固相萃取-气相色谱法测定水中硝基苯类有机污染物的方法研究

建立了固相萃取、毛细柱气相色谱-电子捕获检测器定量分析水中硝基苯类化合物的分析方法。通过对固相萃取柱的选择、固相萃取条件(样品溶液的pH值、上样速度、上样体积、洗脱液选择及配比)的优化,得出了最佳实验条件。穿透体积可达1.5L,回收率在80%~105%,最小检出浓度在0.00037~0.072μg/L之间,均大大低于GB13194-91的规定。相对标准偏差在0.7%~5.3%之间。该方法准确、简单,重现性好、回收率高,污染小。     

萃取-催化氧化光度法测定生物体中H2O2含量研究

提出萃取-催化氧化光度法测定生物体中H2O2含量的新方法.用稀土催化H2O2产生羟基自由基以氧化二苯基碳酰二肼,生成红色二苯基碳酰腙,其最大吸收波长为563.0nm;当二苯基碳酰二肼浓度一定时,△A563与H2O2含量呈量效关系.在0～30μmol/L H2O2 含量范围内,该法能简单、快速、精确地测定生物样品中H2O2实际含量.     

Fractionation of Cu, Pb and Zn in certified reference soils SRM 2710 and SRM 2711 using the optimized BCR sequential extraction procedure

Sequential extraction of metals from solid media is a common analytical tool used in environmental and exploration geochemistry. A number of procedures exist, but without harmonization and standardization, meaningful comparisons are tenuous without baseline data. A newly developed, standardized sequential extraction procedure (optimized BCR) was applied to two contaminated certified reference soils from Montana, US (SRM 2710 and SRM 2711) for Cu, Pb and Zn. Four operationally defined fractions were isolated, acid extractable, reducible, oxidizable, and residual (by aqua regia). Fraction-specific concentrations, percentages and recoveries for Cu, Pb and Zn were used to explore differences between the optimized BCR procedure and three other sequential extraction schemes with published data for SRM 2710 and 2711 (i.e. Tessier scheme, Geological Survey of Canada scheme and the original BCR scheme). Results indicate significant differences between the four schemes, even for schemes that are closely associated (i.e. the original and optimized BCR schemes). Order-of-magnitude fraction-specific concentration differences were observed, especially for Pb in the reducible fraction. Differences between schemes are worrisome because trends varied between metals, between fractions and between reference soils. These data reinforce the need for increased adoption of standardized sequential extraction procedures and further examination of different solid media.     

石油亚砜萃取巯基醋酸的研究

对石油亚砜(PSO)萃取巯基醋酸的条件和影响进行了实验研究,确定了石油亚砜通过氢键和巯基醋酸形成的萃合物的组成.为从废水中回收巯基醋酸以及石油硫醚的综合利用提供了依据.     

烧结砖生产中氟的逸出及钙基废渣固氟特性研究

砖坯烧制过程中，氟逸出的初始温度约为600℃，大部分氟在约800℃至砖坯发生明显烧结的温度内逸出，以CaO含量高的粘土原料制砖，氟逸出量相对较少。在此基础上，提出在制砖原料中添加适量钙基废渣抑制氟的逸出，并进行了详细的实验室和工业性试验；结果表明，在适宜添加量下，存氟率由约25％增至70％以下，且不影响砖制品质量。     

正己烷萃取—此外分光光度法测定矿井水中微量油

在进行矿井水中油类分析时，用正己烷作为萃取剂，以工作曲线代替标准曲线，从而使油平均回收率增加到96％以上。并在正己烷用量、水样预处理等测试参数选择上做了条件试验。     

Studies on the use of power ultrasound in solid–liquid myrobalan extraction process

Focus on eco-friendly processing techniques makes vegetable tanning a viable option in leather processing and establishes the subsequent need for the more efficient methods of extraction in tannin manufacture. Application of ultrasound has been tried in the extraction of tannins from myrobalan nuts in order to improve the extraction efficiency, to perform the extraction under milder process conditions and to reduce the process time. The influence of process parameters such as ultrasonic output power, time and temperature has been studied. Scale-up trials and the use of ultrasound in pulse mode have also been attempted. The results show that a three- to fivefold improvement is possible with ultrasonic output from 20 to 100 W. Extraction efficiency has been calculated from the maximum extractable materials from myrobalan nuts. Extraction efficiency is found to be 90% for ultrasound, 100 W without external heating as compared to 77% for control process at 70 °C for 4 h. Therefore, ultrasound could be employed even dispensing with provision for temperature controls. The use of ultrasound in pulse mode offered 70% extraction efficiency of continuous mode. Scale-up trials indicate that there exists an optimum ultrasonic output power depending on the amount of nuts used, to achieve better extraction efficiency. The effectiveness of ultrasonically extracted tannin solution has also been tested in the tanning process for its applicability. The degree of tanning efficacy has been assessed by shrinkage temperature measurement. The results indicate that ultrasonically extracted tannin solution is suitable for tanning process. Therefore, application of ultrasound in tannin extract manufacture is a viable option with added advantages.     

硫代氨基甲酸盐提取工业废水中的锌离子

本文主要探索了金属离子络合剂———硫代氨基甲酸盐的合成制备 ,并通过其对锌离子的络合作用 ,以达到脱除金属离子的目的 .实验表明 ,由吗啡啉合成制得的硫代氨基甲酸盐 锌离子络合剂在酸性废水中 ,对锌离子具有良好的络合能力 .通过对废水中金属锌离子的脱除工艺条件的相应探索 ,发现在体系的pH =2～ 6范围内 ,硫代氨基甲酸盐对锌离子的脱除率均达99 %以上     

超临界水处理有机废物研究新进展

超临界水处理废物以通过添加氧化剂的超临界水氧化和不加氧化剂的超临界水萃取两种方式实现，超临界水氧化应用较多，与其它废物处理技术相比有显著优点。本文总结了超临界水氧化流程和反应机理，评述了添加剂，温度，压力及停留时间，催化剂等对超临界水氧化反应的影响，同时介绍了超临界水氧化和超临界水萃取的最新应用研究状况及尚需解决问题。     

北京市工业废水和城市污水中菊酯类农药残留分析

建立了基于18C固相萃取柱和气相色谱/电子捕获（GC/ECD）分析水体中环境激素类物质--菊酯类农药的分析方法,并对方法的回收率、灵敏度进行了评价,同时分析了北京市七类典型污染点源50个采样点位菊酯类农药的浓度,检出的菊酯类农药包括联苯菊酯、氰戊菊酯、氯氰菊酯和溴氰菊酯,其检出率都较低,低于22%.检出菊酯类农药的浓度范围是0.013～1.246μg/L.该方法对菊酯类农药的回收率达到67.7%～96.2%,检测限为0.010～0.015μg/L.溴氰菊酯在废水排放中的达标率为100%.