水泥土搅拌桩的桩径分析

针对搅拌桩施工会引起周围土体的位移及产生很高的超静孔隙水压力的工程现象,首先分析了搅拌桩施工中固化剂的注入体积与膨胀压力、成桩直径的关系。结果表明,5%~10%的注入浆液的体积可以对周围土体产生1.8~3.0倍不排水抗剪强度的膨胀压力,成桩直径比搅拌叶片的名义直径大5%~10%。然后量测室内模型桩、现场搅拌桩的成桩直径,分析了注入浆液的体积与成桩直径的关系。结果表明,对于深度不太大的水泥土搅拌桩,有约45%的注入体积会通过上浮隆起的土体损失掉;大约5%的注入体积通过劈裂裂缝渗入到周围土体中;大约50%的注入体积会转化为成桩直径,使桩体膨胀5%~10%,即实测桩径比搅拌叶片的名义直径大5%~10%。     

30MHz-1000MHz显示器辐射骚扰测试及其不确定度评定

本文以显示器辐射骚扰测试为例对10米半电波暗室的辐射骚扰试验进行不确定度评定。并与相应标准进行比较，确认该辐射测试系统的测量结果是可信的。     

应用地磁场的弹体飞行姿态测量方法研究

常规弹药的简易制导化是常规弹药改造的一个重要途径,是目前研究的热点之一,可以在低成本下大大提高常规弹药的精度,弹道修正弹是其中的一个重要发展方向,而弹体姿态实时测量是其中的一项关键技术。介绍了弹体姿态测量中基于地磁场的姿态测量方法,将其分为组合姿态测量和单矢量测量,并对测量方法做出了分析,阐述了应用地磁场的姿态测量的重要意义。     

环境地表γ计量率、工频电磁场和射频电场监测实验结果对比分析研究

本文通过两实验室针对环境地表γ计量率、工频电磁场和射频电场仪器对比实验,并对结果进行了统计检验。分析结果表明,两者监测数据无显著差异。     

Assessing field vulnerability to phosphorus loss in Beijing agricultural area using Revised Field Phosphorus Ranking Scheme

Guanting Reservoir,one of the drinking water supply sources of Beijing,suffers from water eutrophication.It is mainly supplied by Guishui River.Thus,to investigate the reasons of phosphorus(P)loss and improve the P management strategies in Guishui River watershed are important for the safety of drinking water in this region.In this study,a Revised Field P Ranking Scheme(PRS)was developed to reflect the field vulnerability of P loss at the field scale based on the Field PRS.In this new scheme,six factors are included, and each one was assigned a relative weight and a determination method.The affecting factors were classified into transport factors and source factors,and,the standards of environmental quality on surface water and soil erosion classification and degradation of the China were used in this scheme.By the new scheme,thirty-four fields in the Guishui River were categorized as"low","medium"or"high"potential for P loss into the runoff.The results showed that the P loss risks of orchard and vegetable fields were higher than that of corn and soybean fields.The source factors were the main factors to affect P loss from the study area.In the study area,controlling P input and improving P usage efficiency are critical to decrease P loss.Based on the results,it was suggested that more attention should be paid on the fields of vegetable and orchard since they have extremely high usage rate of P and high soil test of E Compared with P surplus by field measurements,the Revised Field PRS was more suitable for reflecting the characteristics of fields,and had higher potential capacity to identify critical source areas of P loss than PRS.     

Warm forming die design,Part II: Parting surface temperature response characterization of a novel thermal finite element modeling code

The majority of the research activities in the area of warm forming are concentrated on demonstrating or simulating the improved formability associated with forming lightweight materials such as aluminum alloys at elevated temperatures. However, the ability to design the proper thermal management system within the forming tool is a critical aspect to delivering this technology as a viable, stable production alternative to traditional stamping. This work begins to address the thermal stability issues of this process by examining the impact of process cycle time on the parting surface temperature response. Cycle times of 10, 15, 30, and 300 s were evaluated using a reciprocating surface and a self-heated experimental block of 1020 steel fitted with resistance cartridge heaters. The presented results indicate that cycle time does not significantly impact the steady-state temperature response at the parting surface for a well-insulated die that has proper thermal management. Parting surface experimental results were compared to values obtained numerically and through the use of the novel thermal finite element analysis software PASSAGE/Forming^®.     

Low cost measurements of nitrogen and sulphur dry deposition velocities at a semi-alpine site: gradient measurements and a comparison with deposition model estimates

The conditional time averaged gradient method was used to measure air-surface exchange of nitrogen and sulphur compounds at a semi-alpine site in Southern Norway. Dry deposition velocities were then obtained from the bi-weekly concentration gradient measurements. Annual deposition velocities were found to be 1.4, 11.8 and 4.0 mm s(-1) for NH3, HNO3 and SO2, respectively, if all data were included, and to be 10.8, 11.8 and 13.0 mm s(-1), respectively, if only positive values were included. Measured deposition velocities were compared to two sets of values estimated from a big-leaf dry deposition module applying to two different land types (short grass and forbs, and tundra), driven by measured micrometeorological parameters. The deposition module gives reasonable values for this site throughout the year, but does not reproduce the large variability as shown in the measured data. No apparent seasonal variations were found from either measurements or module estimates due to the very low productivity of the studied area.     

Field and laboratory simulations of storm water pulses: behavioural avoidance by marine epifauna

Epifaunal communities associated with macroalgae were exposed to storm water pulses using a custom made irrigation system. Treatments included Millipore freshwater, freshwater spiked with trace metals and seawater controls to allow for the relative importance of freshwater inundation, trace metals and increased flow to be determined. Experimental pulses created conditions similar to those that occur following real storm water events. Brief storm water pulses reduced the abundance of amphipods and gastropods. Freshwater was the causative agent as there were no additional effects of trace metals on the assemblages. Laboratory assays indicated that neither direct nor latent mortality was likely following experimental pulses and that epifauna readily avoid storm water. Indirect effects upon epifauna through salinity-induced changes to algal habitats were not found in field recolonisation experiments. Results demonstrate the importance of examining the effects of pulsed contaminants under realistic exposure conditions and the need to consider ecologically relevant endpoints.     

水质总氮测定中的有关问题探讨

对总氮测定中的一系列影响因素,诸如实验用水,器皿的洗涤,实验室环境试剂的提纯、配制和保存,消解温度、压力和时间的控制,以及高氨氮水样中的总氮测定、总氮、总磷的同时测定和其他有关的问题,作了较为详细的探讨,并提出了相应的解决办法。     

智能家电的低待机功耗研究

从智能家电待机工作状态入手,分析电器产品中参与待机工作的各部分电路原理,提出降低潜在功耗设计思路和计算方法,从家电设计研发阶段对待机功耗进行控制,同时对待机功耗精确测量方法关键点进行解读以控制低功耗测试不确定度,有助于低待机功耗设计和测量的标准化和规范化。