Adsorption characteristics of humic acid-immobilized amine modified polyacrylamide/bentonite composite for cationic dyes in aqueous solutions

Humic acid-immobilized amine modified polyacrylamide/bentonite composite (HA-Am-PAA-B) was prepared and used as an adsorbent for the adsorption of cationic dyes (Malachite Green (MG), Methylene Blue (MB) and Crystal Violet (CV)) from aqueous solutions. The polyacrylamide/bentonite composite (PAA-B) was prepared by intercalative polymerization of acrylamide with Nabentonite in the presence of N,N0-methylenebisacrylamide as a crosslinking agent and hexamethylenediammine as propagater. PAA-B was subsequently treated with ethylenediammine to increase its loading capacity for HA. The surface characterizations of the adsorbent were investigated. The adsorbent behaved like a cation exchanger and more than 99.0% removal of dyes was detected at pH range 6.0–8.0. The capacity of HA-Am-PAA-B was found to decrease in the following order: MG > MB > CV. The kinetic and isotherm data were interpreted by pseudo-second order rate equation and Freundlich isotherm model, respectively. Experiments were carried out using binary solute systems to assess the competitive adsorption phenomenon. The experimental isotherm data for each binary solute combination of MG, MB and CV were analyzed using Sheindrof-Rebhun-Sheintuch (SRS) (multicomponent Freundlich type) equation.     

Chitosan and chemically modified chitosan beads for acid dyes sorption

The capabilities of chitosan and chitosan-EGDE (ethylene glycol diglycidyl ether) beads for removing Acid Red 37 (AR 37) and Acid Blue 25 (AB 25) from aqueous solution were examined. Chitosan beads were cross-linked with EGDE to enhance its chemical resistance and mechanical strength. Experiments were performed as a function of pH, agitation period and concentration of AR 37 and AB 25. It was shown that the adsorption capacities of chitosan were comparatively higher than chitosan-EGDE for both acid dyes. This is mainly because cross-linking using EGDE reduces the major adsorption sites -NH3+ on chitosan. Langmuir isotherm model showed best conformity compared to Freundlich and BET. The kinetic experimental data agreed very well to the pseudo second-order kinetic model. The desorption study revealed that after three cycles of adsorption and desorption by NaOH and HCl, both adsorbents retained their promising adsorption abilities. FT-IR analysis proved that the adsorption of acid dyes onto chitosan-based adsorbents was a physical adsorption. Results also showed that chitosan and chitosan-EGDE beads were favourable adsorbers and could be employed as low-cost alternatives for the removal of acid dyes in wastewater treatment.     

双酚A在厌氧污泥上吸附行为的研究

采用批式实验研究了低浓度的内分泌干扰物双酚A在厌氧污泥上的吸附行为.实验采用高温灭菌的方法对活性污泥灭活以减小污泥降解对吸附实验的影响.研究发现,厌氧污泥对 BPA 的吸附很快,15min的吸附量可达最大吸附量的89.1%. BPA的吸附等温线可以较好地用线性模型以及Freundlich模型来描述,其在温度为10-30℃之间的有机碳归一化分配系数在 665～878的范围内. MLSS对BPA的吸附去除率有较大的影响,随着MLSS的增加, BPA 吸附去除率增加.通过吸附热力学的研究可以推断, BPA 在厌氧污泥上的吸附过程以物理吸附为主,主要是一个分配过程.污泥解吸实验表明BPA在厌氧污泥上的吸附是部分可逆的.     

废啤酒酵母泥吸附活性黑31的机理研究

探讨了废啤酒酵母泥吸附水中活性黑31的平衡、动力学规律,利用傅里叶红外光谱技术分析了废啤酒酵母泥及活性黑31的吸附官能团间的相互作用.结果表明,废啤酒酵母泥对活性黑31的吸附容易进行;20min前吸附速度都较快,2h后吸附都达到平衡;吸附动力学符合准二级动力学模型.废啤酒酵母泥对活性黑31的吸附等温曲线符合Freund...     

软锰矿改性污泥活性炭对Cu~(2+)吸附特性的研究

文章对比研究了污泥活性炭(AC)和1%软锰矿改性的污泥活性炭(ACP)对溶液中Cu2+的吸附特性,考察了时间、pH值和吸附剂投加量等因素对吸附反应的影响。结果表明:室温下,180 min后Cu2+吸附达到平衡,pH=4.8时吸附效果最优;伪二阶动力学方程和Langmuir吸附等温方程能很好地拟合两种污泥活性炭的吸附反应。通过计算,室温下,改性前后的污泥活性炭Langmuir模型的饱和吸附量Qm分别是78.13 mg/g和94.34 mg/g。在初始浓度200 mg/L,pH=5,吸附剂投加量为2g/L时,1%软锰矿改性的污泥活性炭对Cu2+的最大吸附量为90.15 mg/g,比未改性时提高了23.33%。     

铀尾矿库渗漏地下含水层中六价铀的几种吸附反应运移模型对比

在铀尾矿地区,溶解态U(Ⅵ)渗漏到含水层中会对周围环境造成严重的威胁.使用反应运移软件PHT3D对U(Ⅵ)在含水层中的迁移和吸附过程进行模拟.结果表明,相比于不考虑吸附情形,考虑吸附的U(Ⅵ)反应迁移阻滞现象明显.线性和Langmuir吸附等温线模型在水动力条件复杂、地球化学条件多变时的模拟效果与表面络合模型相比较差,甚至有时得到与实际相反的结果,这说明了传统Kd吸附经验模型的局限性.由表面络合模型计算得出的分配系数Kd值是时空变化的,其更能反映实际中多变水化学条件下的吸附过程,适合描述复杂的不同水文地球化学条件.     

烷基多糖苷季铵盐改性粘土治理赤潮研究

研究了新型表面活性剂烷基多糖苷季铵盐在2种粘土高岭土和膨润土上的吸附行为,发现其在2种粘土上的吸附符合Langmuir吸附等温线,并且吸附速率很快,在1～2min之内就能够达到吸附平衡,经红外分析发现其可以对粘土进行有效改性.在此基础上,还研究了烷基多糖苷季铵盐对东海原甲藻、强壮前沟藻、锥状斯氏藻生长的影响以及2种有机改性粘土对赤潮藻的去除情况和絮凝动力学.结果表明,烷基多糖苷季铵盐用量分别为0～0.4 mg/L、0～0.5 mg/L、0～0.8 mg/L时,对上述3种藻的生长只是抑制作用;当浓度为0.6～1.2 mg/L、0.75～1.5 mg/L、1.2～2.4 mg/L时,就会阻碍上述3种藻的生长,并且3d之后能够使其几乎全部死亡.用其改性粘土后,在与原土相同的用量条件下可将对赤潮藻的去除率从20%左右提高到90%以上,大大降低了有效去除赤潮藻的粘土用量.其沉降动力学研究表明,粘土的种类、用量以及改性剂的用量都是影响体系沉降速率的重要因素,在实际应用中可以根据不同的情况而改变其中的某个因素以达到提高沉降速率的效果.     

改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附

通过批量实验研究了改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附特性.Langmuir和Freundlich吸附等温方程被用于分析吸附等温数据,准一级动力学模型、准二级动力学模型和颗粒扩散模型被用于吸附动力学实验数据分析.结果表明,改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附过程符合Langmuir和Freundlich吸附等温方程,最大吸附量达到71.43 mg·g^-1;颗粒扩散模型能够很好地描述改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附动力学过程,水溶液中染料的初始浓度、颗粒直径、颗粒量及搅拌速度对吸附速率均产生一定的影响.改性泥炭-树脂颗粒对水溶液中酸性橙Ⅱ的吸附作用主要发生在颗粒的外表面.     

氨氮在土壤中的吸附/解吸动力学行为的研究

文章主要研究氨氮在土壤中吸附/解吸动力学和热力学行为及其影响因素。通过对氨氮吸附/解吸动力学的研究发现,氨氮的吸附和解吸基本都符合一级反应动力学方程。通过对氨氮热力学的研究发现,氨氮的吸附等温式既不符合Langmuir,也不符合Freundlich。我们考察吸附剂大小、吸附剂含量、pH值、温度的因素对氨氮吸附等温线的影响,研究发现,粒度越小,pH值越大、温度越低,土壤对氨氮的吸附能力越强,而土壤和溶液的最佳配比还有待于进一步考察。此外,通过对温度的考察发现,土壤对氨氮的吸附属于物理吸附。     

含氟废水安全保障技术研究

许多行业产生的废水中都含有大量氟离子,电子元件生产、电镀和金属冶炼等行业排放的废水中都含有高浓度氟化物.而目前缺乏经济性好且适用性强的除氟方法,针对氟化物去除难度大、达标困难这一典型问题,采用不同的制备方法,制备了羟基氧化铁和两种铈基吸附剂,研究了吸附等温模型、吸附动力学以及pH对吸附的影响.结果表明:3种吸附剂在吸附...