Pd/C气体扩散电极用于电生成H2O2降解苯酚的研究

采用自制的Pd/C气体扩散阴极和Ti/IrO2/RuO2阳极,在无隔膜电解槽中对苯酚模拟废水降解效果及机制进行了研究,采用电子自旋共振法(ESR)对电解体系中产生的羟自由基(·OH)进行了检测.结果表明,在Pd/C气体扩散体系中掺杂Pd催化剂可以促进H2 O2的生成(H2 O2的稳定浓度是7.5 mg/L),有利于·OH的产生.经电化学氧化处理120 min后,苯酚和COD的去除率分别达到97.2%和50%,表明在电催化氧化过程中苯酚被氧化生成了大量低分子量中间产物.废水的BOD5/COD值达到0.73是处理前的9.1倍,苯酚废水的可生化降解性通过电化学氧化处理后显著提高.在该电化学体系中苯酚的降解是在阳极直接、间接氧化及阴极产生的H2 O2、·OH的氧化共同作用下完成的.通过对紫外扫描光谱图的分析推断出苯酚在电解过程中有醌类物质生成;由GC-MS检测到了邻苯二酚、对苯二酚、苯醌等芳香族化合物和己二酸、顺丁烯二酸、反丁烯二酸、丁二酸、丙二酸、乙二酸等短链羧酸,据此提出了苯酚降解的可能历程.     

Fe2O3 particles as superior catalysts for low temperature selective catalytic reduction of NO with NH3

Fe203 particle catalysts were experimentally studied in the low temperature selective catalytic reduction （SCR） of NO with NH3. The effects of reaction temperature, oxygen concentration, [NH3]/[NO] molar ratio and residence time on SCR activity were studied. It was found that Fe203 catalysts had high activity for the SCR of NO with NH3 in a broad temperature range of 150-270℃, and more than 95% NO conversion was obtained at 180℃ when the molar ratio [NH3]/[NO] = 1, the residence time was 0.48 seconds and 02 volume fraction was 3%. In addition, the effect of SO2 on SCR catalytic activity was also investigated at the temperature of 180℃. The results showed that deactivation of the Fe2O3 particles occurred due to the presence of SO2 and the NO conversion decreased from 99.2% to 58% in 240 min, since SO2 gradually decreased the catalytic activity of the catalysts. In addition, X-ray diffraction, Thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the fresh and deactivated Fe2O3 catalysts. The results showed that the deactivation caused by SO2 was due to the formation of metal sulfates and ammonium sulfates on the catalyst surface during the de-NO reaction, which could cause pore plugging and result in suppression of the catalytic activity.     

制备条件对低温NH_3-SCR脱硝催化剂Mn-Ce/TiO_2结构与性能的影响

采用溶胶凝胶法制备了Mn-Ce/TiO2催化剂,以NH3为还原剂,通过程序升温反应考察其选择性催化还原NO的催化性能.同时,着重探讨了焙烧温度、焙烧时间、活性物质负载量及Mn、Ce负载比例对催化剂结构和性能的影响,并用BET、XRD等对催化剂进行了表征.结果表明,活性组分负载量由0增至20%时,NO转化率随着负载量的增加而提高,当(Mn+Ce)质量分数为20%,催化剂活性最高,此后随着活性组分负载量的增加,NO转化率明显下降;Mn与Ce的负载比例为0.85∶0.15时,催化剂比表面积最大,为112.31m2·g-1;焙烧温度500℃时催化剂晶相均为TiO2锐钛矿型结构,焙烧温度升高至600℃,催化剂晶相为TiO2锐钛矿型和金红石型混合结构,且催化剂比表面积急剧减小;焙烧时间对催化剂晶相结构影响不大,焙烧时间为5h时,Mn-Ce/TiO2的脱硝性能最好.     

氧化镁基催化剂及脱硝性能研究

为控制燃烧烟气中NOx的污染,对共混合方法制备的氧化镁基催化剂进行烟气直接催化分解法脱硝实验研究,分析模拟烟气脱硝塔内温度及床层高度及氧气浓度、NO浓度和空速对脱硝效率的影响.研究表明:氧化镁基催化剂可以采用直接催化分解法对烟气脱硝,脱硝率85%～95%,氧化镁基催化吸附剂组成为氧化镁、固化剂、添加剂;脱硝的床层高度4～5 cm,脱硝反应温度130～170℃,烟气空速2 500～3 000 h-1;研究推测出氧化镁基催化剂存在活性缺陷,并对脱硝机理进行了初步分析.     

Mn2O3/γ-Al2O3在超临界水氧化中催化活性的研究

采用浸渍法制备了Mn2O3/γ-Al2O3催化剂,在超临界水中催化氧化降解1,5-萘二磺酸,探索了催化剂Mn2O3活性组分负载量、催化剂空速和反应溶液pH对Mn2O3/γ-Al2O3催化剂活性的影响。结果表明：Mn2O3/γ-Al2O3的催化活性在一定范围内随Mn2O3活性组分负载量的增加而提高;在一定范围内,Mn2O3/γ-Al2O3空速越小,模拟废水的COD去除率越高;Mn2O3/γ-Al2O3催化活性在反应溶液呈酸性情况下比碱性时高。     

金属掺杂对纳米管TiO_2光催化去除水中罗丹明B的影响

采用水热合成法,将Fe(NO3)3·9H2O、ZnCl2和AgNO3对纳米管TiO2进行掺杂,使用TEM、XRD、XPS、比表面积分析仪及UV-visDRS对掺杂后的纳米管TiO2进行表征并考察其光催化氧化去除罗丹明B的效果,从而优选最佳掺杂金属。结果表明,煅烧温度可影响纳米管TiO2锐钛矿相相对含量、比表面积及禁带宽度,进而影响其光催化活性。此外,掺杂金属离子的种类不同,纳米管TiO2的光催化活性也受到影响。500℃煅烧非掺杂纳米管TiO2的存在下,光催化氧化罗丹明B的去除率为98.72%。向纳米管TiO2中掺杂Fe3+、Zn2+及Ag+时,光催化氧化罗丹明B的效果得到提高。对以上三种掺杂金属离子而言,掺杂量为1.0%(原子百分含量)的催化剂的最佳煅烧温度为550℃。其中,Fe3+掺杂纳米管TiO2光催化活性最高,50min内光催化氧化罗丹明B的去除率可达99.0%。     

非均相高效催化剂在餐厨废油转化生物柴油中的应用

近年来,非均相催化剂在酯化和转酯化催化制备生物柴油中备受关注。综述了固体碱、固体酸、固定化酶等非均相高效催化剂在生物柴油制备中的研究进展,并展望了新型非均相催化剂在餐厨废油转化制备生物柴油的应用前景。     

不同SAPO分子筛负载MnOx催化剂的低温NH3-SCR性能研究

以磷酸硅铝分子筛SAPO-5、SAPO~(-1)1和SAPO-34为载体,采用乙醇分散法制备了用于低温氨选择性还原(NH_3-SCR)NO_x的分子筛负载MnO_x催化剂.活性测试结果显示,3种分子筛催化剂均展现出优良的NH_3-SCR活性,但三者在低温区间的SCR活性存在较明显差异,其SCR活性顺序如下:MnO_x/SAPO-34MnO_x/SAPO-5MnO_x/SAPO~(-1)1.借助XRD、N2吸附-脱附、XPS、H2-TPR、NH_3-TPD、NH_3FT-IR等技术对催化剂的表面活性物种及表面酸性等进行表征分析,结果表明,MnO_x主要以无定型状态分散于载体上,负载后载体的比表面积和孔体积均有所下降.XPS和H2-TPR分析证实,不同分子筛载体上MnO_x的表面浓度与氧化态明显不同.NH_3-TPD和NH_3FT-IR分析揭示了催化剂表面均存在Bronsted酸位和Lewis酸位,其中,Lewis酸性位对低温SCR反应起着关键作用.研究表明,催化剂的催化性能会因载体不同而存在差异,高Mn4+表面浓度和丰富的Lewis酸性位对催化剂在低温区间实现优良的催化活性尤为重要.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

湿式氧化技术研究进展

湿式氧化法是一种有效的处理有毒、有害、高浓度有机废水的水处理技术。本文综述了湿式氧化技术的机理、动力学、主要技术指标及参数，同时对湿式氧化催化剂的组成、分类、特点、目前的应用等情况做了介绍。指出催化剂的加入能够极大的提高湿式氧化技术对有机物的降解效率，高效、稳定的催化剂的研制是降低湿式氧化反应温度与压力的有效手段。催化湿式氧化技术是较有发展前途的水处理技术。