蜂窝断面内循环三相生物流化床内流动状况的数值模拟

根据蜂窝断面内循环三相生物流化床内混合液的连续性方程、动量方程和能量方程,利用Fluent软件对反应器内的流动状况进行了数值模拟.采用Fluent的前处理软件Gambit完成流化床的三维模型,利用Fluent主程序解析计算,并利用后处理软件实现计算结果的显示.模拟计算结果获得了反应器内静压力、静压差的变化规律,得到了液体循环速度、气含率沿纵向及横断面的分布.     

污泥与高浓度有机废物厌氧消化反应中的产气量

研究了高温／中温两相厌氧消化反应器系用以同时处理污泥与不同高浓度有机废物时产气及产甲烷的变化特性。结果表明，气体及甲烷主要是在第二段的中温消化反应器内产生。当中温消化反应器的有机负荷ＶＳ为１．６５￣３．１０ｋｇ／ｍ＾３ｄ时，稳态条件下的平均产气量为１．９５８￣４．０２０ｍ＾３／ｄ，气体中甲烷的平均组成为６５％￣７３％，甲烷的比产率为０．３９７￣０．５１１ｍ＾３／ｋｇＶＳ。     

Microbial reduction of sulfate injected to gas condensate plumes in cold groundwater

Despite a rapid expansion over the past decade in the reliance on intrinsic bioremediation to remediate petroleum hydrocarbon plumes in groundwater, significant research gaps remain. Although it has been demonstrated that bacterial sulfate reduction can be a key electron accepting process in many petroleum plumes, little is known about the rate of this reduction process in plumes derived from crude oil and gas condensates at cold-climate sites (mean temperature <10 degrees C), and in complex hydrogeological settings such as silt/clay aquitards. In this field study, sulfate was injected into groundwater contaminated by gas condensate plumes at two petroleum sites in Alberta, Canada to enhance in-situ bioremediation. In both cases the groundwater near the water table had low temperature (6-9 degrees C). Monitoring data had provided strong evidence that bacterial sulfate reduction was a key terminal electron accepting process (TEAP) in the natural attenuation of dissolved hydrocarbons at these sites. At each site, water with approximately 2000 mg/L sulfate and a bromide tracer was injected into a low-sulfate zone within a condensate-contaminant plume. Monitoring data collected over several months yielded conservative estimates for sulfate reduction rates based on zero-order kinetics (4-6 mg/L per day) or first-order kinetics (0.003 and 0.01 day(-1)). These results favor the applicability of in-situ bioremediation techniques in this region, under natural conditions or with enhancement via sulfate injection.     

纳米刻蚀法制备氧化锰介孔材料及其降解高含盐废水中罗丹明B

为了有效去除高含盐废水中的有机染料污染物,利用有序介孔硅材料作为模板剂,通过硬模板法制备了新型锰系氧化物（MnO_x）介孔材料作为类Fenton催化剂.催化剂的结构表征结果表明,模板剂在锰前驱物溶液中浸渍和后续煅烧成型过程决定了氧化锰介孔材料的结构.浸渍-煅烧成型重复次数越多,MnO_x介孔材料中孔道结构的有序度和氧化锰的结晶度越好.浸渍-煅烧成型次数过少,MnO_x介孔材料中孔道呈现无序状态,比表面积较大但氧化锰结晶度不足;次数过多则形成更为致密的小孔径的孔道结构,从而使MnO_x介孔材料的比表面积减小.由于对罗丹明B（RhB）良好的选择性吸附能力和较多的Mn³⁺/Mn⁴⁺对,具有有序规则孔道的氧化锰介孔材料具有优异的类Fenton催化活性,对高含盐废水中RhB的5 h降解去除率最高可达90%左右.     

模板剂十二胺对胺改性HMS吸附CO2的影响

以正硅酸乙酯为硅源、十二胺为模板剂制备中孔硅HMS-1,采用焙烧和乙醇萃取的方法去除其模板剂,所得材料分别为HMS-2与HMS-3,并将四乙烯五胺（TEPA）与二乙醇胺（DEA）混合负载于3种材料上,采用X射线衍射（XRD）、傅里叶红外（FTIR）与氮气吸附实验对材料进行表征,研究改性前后的HMS对常压下低浓度CO₂的吸附性能及再生能力.XRD与FTIR结果表明,TEPA与DEA已被成功负载到HMS孔道内.氮气吸附实验表明,保留模板剂和胺基改性后,材料的孔容显著降低.20℃下,初始浓度为10%的CO₂在材料上的吸附量顺序为：MA-HMS-1（3.29mmol/g） > MA-HMS-3（2.7mmol/g） > HMS-1（1.88mmol/g） > MA-HMS-2（1.65mmol/g） > HMS-2（1.33mmol/g）,模板剂的存在,不仅增加了CO₂的吸附位点,还对混合胺改性的HMS吸附CO₂起到了协同作用.在20~75℃范围内,MA-HMS-1与MA-HMS-3受温度影响最明显,65℃时吸附量达最大值;随着温度的升高,HMS-1的吸附量随温度升高持续降低;MA-HMS-2的吸附量基本不变.含胺基的4种材料（HMS-1、MA-HMS-1、MA-HMS-2与MA-HMS-3）在80℃下拥有优良的再生性能,经4次循环再生后,MA-HMS-1的再生率为97.5%,高于MA-HMS-2（83%）和MA-HMS-3（84%）,保留HMS的模板剂对材料的再生性能有明显促进作用.     

探讨“烟塔合一”技术在环评中大气环境的防护距离

归纳"烟塔合一"项目评估的共性要求,在分析德国模式不能充分反映特定条件下对近距离保护目标影响的基础上,阐明了环境防护距离设置的必要性,并就目前所采取环境防护距离计算方法及部分项目风洞试验结果进行解析,提出相关建议。     

HP-5毛细管柱气相色谱法分离水中滴滴涕色谱条件研究

本试验利用HP-5毛细管柱,气相色谱法对水中滴滴涕几种衍生体的分离条件进行了研究和优化,找到了最佳仪器条件,为水中滴滴涕的检测提供了一定的试验参考。     

Self-ignition tendency of solid fuels: A gas emissions approach for early detection

Self-ignition of solid fuels storage is one of the main causes of human and economic losses. Additionally, each fire caused by this phenomenon emits an amount of toxic gases that contributes on the development of climate change. Nowadays, several methodologies are used in order to detect the self-ignition tendency of solid fuels, but they have as main disadvantages the amount of money and time that they require. The aim of this study is to propose a methodology of detection of incipient self-ignition of solid fuels through the measurement of gas emissions. This study compares existing methodologies to detect self-ignition tendency, such as TG, DSC or susceptibility, and to combustion related gas emission results. Different methods have been used to evaluate the results from the gas emission test, showing that interval and inflexion methods provide early detection of the self-heating process. With this methodology, it is possible to determine this process in advance with the equipment currently available in every industrial facility, reducing costs and improving efficiency.     

气田开发过程中地下水环境保护方案初探

区域地下水环境的保护是气田开发过程中环境保护工作的重点之一。通过现场调查和统计分析得知,外部污染源是影响当地地下水环境的主要因素,农田径流污染源是外部的主要污染源,以COD_Cr计其排放量分别约占外部污染源排放总量的67%,而钻井液漏失、天然气窜层、钻井废水排放等钻井作业是内部的主要污染源,其COD_Cr排放量约占内部污染源COD_Cr排放总量的62%,因而钻井作业的污染防治应是项目内部地下水污染防治工作的重点。根据地下水环境质量现状分析及变化趋势分析可知由于气田的开发建设,气田区地下水水质已受到一定程度的影响,特征污染物表现为COD_Cr、氨氮、氯化物、硝酸盐氮。为保护气田区地下水环境,分施工期和运营期两阶段设计了地下水环境保护方案,采取源头控制的清洁生产,至末端控制的污染治理并提出了突发污染事故应急预案,为气田的可持续开发提供指导。     

顶空-气相色谱法测定水质中的丙酮和丁酮

本文建立顶空-气相色谱法测定水和废水中的丙酮和丁酮的方法,水样测定结果的相对偏差小于5.0%,加标回收率在91%～103%之间,最低检出浓度0.006 mg.L-1。该方法简便,灵敏度更高,重现性好,线性范围宽,精密度和准确度满意,尤其是避免了消耗大量有机试剂,避免二次污染。旨在为实验分析人员提供技术参考依据。