碱激发胶凝材料及其固化Pb~(2+)的试验研究

对碱激胶凝材料(碱-偏高岭土、碱-矿渣和碱-粉煤灰)与水-水泥体系固化Pb2+进行了试验研究,其中水-水泥体系为对比样.结果表明:对于相同稠度的碱激发胶凝材料,即使Pb2+含量达到2.4%,除了碱-粉煤灰的抗压强度略低外,其他都达到30 MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子(Pb2+)浸出浓度,其规律性与其NH4+交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性.     

氮掺杂氧化钛的简易制备及可见光催化活性的研究

为开发对可见光响应的催化剂,以尿素为氮掺杂剂,采用简易溶胶-凝胶法制备氮掺杂氧化钛,并以2,4-DCP的降解检验其光催化活性。XRD、BET、XPS和UV-Vis漫反射光谱分析表明,随着氮/钛原子比（N/Ti)的增大,各催化剂晶粒尺寸减小,比表面积增大,锐钛矿相向金红石相的转变得到抑制,除0#样品出现金红石相外,其他催化剂均只出现锐钛矿相;掺入催化剂的N位于晶格O位点和晶格间隙,替代N和间隙N掺杂使催化剂的光吸收发生明显的红移。荧光光谱分析表明,当N/Ti在0～6范围内增加时,反应体系中·OH自由基的产生速率增加,当N/Ti增大至8时,速率则下降。相似的规律也表现在氮掺杂量对光催化活性的影响。适量氮掺杂能增强氧化钛的可见光催化活性,该改性催化剂可用于有机污染物的太阳光激催化降解。     

应用CALINE4模式估算机动车排放污染物的浓度——以济南市主干道为例

随着经济的快速发展,机动车排气污染已成为我国城市空气污染的重要来源,而且在一定时段,机动车排气污染已成为空气污染最主要的污染源之一。以济南市经十路为例,采用实地调查的方法,得出各时段的车流量,选用大气环评助手EIAA中的CALINE4模式对机动车尾气中的主要污染物CO、NOx、THC的排放浓度进行估算,得出3种污染物CO、NOx、THC最大值均出现在7:00—8:00之间,最小值均出现在12:00-13:00之间,排放强度由大到小为:CO、THC、NOx。     

镰刀菌HJ01对对氯苯酚的降解特性

采用实验室分离的一株镰刀菌HJ01,以对氯苯酚(4-CP)为降解底物,以蔗糖为外加碳源,考察了蔗糖质量浓度、降解温度、初始pH对4-CP降解效果的影响,初步探讨了镰刀菌HJ01对4-CP的降解动力学和降解机理.实验结果表明:该菌株能以4-CP为惟一碳源和能源生长;在外加蔗糖为碳源,蔗糖质量浓度为3 g/L、降解温度为30℃、初始pH为8的条件下,50 mg/L4-CP能在6 d内被完全降解.以4-CP为惟一碳源和外加蔗糖下的降解动力学分别符合Haldane模型和一级动力学方程.     

5—(4—磺酸基苯偶氮)8—(2,4—二硝基苯氨基)喹啉测定食品中铜的研究应用

在弱碱性介质中 ,5— (4—磺酸基苯偶氮 ) 8— (2 ,4—二硝基苯氨基 )喹啉 (SPDNPAQ)与铜反应生成 2∶ 1紫红色络合物 ,体系 λmax=56 0 nm,ε=1.2 3× 10 5L· mol-1· cm-1。铜含量在 0～ 0 .4 mg/ L内符合比耳定律 ,方法用于一些生物样品和水样中铜的测定。     

Competition between phenanthrene, chrysene, and 2,5-dichlorobiphenyl for high-energy adsorption sites in a sediment

We determined the maximum amounts of added phenanthrene, chrysene, and 2,5-dichlorobiphenyl sorbed onto high-energy adsorption sites in a sediment on bi-solute experiments. The bi-solute pairs were phenanthrene/chrysene and phenanthrene/2,5-dichlorobiphenyl. On the bi-solute sorption experiments, one solute was introduced and equilibrated with sediment prior to addition of the second solute. The values for the maximum amounts adsorbed onto high-energy sites revealed that, after equilibration of the first solute, still some high-energy sites could be occupied by the second solute. Phenanthrene, chrysene, and 2,5-dichlorobiphenyl seem to share about 30% of the accessible high-energy adsorption sites in the sediment employed.     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

Influence of Na2S on the degradation kinetics of CCl4 in the presence of very pure iron

This paper presents the results of kinetic studies to investigate the effect of FeS film formation on the degradation rate of CCl(4) by 99.99% pure metallic iron. The film was formed by submersing metallic iron grains in an oxygen free HCO(3)(-)/CO(3)(2-) electrolyte solution. When the grains had reached a quasi steady-state value of the corrosion potential, Na(2)S((aq)) was injected. Upon injection, a microm thick poorly crystalline FeS film formed immediately on the iron surface. Over time, the iron became strongly corroded and both the FeS film and the metallic iron grains began to crack leading to exposure of bare metallic iron to the solution. The effect of the surface film on the degradation rate of CCl(4) was investigated following four periods of aging, 1, 10, 30, and 60 days. Relative to the controls, the 1-day sulfide-aged iron showed a substantial decrease in rate of degradation of CCl(4.) However, over time, the rate of degradation increased and surpassed the degradation rate obtained in the controls. It has been proposed that CCl(4) is reduced to HCCl(3) by metallic iron by electron transfer. The FeS film is substantially less conducting than the bulk iron metal or non-stoichiometric magnetite and from the results of this study, greatly decreases the rate of CCl(4) degradation relative to iron that has not been exposed to Na(2)S. However, continued aging of the FeS film results in breakdown and stress-induced cracking of the film, followed by dissolution and cracking of the iron itself. The cracking of the bulk iron is believed to be a consequence of hydrogen embrittlement, which is promoted by sulfide. The increase in CCl(4) degradation rate, as the FeS films age, suggests that the process of hydrogen cracking increases the surface area available for charge transfer.     

Co3O4/介孔分子筛催化剂对苯催化完全氧化的研究

分别以介孔分子筛MCM-41、MCM-48、SBA-15为载体,采用等体积浸渍法制备了氧化钴/介孔分子筛催化剂,利用N₂吸附、X射线衍射、程序升温还原等技术对催化剂进行了表征,考察了Co₃O₄的负载量及载体的孔结构对催化剂完全催化氧化苯的性能的影响。结果表明,Co₃O₄的负载量为20%时,催化剂的催化活性最好;载体的孔径和催化剂的可还原性能是影响催化活性的主要因素,催化剂活性顺序为Co₃O₄ /SBA-15> Co₃O₄ /MCM41> Co₃O₄ /MCM-48。     

2,2’,4,4’-和3,3’,4,4’-四氯联苯(TCB)对小白鼠体外受精的影响(英文)

采用体外受精技术评价环境污染物 2 ,2’ ,4,4’ 和 3,3’ ,4,4’ 四氯联苯对小白鼠卵母细胞受精能力和 2 细胞胚胎发育的毒性作用 .实验结果表明 :ρ(PCB) =0 .1,1.0 ,10 .0mg/mL的 2 ,2’ ,4,4’ 和 3,3’ ,4,4’ 四氯联苯均显著降低小白鼠卵母细胞的受精能力 ;ρ(PCB) =1.0 ,10 .0mg/mL的 2 ,2’ ,4,4’ 和 3,3’ ,4,4’ 四氯联苯使卵母细胞的退化率和 2 细胞的畸形率显著增加 ;两种四氯联苯对小白鼠卵母细胞体外受精能力、退化率和 2 细胞胚胎的畸形率无统计差异 .表 2参 2 5