催化湿式氧化处理造纸废水的研究

以过渡金属氧化物CuO为活性组分,采用催化湿式氧化法处理造纸废水,考察Cu负载量、催化剂用量、反应温度对废水COD去除率的影响。结果表明:固定氧气分压在2.5MPa和反应时间3h,催化剂用量为3g,Cu负载量为4%,反应温度为220℃,500mL浓度为3250mg/L造纸废水的COD去除率为90%,色度去除率为89%,pH值由9.6变为7.8。另外,对催化剂进行再生处理和稳定性测试。结果表明:450℃下活化3h,在上述相同反应条件下,对原废水的COD去除率降低为88%,重复使用9次后对废水的COD去除率仍能保持在85%左右。     

污水生物处理过程中的同步硝化反硝化研究概况

在好氧生物氧化过程中通过控制反应器内 DO浓度、C/N比、污泥负荷的条件下 ,观察到较明显的同步硝化反硝化现象 ,通过控制反应条件 ,可使硝化、反硝化速率都得以同步提高。     

猪场废水厌氧氨氧化脱氮的短程硝化反硝化预处理研究

在常温(13～20℃)、不调节pH的条件下,采用短程硝化反硝化预处理低C/N（2左右）猪场废水,考察了反硝化与亚硝化过程,并以经过短程硝化反硝化预处理的猪场废水为进水,分析了厌氧氨氧化的脱氮效果.结果表明,采用短程硝化反硝化预处理低C/N猪场废水,可以达到去除部分COD、部分脱氮、控制出水氨氮和亚硝态氮浓度之比在1∶1左右、pH在7.5～8.0左右的目的,为厌氧氨氧化创造了进水条件,全程COD和总氮平均去除率分别为64.3%和49.1%;经过短程硝化反硝化预处理的猪场废水,其厌氧氨氧化脱氮效果稳定,氨氮、亚硝态氮、总氮的平均去除率分别为91.8%、99.3%、84.1%.     

Applicability of LIVE/DEAD BacLight stain with glutaraldehyde fixation for the measurement of bacterial abundance and viability in rainwater

Rainwater contains substantial bacteria and rain is an efficient pathway for the dissemination of bacteria from the atmosphere to land and water surfaces.However,quantitative information on rainwater bacteria is very limited due to the lack of a reliable method.In this study,the epifluorescence microscopy enumeration with the LIVE/DEAD BacLight Bacterial Viability Kit stain was verified to quantify the abundance of viable and non-viable bacterial cells in rainwater,with the 4',6-diamidino-2-phenylindole(DAPI) stain for the reference of total cell counts.Results showed that the total counts of bacterial cells by LIVE/DEAD BacLight staining were consistent with those by DAPI staining,and the average detection efficiency was(109 ± 29)%.The ratio of cell count with glutaraldehyde fixation to that without fixation was(106 ± 5)%on average.The bacterial concentration in negative control was usually an order of magnitude lower than that in rainwater samples.However,in case of small precipitation,the abundance in negative control could be more than that in rainwater samples.These results indicate that the enumeration with LIVE/DEAD BacLight bacterial viability assay coupled with glutaraldehyde fixation and careful negative control investigation is an approach applicable to the measurement of the concentration and viability of bacterial cells in rainwater.     

UV/H_2O_2对氯消毒副产物TCM、DCBM的去除影响因素研究

针对UV/H_2O_2对氯化消毒副产物三氯甲烷(TCM)和一溴二氯甲烷(DCBM)的去除效果及影响因素进行研究,结果表明UV/H_2O_2方法对TCM和DCBM去除效果的影响因素有过氧化氢(H_2O_2)投加量、紫外光照强度、反应p H值和反应物初始浓度。通过不同的反应条件得出:H_2O_2在一定投加量变化范围(10~35 mmol/L)内,随投加量的增加,TCM和DCBM的去除率均呈先上升后下降趋势,H_2O_2最佳投加量分别为25,20 mmol/L;增大紫外光照(UV)强度,TCM和DCBM的去除率均显著提高;随初始p H值的增大,去除率均呈先上升后下降趋势,p H值为7.0时,去除率达到最佳;TCM和DCBM反应初始浓度分别为150,160μg/L时,其去除率最高,在有效时间内去除率分别为95.88%、92.56%。     

Pd-MnO2 nanoparticles/TiO2 nanotube arrays (NTAs) photo-electrodes photo-catalytic properties and their ability of degrading Rhodamine B under visible light

Pd-MnO_2/TiO_2 nanotube arrays(NTAs) photo-electrodes were successfully fabricated via anodization and electro deposition subsequently; the obtained Pd-MnO_2/TiO_2 NTAs photo electrodes were analyzed by scanning electron microscopy(SEM), X-ray diffraction(XRD) and characterized accordingly. Moreover, the light harvesting and absorption properties were investigated via ultraviolet–visible diffuse reflectance spectrum(DRS); photo degradation efficiency was investigated via analyzing the photo catalytic degradation of Rhodamine B under visible illumination(xenon light). The performed analyses illustrated that Pd-MnO_2 codoped particles were successfully deposited onto the surface of the TiO_2 nanotube arrays;DRS results showed significant improvement in visible light absorption which was between400 and 700 nm. Finally, the photo catalytic degradation efficiency results of the designated organic pollutant(Rhodamine B) illustrated a superior photocatalytic(PC) efficiency of approximately 95% compared to the bare TiO_2 NTAs, which only exhibited a photo catalytic degradation efficiency of approximately 61%, thus it indicated the significant enhancement of the light absorption properties of fabricated photo electrodes and their yield of UOH radicals.     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

顶空／气相色谱-质谱法测定水中四乙基铅

建立了顶空,气相色谱-质谱法测定水中四乙基铅方法。水样中的四乙基铅直接顶空进样,质谱分析。实验结果表明,在0．10-5．00μg几范围内线性关系良好,方法检出限为0．02μg/L,得到了良好的分离效果与较高的灵敏度和精密度。方法简便快捷,能达到《生活饮用水卫生规范》（GB/T5750．8—2006）中规定的要求。     

新版GB/T28001的主要变化

介绍了GB／T28001—2001标准修订的背景及修订原则,解读了新版标准的主要变化。