低温碱溶脱除液晶显示器(LCD)玻璃基板粉末中的硅和铝

为了提高氯化法回收LCD中铟的效果,降低SiO2和Al2O3对氯化过程的干扰,采用NaOH对液晶显示器玻璃基板粉末中的硅和铝进行了预先溶出规律研究.首先分析了LCD粉末中SiO2和Al2O3的含量、形貌以及铟的浸出变化,然后计算了SiO2和Al2O3的脱除效率.在条件实验基础上通过正交实验设计得出优化实验条件.研究表明,在液固比为90:2、温度95℃、溶出时间2 h、碱度0.56 g/L的最佳工艺条件下, SiO2的脱除率为80.88%、Al2O3的脱除率为 83.30%、二者总的脱除率为81.30%,洗涤液中没有发现铟的溶出,碱溶后的物料表面产生大量均匀的孔状结构.这将对液晶显示器玻璃基板粉末的资源化与铟的富集有重要意义.     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

Synthesis of Short-chain-length/Medium-chain-length Polyhydroxyalkanoate (PHA) Copolymers in Peroxisome of the Transgenic Arabidopsis Thaliana Harboring the PHA Synthase Gene from Pseudomonas sp. 61-3

In this paper, the photosynthetic production of short-chain-length/medium-chain-length polyhydroxyalkanoate (PHA) copolymers is reported. The wild-type and highly active doubly mutated PHA synthase 1 (S325T/Q481K, abbreviated ST/QK) genes from Pseudomonas sp. 61-3 were introduced into Arabidopsis thaliana. Peroxisome targeting signal 1 (PTS1) was used to target PHA synthases into the peroxisome to synthesize PHA from the intermediates of the β-oxidation pathway. The transgenic Arabidopsis produced PHA copolymers consisting of 40–57 mol% 3-hydroxybutyrate, 21–49 mol% 3-hydroxyvalerate, 8–18 mol% 3-hydroxyhexanoate, and 2–8 mol% 3-hydroxyoctanoate. The maximum PHA contents were 220μ g/g cell dry weight (cdw) in leaves, and 36μ g/g cdw in stems, respectively. The expression of the ST/QK mutated PHA synthase in leaves gene did not lead to significant difference in PHA content and monomer composition of PHAs, compared to the wild-type PHA synthase gene, suggesting that the supply of monomers may be a rate-determining step of PHA biosynthesis in the peroxisome. However, in stems, there were significant differences dependent on whether the wild-type or ST/QK mutated PHA synthase was expressed. These results suggest that tissue-specific monomer availability is important in determining the final mol% composition of PHA copolymers produced by the peroxisome in plants.     

一个研究街道峡谷流场及浓度场特征的三维数值模式

目前，研究街道峡谷内流场及机动车排放污染物的扩散行为特征所采用的主要方法为：采用野外测试法和物理模拟法，而采用三维数值模拟方法研究此问题的工作很少。本文创建了一个研究微尺度街道峡谷内流场及机动车排放污染物扩散特征的三维数值模式，即首次采用伪不定常方法，利用K——E闭合方案，建立了一个模拟城市街道峡谷内流场及污染物扩散特征与街道峡谷风场、街道几何结构及两侧建筑物高度对称性之间的复杂关系的三维数值模式。经过与实际监测资料及风洞实验对比，结果表明此三维模式具有较好的模拟精度，能够很好模拟峡谷内的风场及街谷几何结构对街道峡谷内流场及浓度场特征的影响，有很强的实用性。     

Na_2CO_3对回填材料膨润土的改型效果分析

以新疆柯尔碱膨润土为原料,加入不同比例的Na2CO3改型剂,研究改型剂添加对膨润土胶质价、膨胀容和pH值的影响。另外,考虑到压实膨润土的非饱和渗透特性对于评价缓冲回填材料性能具有重要意义,故采用压力膜仪测量压实Na2CO3改型膨润土和原土的土水特征曲线,分析研究二者基质吸力随体积含水率变化的相关关系。实验结果显示,添加Na2CO3改型剂可以增大膨润土的胶质价、膨胀容和pH值,成功地将膨润土中的钙蒙脱石转化为钠蒙脱石,其对柯尔碱膨润土pH值的作用效果满足地质处置库对缓冲回填材料的要求;改型后膨润土的持水能力明显大于原土。     

旱地长期定位施肥对土壤剖面硝态氮分布与累积的影响

在 １５ ａ长期定位试验基础上研究了黄土高原旱地长期施用不同用量和配比的氮、磷肥对土壤剖面中硝态氮分布和累积的影响。结果表明：长期大量施用氮肥,在土壤剖面 １００～１８０ ｃｍ之间形成硝态氮累积层,峰值出现在 １４０ ｃｍ处,最大值为 ６７．９２ｍｇ／ｋｇ（单施 Ｎ １８０ ｋｇ／ｈｍ~２）; 配合施用磷肥可以降低土壤剖面硝态氮质量分数,根据试验,提出了旱地合理施肥的氮磷肥用量。     

Fe3O4-TiO2Al吸附剂去除水中氟离子

以实验室制备的Fe3O4-TiO2·nH2O·Al吸附剂处理模拟和实际含氟废水,探讨了吸附剂用量、体系pH、吸附温度和吸附时间等因素对F-吸附效果的影响。结果表明:在初始F-浓度16.1 mg/L,起始pH 8.0,吸附剂投加量5 g/L,室温(约25 ℃)下吸附15 min时,模拟和实际废水的出水F-均可达到3O4-TiO2·nH2O·Al具有一定的实际应用价值。含氟水溶液初始pH对Fe3O4-TiO2·nH2O·Al吸附F-性能影响较大。在pH 介于3.0~5.0 时,吸附容量较大,过高或过低都会导致吸附容量降低。Fe3O4-TiO2·nH2O·Al吸附F-的过程为放热反应,升温不利于F-的吸附。该吸附剂吸附F- 的过程为化学吸附,符合准二级动力学模型,等温线拟合接近Freundlich吸附等温线。     

Isomer distribution of nitrotriphenylenes in airborne particles, diesel exhaust particles, and the products of gas-phase radical-initiated nitration of triphenylene

The formation of mutagenic nitro-polycyclic aromatic hydrocarbons (NPAHs) 1- and 2-nitrotriphenylene (1- and 2-NTP) via gas-phase OH or NO₃ radical-initiated reactions of triphenylene was demonstrated for the first time using a flow reaction system. In contrast with the results of conventional electrophilic nitration, 2-NTP was formed in larger yield than 1-NTP, but this is consistent with the mechanism proposed for gas-phase radical-initiated nitration of PAH. In diesel exhaust particle (DEP) samples, both 1- and 2-NTP were identified and their concentrations determined, as well as 1-nitropyrene (1-NP), which is a representative combustion-derived NPAH: the mean concentrations of 1-NTP, 2-NTP, and 1-NP were 4.7, 1.9, and 32 pmol mg_DEP^–1, respectively. The mean 2-NTP/1-NTP, 1-NTP/1-NP, and 2-NTP/1-NP ratios in samples of airborne particles collected in a residential area in Osaka, Japan, were>1.55,<0.25, and 0.37, respectively; these values are much higher than those of the DEP samples. This finding indicates that there is another source for airborne NTPs, especially 2-NTP, apart from diesel exhaust. These results strongly suggest that airborne NTPs originate from atmospheric processes such as radical-initiated reactions of triphenylene, and this has a significant influence on the atmospheric occurrence of NTPs.     

浓磷酸预处理废弃棉织物回收葡萄糖和涤纶的优化

为了实现废弃棉织物的高效资源化利用,采用浓磷酸预处理,将棉纤维转化为葡萄糖,并回收高纯度涤纶.以磷酸浓度、磷酸与原料液固比、预处理温度和时间为研究对象,以涤纶回收纯度、葡萄糖收率为考察指标,采用中心组合设计(CCD),建立响应面模型对预处理工艺参数进行优化.并确定了最佳的浓磷酸预处理工艺条件为:磷酸质量分数85%,液固比15:1,预处理时间7 h,预处理温度50℃.在此条件下涤纶回收纯度可达100%,葡萄糖收率可达79.0%,且实验验证值与模型预测值较为接近,模型精度较高.此外,再生纤维素不经干燥直接酶水解,葡萄糖收率可被进一步提高至83.0%.     

氧化铁改性砂联合生物预处理对氨氮的吸附特性

对含氨氮(NH3-N)的微污染原水,采用自制氧化铁改性石英砂(iron oxide coated sand,IOCS)滤料强化过滤与生物预处理技术联合,进行强化处理与吸附效果研究.结果表明,采用强化挂膜法,生物预处理反应器的生物膜成熟期约为7 d,其对氨氮的去除率为60%~70%,但反应器中存在亚硝酸盐氮积累的现象.IOCS与生物预处理技术联合,对NH3-N的平均去除率为84.67%,出水NH3-N浓度均低于0.5 mg/L,NO2--N含量趋于0;而普通石英砂(RQS)在同等条件下,对氨氮的去除效果不稳定,平均去除率为74.31%,出水NH3-N平均浓度未达标,对NO2--N平均去除率仅有33.29%.在4 m/h滤速工况下,与生物预处理技术联合,IOCS和RQS对NH3-N最高去除率分别为94.3%和82.72%.IOCS与RQS的表面形态结构存在明显差异:前者的表面结构更加复杂多孔,比表面积大,有利于生物牢固附着;后者表面较光滑,比表面积小,挂膜后生物易脱落.