影响,通过镜检观察反应器内微生物特性,探究反应器同步硝化反硝化脱氮机理。结果表明,反应器维持DO在2.5 mg/L左右时,对粪便污水中氨氮、TN和COD的去除率分别达99.8%、84.1%和95.5%,在好氧曝气生物流化床反应器中,实现同步硝化反硝化脱氮并去除有机物。分析认为,反硝化脱氮主要发生在生物膜内的厌氧微环境,反硝化反应主要由厌氧反硝化菌完成,曝气生物流化床反应器同步硝化反硝化脱氮机理主要从微环境理论解释。     

ABR处理硫酸盐有机废水的BP神经网络建模

通过厌氧折流板反应器(ABR)处理硫酸盐有机废水的实验数据对BP神经网络进行训练,建立了ABR处理硫酸盐有机废水的BPNN模型,通过测试对比,找出了较优训练函数为traingda,较优训练次数为1 900.利用分割连接权值法(PCW)对影响出水SO42-和COD的主要因素进行分析,结果显示进水COD、SO42-、pH、COD/SO42-和HRT对出水SO42-和COD均产生一定影响,其中进水pH对出水SO42-和COD的影响最大,相对重要性(RI)指数分别为30.79％和23.44％;并通过样本试验数据分别建立了对SO42-和COD去除率的限制因子仿真模型,为预测硫酸盐有机废水的厌氧处理过程提供指导.     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水,考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时,COD去除率约为87%,出水COD在2500mg/L以下,出水挥发性脂肪酸（VFA）浓度为4~6mmol/L,最佳容积负荷为15.0kg/（m3·d）;采用SBR处理UASB出水,当容积负荷为1.5kg/（m3·d）时,出水COD在200mg/L以下,COD去除率在83%以上,ρ（NH₃-N）在5mg/L以下,TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷,加入量为5mL/L,处理后废水TP为4~6mg/L。处理后废水的COD,ρ（NH₃-N）,TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

循环式超声强化光催化降解双酚A

设计了一种循环式超声强化光催化反应器,以TiO2作为光催化剂,研究了超声功率、TiO2加入量、循环液流速和空气流量对双酚A(BPA)降解效果的影响。实验结果表明:超声与光催化过程在循环式超声强化光催化反应器中实现了较好的协同效应;在初始BPA质量浓度为20.0mg/L、超声功率为600W、TiO2加入量为7g/L、循环液流速为4.05×10-2m/s、空气流量为200mL/min的条件下,反应150min后,BPA降解率可达90.5%,溶液中剩余BPA质量浓度仅为1.8mg/L,反应240min后TOC去除率可达84.5%。     

好氧-缺氧-闲置运行模式处理生活污水

在3个序批式反应器中,利用好氧-缺氧-闲置的运行模式处理实际生活污水,比较了不同曝气时间（2、3和4h）条件下的处理效果,结果表明,在R2（2 h）反应器中成功实现了单级好氧除磷和内聚物驱动的短程硝化反硝化。采用此反应器运行模式,对实际生活污水进行长期处理,反应器的COD、TN和TP的平均去除率分别为85.29%、74.09%和87.97%。本研究表明,在好氧-缺氧-闲置的运行模式下处理生活污水,能成功地实现单级好氧除磷与内聚物驱动的短程硝化反硝化的结合,并且在长期运行的过程中,能稳定地取得较好的脱氮、除磷效率。     

碳酸锶生产中"三废"综合利用研究

介绍了碳还原法生产碳酸锶过程中"三废"的主要成分;提出了用克劳斯燃烧法和吸收氧化法生产硫磺,用直接合成法和4级联合吸收法生产硫脲综合利用废气的途径;提出了2种治理废水方案,不仅达到脱硫、脱氮、降解有机物目的,而且还可得到硫磺、碳酸氢氨副产品;探讨了锶渣在砖、水泥的生产及公路工程建设中应用的可行性.     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

Dairy washwater treatment using a horizontal flow biofilm system

In Ireland, dairy farmyard washwater commonly comprises farmyard run-off and dairy parlour washings. Land-spreading is the most widely used method for treating this wastewater. However, this method can be labour intensive and can cause, in some cases, the degradation of surface and ground waters, mainly due to nitrogen contamination. In this study, a horizontal flow biofilm reactor (HFBR) with step-feed was constructed and tested in the laboratory, to remove organic carbon and nitrogen from a agricultural strength synthetic washwater (SWW). The HFBR had an average top plan surface area (TPSA) of 0.1002 m(2) and consisted of a stack of 45 polystyrene horizontal sheets--15 sheets embedded with 25 mm deep frustums above 30 sheets with 10 mm deep frustums. The frustums acted as miniature reservoirs. The sheets were alternately offset to allow the wastewater to flow horizontally along each sheet and vertically from sheet to sheet down through the reactor. Biofilms developed on the sheets and treated the wastewater. During the 212-d study, the total hydraulic loading rate based on the TPSA of the sheets was 35 l m(-2) d(-1). SWW was pumped for 10 min each hour, in a step feed arrangement at a rate of 23.33 l m(-2) d(-1) on to the top sheet during Phases 1 and 2, and 11.67 l m(-2) d(-1) onto Sheet 16 during Phase 1 (days 1-92) and onto Sheet 30 during Phase 2 (days 93-212). The substrate loading rate during Phases 1 and 2 was 94.8 g total chemical oxygen demand (COD) m(-2) d(-1) and 10.5 g total nitrogen (TN) m(-2) d(-1), based on the TPSA. At steady state in Phase 2, the unit achieved excellent carbon removal of 99.7% 5-day biochemical oxygen demand (BOD(5)) and 96.7% total COD, equivalent to TPSA removal rates of 67.5 g BOD(5)m(-2)d(-1) and 91.7 g COD m(-2) d(-1). The nitrogen removal percentages were 98.3% total ammonium-nitrogen (NH(4)-N(t)) and 72.8% TN, which equated to TPSA removal rates of 4.8 g NH(4)-N(t) m(-2) d(-1) and 7.6g TN m(-2) d(-1). No sloughing of solids or clogging of media occurred during the study. The unit was simple to construct and operate, with little maintenance.