Development and application of LC–APCI–MS method for biomonitoring of animal and human exposure to imidacloprid

Imidacloprid (IMI) is a relatively new neuro-active neonicotinoid insecticide and nowadays one of the largest selling insecticides worldwide. In the present study a LC–APCI–MS based method was developed and validated for the quantification of imidacloprid and its main metabolite 6-chloronicotinic acid (6-CINA) in urine and hair specimens. The method was tested in biomonitoring of intentionally exposed animals and subsequently applied for biomonitoring of Cretan urban and rural population.     

Interpreting the relationship between pheromone component emission from commercial lures and captures of Helicoverpa zea (boddie) in bucket and cone traps

Abstract

Male corn earworm moths, Helicoverpa zea (Boddie), were captured in conical Texas pheromone traps (cone traps) and bucket traps baited with four different commercial lures manufactured by three different manufacturers. Because significant numbers were captured in bucket traps baited with some of the lures, and none with others, the volatile emissions from all of the lures were sampled and analyzed by gas Chromatographic methods. The numbers of males captured in two types of trap were compared with bait emissions in an endeavor to define a more effective lure for bucket traps. The lure from one manufacturer captured the same numbers of males in both trap types; one captured more in bucket traps than in cone traps, and another captured only a small number in bucket traps. The emission rate of all active compounds from each of the different lures was approximately linear for the duration of the assays. A gas‐liquid Chromatographic peak associated with a third compound, (Z)‐9‐tetradecenal, which reduces behavioral responses, was observed in the emissions from all lures evaluated. The effectiveness of the Hercon (Emmigsville, PA) lure in capturing males in both types of trap was associated with a lower emission of (Z)‐l 1‐hexadecenal, (Z)‐9‐hexadecenal and (Z)‐9‐tetradecenal than from the other lures.     

A-O工艺污泥疏水比率与污泥活性的关系

通过A-O工艺对印染废水的降解处理,研究了不同污泥活性下微生物疏水比率和COD去除率的变化规律.结果表明,污泥活性指标ATP浓度与微生物疏水性之间存在一定关系,并对COD去除率产生一定的影响.缺氧污泥的活性指标ATP浓度在0.38～0.77 mg/L范围时,污泥微生物的疏水性最好且疏水比率最高值为84％,COD的去除率最高,为70.01％;好氧污泥的活性指标ATP浓度在0.86～2.17 mg/L范围时,污泥微生物的疏水性最好,疏水比率最高值为75％,COD的去除率最高为96.2％.     

过硫酸钾去除水中的TCE

以地水中的氯代烃污染物三氯乙烯(TCE)为目标污染物,以过硫酸钾溶液为氧化剂,探讨了不同条件下过硫酸钾对TCE的去除效果。实验结果表明,在40℃,过硫酸钾初始浓度为2.43 g/L条件下,反应2 h后,TCE的去除率就可达到96.8%;过硫酸钾对TCE的去除符合一级反应动力学方程,速率常数(K)为1.3364 h-1,半衰期(t1/2)为0.51 h;过硫酸钾对TCE的去除速率在pH为中性附近时最大,其后无论pH升高或降低去除速率均减小;受温度和pH影响较明显,并且反应温度越高,受pH的影响越明显;随离子强度的增加而减小;反应活化能为119.6 kJ/mol;过硫酸钾溶于水生成过硫酸根离子(S2O28-),S2O28-会进一步生成硫酸根自由基(SO4-.),在碱性条件下,SO4-.与OH-反应会进一步生成羟基自由基(.OH)。过硫酸钾对于TCE的去除主要源自SO4-.和.OH的强氧化性。     

Oil Identification Based on a Goodness-of-Fit Metric Applied to Hydrocarbon Analysis Results

Assessment of environmental damage following accidental oil spills requires reliable oil identification methods. Results from hydrocarbon analyses of environmental samples are often difficult to interpret, because of the changes in oil composition (or weathering) that follows release into the environment, and because of confounding by hydrocarbons from other sources. To a first-order approximation, weathering proceeds according to simple first-order loss-rate (FOLR) kinetics for polycyclic aromatic hydrocarbons (PAH) based on molecular size. This relationship between relative weathering rate and molecular size can be exploited to infer the initial PAH composition of spilled oils, and this information can be combined with results for weathering-invariant analytes to substantially increase the precision and accuracy of hydrocarbon source recognition methods. The approach presented here evaluates a goodness-of-fit metric between the measured hydrocarbon composition of an environmental sample and a suspected source, after correcting for PAR weathering losses based on FOLR kinetics. Variability from analytical and sampling error may thus be accounted for, and source identifications can be expressed as objective probability statements. This approach is illustrated by application to four independent case studies.     

高效阿特拉津降解菌株DNS10降解条件优化

从长期施用阿特拉津的寒地黑土耕层(0～10 cm)土壤中筛选到一株能以除草剂阿特拉津为氮源生长的降解菌株,结合16S rRNA序列分析结果,将该菌株命名为Arthrobacter sp.DNS10。在接种量为108CFU/mL的条件下,菌株DNS10在24 h内对100 mg/L阿特拉津的降解率为99.41%。单因子实验结果表明,菌株DNS10适宜生长和降解的条件范围是:温度25～35℃,pH值5.0～8.0,培养液盐度0.1%～2%,对阿特拉津最大耐受浓度可达1 200 mg/L。正交实验法进一步表明,该菌株保持较好生长及降解能力的最优方案是温度30℃,pH值7.5,培养液盐度0.5%。影响其降解能力的环境因素的主次顺序依次是:温度>盐度>pH值。     

萃取净化电镀含镉废水

研究了二壬基萘磺酸(DNNSA)形成的微乳液从模拟含镉废水中萃取镉离子的工艺条件。分别考察了相体积比(O/A)、萃取时间、温度及萃取剂浓度对废水中镉离子萃取的影响。结果表明,萃取平衡时间为10 mim,降低温度及增加萃取剂浓度均有利于萃取。紫外光谱证实当DNNSA萃取镉时,所形成萃合物对萘环的结构无影响,且不会破坏微乳相的结构;分子荧光光谱表明镉离子对配体DNNSA有荧光猝灭作用。     

城市污水条件下ASBR厌氧氨氧化的启动与脱氮性能

采用ASBR在城市污水条件下进行厌氧氨氧化的启动与脱氮性能研究。实验接种好氧硝化污泥,在温度为(35±1)℃、HRT为24 h、pH为7.3～8.5的条件下经过130 d的培养,成功启动了厌氧氨氧化反应。实验结果表明,厌氧氨氧化反应稳定运行时,TN容积负荷平均为0.179 kg/(m3.d),NH4+-N、NO2--N和TN去除率分别达到了95.30%、91.30%和76.28%。启动期和稳定运行期NH4+-N、NO2--N去除量和NO3--N生成量的比值分别达到1∶1.54∶0.25和1∶1.27∶0.27;稳定运行期进出水pH差值由启动时的0.85下降到0.24。启动期反硝化和厌氧氨氧化反应同时存在而在稳定运行期厌氧氨氧化发展成为主导反应。MLSS和MLVSS/MLSS先减少后增加,反映了启动过程中硝化细菌、反硝化细菌的衰亡和厌氧氨氧化菌逐渐富集的过程,这与反应器的宏观运行效果相一致。     

羟基铝及复合改性蒙脱石对As(V)的去除性能

采用无机羟基铝及阳离子表面活性剂十六烷基三甲基溴化铵对天然蒙脱石进行无机及复合改性。在吸附过程中研究了反应时间、投加量和pH等变量对吸附性能的影响,同时进行吸附动力学及吸附等温线研究,吸附规律符合Langmuir等温方程式。采用X射线衍射、X射线荧光、傅里叶红外光谱等表征手段对未改性及改性蒙脱石进行性能表征。研究结果表明,羟基铝及复合改性蒙脱石对As(V)具有良好的吸附性能,在pH为4～10,初始砷浓度为2 mg/L,改性蒙脱石对As(V)的去除率接近99%。吸附机理主要为羟基铝表面络合吸附和静电吸附。     

利用废弃物衍生燃料的热化学处理法制富含氢气合成气

为了探讨利用热化学方式从城市垃圾中制取富含氢气合成气过程的要素影响,解析氢气发生特性及其与主要影响要素之间的关系。在分析了城市生活垃圾组分特性的基础上,将其加工成组分均一的废弃物衍生燃料(refuse de-rived fuel,RDF),并在700、800和900℃等3个温度条件下,分别开展了RDF的热解、气化及水蒸汽气化等实验。研究表明,RDF的加工不但可有效降低垃圾含水率,还可将垃圾热值提高近1倍。温度和添加水蒸汽是从RDF中制取富含氢气合成气过程中的关键影响要素。其中,温度对氢气生成起到至关重要的决定作用,温度的提高对促进H2浓度的提高有利,同时,在气化过程中添加水蒸汽,可有效促进CO和H2等有价气体组分生成。在900℃的高温水蒸汽气化处理过程中,可获得H2浓度最高为34.13%的合成气。另外,800℃热解过程所产生的合成气热值最高,达到14 509 kJ/Nm3。