阴角邻面火灾作用下L型钢管混凝土柱耐火极限研究

运用有限元软件ABAQUS计算L形带肋钢管混凝土柱阴角相邻两面受火全过程下的耐火极限,分析了阴角邻面受火方式下构件内部温度场和应力场的变化规律,在此基础上分析荷载比、宽厚比、计算长度、加劲肋纵向间距、荷载偏心率、荷载角等参数对耐火极限的影响规律。数据表明:荷载比、计算长度对构件耐火极限影响较大,随着荷载比和计算长度的增大,耐火极限基本呈线性下降;加劲肋间距对构件耐火性能影响较小;由于L形柱的特殊形式,偏心荷载对耐火极限的影响规律较复杂,荷载作用点偏向低温区可以提高耐火极限。     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。     

水性膨胀型防火涂料的现状和应用

钢结构是现代建筑工程中较普遍的结构形式之一,具备重量轻、机械性能好、可承受较大的荷载及制作和安装机械化程度高的特点。随着城市规模的发展,钢结构在我国建筑业具有非常广阔的应用前景。但由于其自身抗火能力差,在火灾高温作用下,其力学性能如屈服强度、弹性模量等会随温度升高而降低,一般在15min左右即丧失承重能力而垮塌,需采取保护措施使其温度不超过临界点才能在火灾中保持稳定性。涂敷钢结构防火涂料,施工简单、重量轻、耐火时间长且不受钢结构几何形状的制约,具有良好的经济性和实用性。随着环保意识的增强,国内外越来越多的建筑提倡绿色环保理念,参与三星或LEED认证体系的评级认证。水性膨胀型防火涂料凭借其优异的环保、施工安全和防火性能,开始逐渐受到众多业主和设计师的青睐。本文从防火原理、技术特点、防火领域的国内外认证、施工和质量管理的角度,浅谈水性膨胀型防火涂料的性能和发展现状,同时也讨论了目前防火涂料存在的一些问题。     

钢框架厂房火灾后的破坏形态

端部约束不同的构件在火灾中的破坏形态不同,研究整体结构构件在火灾中的破坏形态,可以为钢结构抗火研究与设计提供依据。某钢结构框架厂房发生火灾,大火历时3个多小时,火场最高温度达1000°C以上。火灾后,框架梁均有不同程度的破坏,钢梁端部下翼缘屈曲破坏较普遍;由于钢梁顶没有设置抗剪键,钢梁与顶部的混凝土现浇楼板脱开,火灾后残留有较大的挠屈变形;钢柱在火灾后未有明显的破坏现象,但有侧向变形产生。这些现象与实验室中标准试验的结果不同。     

约束高强度Q460钢柱抗火性能分析

为了研究高强度约束钢柱在火灾下的反应,根据高强度结构钢Q460在高温下的力学性能参数,建立了约束高强度钢柱受火分析模型,得到了高强度约束钢柱在火灾下的轴向位移、跨中挠度、最大应力以及临界温度。采用有限元分析对理论结果进行了验证,两者吻合很好。利用验证过的该文计算方法计算了2种荷栽比、长细比和约束刚度比条件下的高强钢柱的抗火性能;采用CECS200:2006的力学性能参数计算了约束普通钢柱的抗火性能。通过对高强钢和普通钢的抗火性能分析发现,轴向约束明显降低钢柱的临界温度,长细比、荷载比越大,临界温度越低;高强钢的抗火性能要优于普通钢。     

Technologically enhanced 210Pb and 210Po in iron and steel industry

Iron and steel manufacture has been ranked as the largest industrial source of environmental contamination in the USA; the wastes generated in their production processes contain heavy elements that can be a source of contamination, and natural radionuclides that can produce an occupational and/or public radiological impact. In this work the potential occupational effective dose rate (μSv/y) due to inhalation in four integrated steel-making factories from Egypt has been evaluated, by assuming a well defined scenario and with basis in the ²¹⁰Pb and ²¹⁰Po activity concentrations determined in ore and wastes collected in the aforementioned factories. Activity concentrations, in Bq/kg, of ²¹⁰Pb and ²¹⁰Po, and leachable Pb and Fe were measured using gamma-ray spectrometry based on HPGe detector, alpha particle spectrometry based on PIPS detector, and inductively coupled plasma-mass spectrometry (ICP-MS). Levels of ²¹⁰Pb and ²¹⁰Po in the range of <DL-4238 and 1-5660 Bq/kg, respectively, were found. According to the assumed scenarios, the occupational exposures by inhalation are much lower than the recommended annual effective dose limit, although the environmental impact due to waste storage and/or use should be considered based on case by case evaluation.     

阴极氧还原产电生物可渗透反应栅的研究Ⅰ. 不锈钢毛电极模拟反应器

提出利用阴极氧还原和阳极微生物产电作用的产电生物可渗透反应栅（CORE-PRB）方法用于被有机物污染的地下水的修复,并以不锈钢毛为电极建立模拟反应装置验证了CORE-PRB的技术概念。实验中考察了分别以蔗糖＋醋酸盐和不同浓度的污泥消化液为进水时的反应电流,并研究电极距离对反应电流的影响。由于氧还原阴极阳极反应能力的限制,随着与阴极室距离加大,模拟反应装置各阳极室的电流迅速减小。有机基质的可生化性对模拟反应器的总电流也有显著影响。     

废钢铁切割加工烟尘的治理

介绍了氧-乙炔火焰切割加工废钢铁产生的烟尘治理系统的设计和系统设备选型,重点介绍了烟尘捕集罩的设计和除尘器、电磁脉冲阀、风机的选型和PLC自动控制以及系统实际运行效果,为废钢铁加工企业治理污染提供一套简单、经济、实用的除尘系统作参考.     

钢铁企业工作场所煤气泄漏扩散规律的研究

以钢铁企业管网煤气泄漏为研究对象,以煤气泄漏扩散规律为研究主题,在确定煤气泄漏相似于浮力射流的基础上,建立煤气泄漏扩散的数学模型。采用CFD软件PHOENICS数值模拟气体泄漏过程的速度场及其浓度分布。在已有煤气泄漏检测系统的基础上,选择性实验模拟煤气泄漏浓度与扩散时间、扩散方向的变化。数值模拟和实验模拟表明,虽然两种方法所得结果存在一定差异,从定性分析角度而言,却能够反映工作场所煤气泄漏后在有限空间内运移扩散的一般规律。     

Advantages and risks of using steel slag in preparing composts from raw organic waste

It had been reported that iron and manganese oxides in steel slag enhanced the production of humic acid (HA) from low-molecular-weight compounds, such as phenolic acids, amino acids, and saccharides. In the present study, this function of steel slag was applied to the composting of raw organic wastes (ROWs). The degree of humification of HAs is an important factor in evaluating compost quality. Thus, HAs were extracted from the prepared composts and the humification parameters were determined, in terms of elemental compositions, acidic functional group contents, molecular weights, spectroscopic parameters from UV–vis absorption and ¹³C NMR spectra. The timing for adding steel slag affected the degree of humification of HAs in the composts. The weight average molecular weight of a HA when slag was added initially (29 kDa) was significantly higher than when slag was added after elevating the temperature of the compost pile (17–18 kDa). These results show that ROWs are decomposed to low-molecular-weight compounds after the pile temperature is elevated and the presence of slag enhances the polycondensation of these compounds to produce HAs with a higher degree of humification. Because the slag used in the present study contained several-tens ng g^?1 to several μg g^?1 of toxic elements (B, Cu, Cr, and Zn), leaching tests for these elements from the prepared composts were carried out. Levels for leaching boron from composts prepared by adding slag (0.2–0.4 mg L^?1) were obviously higher than the corresponding levels without slag (0.05 mg L^?1).