Fenton氧化在废水处理中的应用

综述了近年来Fenton氧化在废水处理领域的应用状况,对Fenton试剂氧化的机理和主要影响因素:温度、pH、反应时间、H2O2和Fe2+的投加量、H2O2/Fe2+量比以及反应动力学模型进行了简要介绍.最后探讨了Fenton氧化技术在废水处理领域现存不足之处及今后的发展趋势.     

建阳市农业面源污染调查与防治对策研究

就目前建阳市农业面源污染的现状进行调查,并提出防治对策。     

环境管理过程中对锅炉型号的识别

通过对锅炉型号的简要介绍,提高对锅炉的认识,增强在污染源动态更新调查表的填报过程中锅炉技术指标的填报能力是十分必要的。     

FRP加固震损RC柱建模方法及骨架模型研究

为研究震损RC柱采用FRP(Fiber Reinforced Polymer,FRP)加固修复后的抗震性能,本文基于OpenSees仿真平台,根据震后RC柱的表观损伤状态提出FRP加固震损RC柱的有限元模型建立方法。对FRP加固震损RC柱进行5120种工况的Pushover分析,采用三折线荷载-位移骨架曲线,研究损伤状态对骨架曲线特征点参数的影响规律,并通过数据回归分析提出FRP加固震损RC柱的骨架曲线计算模型。分析结果表明:损伤会降低FRP加固RC柱的承载力及刚度,且降低程度随损伤指数的增大而增加,两者近似成抛物线关系;在DS-5损伤状态下,相比于FRP加固完好RC柱,FRP加固震损RC柱的屈服承载力P y、峰值承载力P c、弹性刚度K 1、弹塑性刚度K 2及下降段刚度K 3的均值下降17.9%、14.5%、41.8%、43.1%和19.9%;损伤对FRP加固RC柱弹性刚度和弹塑性刚度的降低程度明显高于屈服承载力和峰值承载力;文中提出的FRP加固震损RC柱骨架曲线计算模型具有较高精度。     

岩溶地下河系统中有机氯的分布特征与来源分析

选取重庆老龙洞、青木关岩溶地下河为研究对象,采用气相色谱仪-微池电子捕获检测器(GC-μECD)分析两条地下河水体中21种有机氯农药(OCPs)的浓度.结果表明,南山地下河中六六六(HCHs)和艾氏剂类化合物(ALDs)是主要检出物,青木关地下河中HCHs和甲氧滴滴涕是主要检出物.南山、青木关地下河中均未检出o,p'-DDE、p,p'-DDE、o,p'-DDD,同时,青木关地下河还未检出o,p'-DDT、狄氏剂,其余OCPs在两条地下河中检出率高达100%.青木关地下河中OCPs浓度范围为145~278 ng·L-1之间,平均值为213 ng·L-1;南山老龙洞地下河中OCPs浓度介于17.7~40.8 ng·L-1之间,平均值为32.7ng·L-1.两条地下河中各OCPs组分表现为地下河出口大于入口.通过对OCPs污染来源分析,发现两地下河流域滴滴涕(DDTs)主要来自于历史上工业DDTs输入,氯丹主要来自于大气沉降.六六六(HCHs)主要来源是林丹的输入,南山地下河属于历史污染,青木关地下河上游的甘家槽有新的HCHs输入.与国内外其他各水体相比,南山地下河水体中HCHs、DDTs浓度处于低水平;青木关下河处于中等偏高水平.结合中外用水卫生标准,发现南山地下河和青木关地下河未超过饮水安全标准.青木关应禁止农田施用有机氯农药,保护地下河生态环境.     

Evaluation of accuracy of linear regression models in predicting urban stormwater discharge characteristics

Stormwater runoff has been identified as a source of pollution for the environment, especially for receiving waters. In order to quantify and manage the impacts of stormwater runoff on the environment, predictive models and mathematical models have been developed. Predictive tools such as regression models have been widely used to predict stormwater discharge characteristics. Storm event characteristics, such as antecedent dry days （ADD）, have been related to response variables, such as pollutant loads and concentrations. However it has been a controversial issue among many studies to consider ADD as an important variable in predicting stormwater discharge characteristics. In this study, we examined the accuracy of general linear regression models in predicting discharge characteristics of roadway runoff. A total of 17 storm events were monitored in two highway segments, located in Gwangju, Korea. Data from the monitoring were used to calibrate United States Environmental Protection Agency＇s Storm Water Management Model （SWMM）. The calibrated SWMM was simulated for 55 storm events, and the results of total suspended solid （TSS） discharge loads and event mean concentrations （EMC） were extracted. From these data, linear regression models were developed. R2 and p-values of the regression of ADD for both TSS loads and EMCs were investigated. Results showed that pollutant loads were better predicted than pollutant EMC in the multiple regression models. Regression may not provide the true effect of site-specific characteristics, due to uncertainty in the data.     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

AERMOD与估算模式在环境影响评价中的应用与比较

采用AERMOD和估算模式两种预测模式对同一生活垃圾填埋场进行了预测。比较两种预测结果可以看出,在污染源、预测范围、运行周期相同的情况下,敏感点处的落地浓度均与排放源强呈正比,与距离呈反比。预测结果同时说明,估算模式是一种保守的预测模式,其预测结果比AERMOD模式大,可作为进一步预测模式的有效补充。