某涡轮风扇发动机试车台的声环境研究

涡轮风扇发动机试车台空气流量大,试车噪声呈宽带强噪声,其中突出的低频域噪声可远距离传播,易造成大范围的环境污染。为掌握某型涡轮风扇发动机在室内试车时的噪声特性,并检验试车台建筑物和各项降噪设备的效果,我们对新建试车台的声环境进行了测量。通过对该试车台内、外环境噪声数据的分析,表明新建试车台的声环境满足了我国有关规范的要求。本次研究工作对今后试车台的声学设计具有重要的借鉴意义。     

成都市典型非道路工程机械排气烟度分析

采用不透光烟度计采集了成都市典型工程机械(挖掘机、装载机、叉车和压路机)排气烟度,研究了机械功率对其活动水平(燃油消耗量和年均工作时间)的影响,同时也研究了机械发动机构造和机械排放标准对其排气烟度的影响;同时,采用氮硫测定仪分析了机械油品硫含量,研究了硫含量对其排气烟度的影响.试验结果表明:机械功率越大的工程机械,燃油消耗量和年均工作时间数越高.成都典型工程机械排气烟度排放水平最低的为装载机,最高的为压路机;同时,超高排放装载机与叉车的占比较高.工程机械排气烟度受机械发动机排量、机械发动机构造、机械发动机排放标准和机械用油的综合影响,通过对工程机械装配电控发动机、提高原机排放标准和使用低硫燃油均能直观反映出机械排气烟度不同程度的改善.此外,油品中硫含量越高,机械排气烟度越大.     

排气制动下汽车制动失效的坡长临界值计算

针对连续长下坡汽车王制动器失效的现象,研究了在排气制动下汽车下坡制动失效的坡长临界值问题.根据汽车主制动器制动毂温升模型,推导出在山区不同长纵坡路段,排气制动下汽车主制动器制动失效的坡长临界值,提出r伍5%、6%坡道上,采取Ⅳ档排气制动时,维持40km/h的安全稳定车速,主制动器制动失效的坡长临界值分别为3072m和1929 m,为长下坡路段交通安全设施的设计提供了理论依据.     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

车用汽油铅损害及其对策研究

针对车用汽油的抗爆性能要求,探讨四乙基铅（Ｐｂ（Ｃ２Ｈ５）４）抗爆添加剂的作用机理,并着重分析研究了由此而引起的发动机铅排放对人类造成的损害及给大气环境等带来的污染。还探讨了车用汽油铅损害的对策及其最新进展     

La1-xCexFe0.7Co0.3O3-δ网状多层纳米纤维对碳烟催化燃烧性能研究

采用静电纺丝法制备了一系列钙钛矿催化剂La_(1-x)Ce_xFe_(0.7)Co_(0.3)O_(3-δ)(x=0、0.1、0.2、0.3和0.4),并采用XRD、SEM、FT-IR、H2-TPR和O_2-TPD等技术分析了Ce掺杂量对催化剂结构、微观形貌及理化特性的影响.同时,采用程序升温氧化(TPO)技术评价了催化剂对碳烟的催化燃烧活性,探讨了催化剂对碳烟的催化燃烧机理.结果表明:在La_(1-x)Ce_xFe_(0.7)Co_(0.3)O_(3-δ)中掺杂适宜的Ce有助于提高催化剂活性,改善催化剂比表面积和孔容积.在催化剂与碳烟松散接触条件下,当Ce掺杂量(质量百分比)为0.3时,所制备的La_(0.7)Ce_(0.3)Fe_(0.7)Co_(0.3)O_(3-δ)对碳烟的起燃温度(T_(ig))、最大燃烧温度(T_m)和燃尽温度(T_f)分别为329.5、409.8和421.1℃,呈现良好的催化氧化活性.碳烟最大转化效率为98.7%,平均活化能为123 kJ·mol~(-1),CO_2选择率为98.2%,实现了对柴油机碳烟排放污染物有效"过滤+催化燃烧"的双重目标.     

异质结型SnO2-TiO2纳米纤维光催化降解柴油机多环芳烃

采用同轴静电纺丝法制备了SnO_2-TiO_2纳米纤维,用X射线衍射仪(XRD)、扫描电子显微镜(SEM)、红外光谱仪(FTIR)和紫外-可见光谱能谱仪(UV-Vis),表征了SnO_2-TiO_2纳米纤维相组成和微观形貌,评价了催化剂表面化学形态和吸光特性,研究了SnO_2含量、光源条件、温度和催化稳定性对降解萘污染物的影响规律.结果表明,催化剂Sn25对萘降解效率最高.在暗光、可见光和紫外光条件下,萘降解效率分别为13.8%、37%和98%.Sn25对萘降解稳定率(标准差率)为0.36%.利用催化剂Sn25对柴油机尾气中多环芳烃(PAHs)排放污染物光催化降解应用发现,Sn25对低苯环PAHs、中苯环PAHs和高苯环PAHs的平均催化降解效率分别为80.2%、75.4%和60.2%.表明SnO_2-TiO_2纳米纤维具有较强光催化降解多环芳烃污染物能力.     

航空发动机涡轮叶片热障涂层冲蚀试验装置的研制

目的通过研制热障涂层冲蚀服役环境的模拟装置,来研究冲蚀失效机制。方法通过研制模拟热障涂层高温热冲击的燃气喷枪,在喷枪中设计速度、流量可控的颗粒送料系统,同时在装置中集成裂纹演化实时检测的声发射系统。结果该系统实现了热障涂层冲蚀服役环境的模拟,温度场、裂纹演化损伤参量的同步采集、输出与显示,从而完成了冲蚀服役环境模拟与关键损伤参量实时检测的一体化设计。结论装置能完成热障涂层常温、高温等各种服役温度、各种冲蚀角度、各种冲蚀速度等条件下的模拟试验,并提供较为系统的损伤参量检测数据,为理解热障涂层的冲蚀机理、优化其设计制备提供有效的试验数据。     

海洋环境下燃气轮机涡轮叶片的热腐蚀与防护

涡轮叶片热腐蚀是海洋环境工作下的燃气轮机的典型故障之一,也是决定涡轮叶片使用寿命的主要限制因素之一.简要分析了我国沿海地区海洋环境的特点以及涡轮叶片热腐蚀的特点,讨论了燃气轮机涡轮叶片的热腐蚀机理和影响因素,结果表明叶片表面温度、燃气中的盐含量以及燃油中的硫与钒是导致热腐蚀的重要因素.最后,着重从选材、涂层应用和维护等...     

Modeling the partitioning of BTEX in water-reformulated gasoline systems containing ethanol

The objectives of this research were to quantify the extent of cosolvency for water–gasoline mixtures containing ethanol and to identify appropriate modeling tools for predicting the equilibrium partitioning of BTEX compounds and ethanol between an ethanol-bearing gasoline and water. Batch-equilibrium experiments were performed to measure ethanol and BTEX partitioning between a gasoline and aqueous phase. The experiments incorporated simple binary and multicomponent organic mixtures comprised of as many as eight compounds as well as highly complex commercial gasolines where the composition of the organic phase was not completely defined. At high ethanol volume fractions, the measured partition coefficients displayed an approximate linear relationship when plotted on semi-log scale as a function of ethanol volume fraction. At lower concentrations, however, there was a distinctly different trend which is attributed to a change in solubilization mechanisms at these concentrations. Three mathematical models were compared with or fit to the experimental results. Log-linear and UNIFAC-based models were used in a predictive capacity and were capable of representing the overall increase in partition coefficients as a function of increasing ethanol content in the aqueous phase. However, neither of these predicted the observed two-part curve. A piecewise model comprised of a linear relationship for low ethanol volume fractions and a log-linear model for higher concentrations was fit to data for a surrogate gasoline comprised of eight compounds and was then used to predict BTEX concentrations in the aqueous phase equilibrated with three different commercial gasolines. This model was superior to the UNIFAC predictions, especially at the low aqueous ethanol concentrations.