Integrated analysis of the effects of agricultural management on nitrogen fluxes at landscape scale

The integrated modelling system INITIATOR was applied to a landscape in the northern part of the Netherlands to assess current nitrogen fluxes to air and water and the impact of various agricultural measures on these fluxes, using spatially explicit input data on animal numbers, land use, agricultural management, meteorology and soil. Average model results on NH₃ deposition and N concentrations in surface water appear to be comparable to observations, but the deviation can be large at local scale, despite the use of high resolution data. Evaluated measures include: air scrubbers reducing NH₃ emissions from poultry and pig housing systems, low protein feeding, reduced fertilizer amounts and low-emission stables for cattle. Low protein feeding and restrictive fertilizer application had the largest effect on both N inputs and N losses, resulting in N deposition reductions on Natura 2000 sites of 10% and 12%, respectively.     

ZnO/LixNi1-xO光催化降解甲基橙的研究

采用溶胶凝胶法制备LixNi1-xO和ZnO粉体,利用球磨法制备ZnO/LixNi1-xO复合粉体,以紫外光为光源,通过降解甲基橙,研究了锂掺杂及n-p复合对氧化镍的光催化性能影响。结果表明：当投放量为0.1 g/L,x≤0.075（摩尔分数）的锂掺杂氧化镍均比未掺杂氧化镍的光催化活性高。当锂掺杂摩尔分数为0.025,投放量为0.4 g/L时锂掺杂氧化镍的光催化活性最佳,甲基橙最高降解率达到93.1%。当ZnO/Li0.025Ni0.975O在质量比为1∶1,投放量为0.2 g/L时光催化活性最佳,甲基橙最高降解率达到98.1%。     

粉煤灰基层状金属氧化物对水中活性红X-3B的吸附

以粉煤灰(FA)为原料,采用共沉淀法制备了层状双金属氢氧化物(LDH)和层状金属氧化物(LMO,也称LDO),并采用XRD和BET技术进行了表征。比较了FA、LDH、LMO对活性红X-3B染料(X-3B)的吸附效果;考察了LMO吸附X-3B的影响因素,并探讨了吸附机理。XRD表征结果表明,LMO在吸附X-3B后重新恢复LDH层状结构。BET表征结果表明,LMO的比表面积大于LDH。吸附实验结果表明,3种吸附剂对X-3B吸附效果的优劣顺序为:LMOLDHFA;在初始X-3B质量浓度为50 mg/L、LMO投加量为2.0 g/L、吸附温度为25℃、吸附pH为7、吸附时间为30 min的条件下,X-3B去除率可达98.1%;LMO对X-3B的吸附符合Langmuir等温吸附方程,饱和吸附量为129.53 mg/g,且吸附过程可用准二级动力学方程描述。     

Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

金属冶炼进口物料的固体废物鉴别方法

建立了金属冶炼进口物料的固体废物鉴别方法,并利用该方法对海关查扣的3种金属冶炼进口物料进行了固体废物鉴别。鉴别结果显示:物料1、2和3的自然属性分别为砷含量超标铜精矿、锰阳极泥、回转窑氧化锌,产生来源分别为有害物质超标的产品、污染控制设施产生的物质、有意识加工的目标产物;物料1和2属于我国禁止进口的固体废物,物料3不属于固体废物。本文建立的固体废物鉴别方法可行,可为金属冶炼进口物料的固体废物鉴别和监管提供参考。     

废水中环氧丙烷降解菌株的培育及降解效果研究

本文通过对污泥的驯化筛选得到4株降解环氧丙烷废水的优势茵A、B、C、D,并对降解效果最好的一个菌株A进行研究,得到其最佳降解条件是温度为30℃、pH为5、废水浓度为20％、反应时间为9h,其COD去除率可达到63．24％左右。     

基于回归分析的火灾发生气象因子的研究

利用二元回归分析法,对火灾发生次数、空气湿度、风速进行回归分析并检验,得出了火灾发生次数、空气湿度、风速三者之间的显著线性关系。     

二元联合作用藻红外测试方法——以重金属为例

为检验二元联合作用藻红外测试方法的可行性,用Cu~(2+)、Fe3+、Mn~(2+)、Al3+、Cr3+、Hg~(2+)、Cd~(2+)、Pb~(2+)、Zn~(2+)进行了二元联合作用测试实验。结果显示:联合药液的参照浓度与单药液的参照浓度比为0.5:0.25的有15组二元组合,为2.0:1.0的有10组二元组合,为1.0:0.5的有11组二元组合;在9种重金属的36组二元联合作用测试结果中出现拮抗作用、相加作用、协同作用,表明联合作用类型表现出多样性;14组拮抗作用中单组的再现性为50%~100%、多组的再现性的出现率为93%、单组的重现性为67%~100%、多组的重现性的出现率为100%,21组相加作用中单组的再现性为50%~100%、多组的再现性的出现率为86%、单组的重现性为67%~100%、多组的重现性的出现率为100%,1组协同作用重现性67%;36组联合作用测试结果的再现性为50%~100%、再现性的出现率为86%,重现性为67%~100%、重现性的出现率为100%。上述分析可知,9种重金属的36种二元联合作用测试结果具有较好的多样性、再现性、重现性,表明测试条件、藻温测试方法、三指标评价法能够保证藻响应温差和藻响应药品评价结果的质量,参照浓度分析方法、联合作用评价方法能够控制联合作用分析结果的质量;藻响应的有毒有害物都存在敏感浓度,用参照浓度分析方法可分析出藻响应有毒有害物的参照浓度。因此,藻红外测试技术可以用于测试重金属、农药、有机药品、抗生素等的二元联合作用。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

Formation of PCDD/Fs from oxidation of 2-monochlorophenol over an Fe2O3/silica surface

The role of iron in surface-mediated formation of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from 2-chlorophenol (2-MCP) was investigated over the temperature range of 200-550 °C under oxidative conditions. In order to compare and contrast with previous work on copper and ferric oxide-mediated pyrolysis of 2-MCP, identical reaction conditions were maintained (50 ppm 2-MCP, model fly-ash particles containing 5% Fe₂O₃ on silica). Observed products included dibenzo-p-dioxin (DD), 1-monochlorodibenzo-p-dioxin (1-MCDD), dibenzofuran (DF), 4,6-dichlorodibenzofuran (4,6-DCDF), 2,4- and 2,6-dichlorophenol, 2,4,6-trichlorophenol, quinone, catechol, chloro-o-quinone, chlorocatechol and polychlorinated benzenes. Yields of DD and 1-MCDD were 2 and 5 times higher than under pyolysis conditions, respectively. Although 4,6-DCDF was the major PCDD/F product formed with a yield that was 2.5× greater than under pyrolysis, the yield of non-chlorinated DF, which was the dominant PCDD/F product under pyrolysis, decreased by a factor of 3. Furthermore, the ∼2× higher yield of PCDDs under oxidative conditions resulted in a PCDD to PCDF ratio of 0.75 compared to a relatively low ratio of 0.39 previously observed under pyrolytic conditions.