光催化降解亚甲基蓝的影响因素及动力学研究

进行了亚甲基蓝在硫化镉上的暗吸附反应，并作Langmuir拟合和Freundlich拟合计算其吸附速率常数。通过实验证明硫化镉光催化降解亚甲基蓝符合一级动力学反应。在低光强下，反应速率常数随着光强的增大而增大，两者之间存在显著的线性关系。改变光催化反应温度，计算表观活化能Ea为19.13kJ/mol，证明温度对反应影响较小。     

Simultaneous catalytic removal of NOx and diesel PM over La0.9 K0.1 CoO3 catalyst assisted by plasma

The simultaneous removal of NOx and particulate matter(PM) from diesel exhaust is investigated over a mixed metal oxide catalyst of La0.9 K0.1 CoO3 loaded on γ-Al2O3 spherules with the assistant of plasma. It was found that NOx was reduced by PM in oxygen rich atmosphere, the CO2 and N2 were produced in the same temperature window without considering the N2 formed by plasma decomposition. As a result, the temperature for the PM combustion decreases and the reduction efficiency of NOx to N2 increases during the plasma process, which indicated that the activity of the catalyst can be improved by plasma. The NOx is decomposed by plasma at both low temperature and high temperature. Therefore, the whole efficiency of NOx conversion is enhanced.     

Destruction of VOCs by combination of corona discharge and catalysis techniques

The catalytic effect of alumina on the destruction of toluene, benzene, acetone and methanol, in DC pulsed corona discharge reactor was studied. In the presence of alumina the inlet concentration of the VOCs was varied from 5 x 10-6 mol/L to 80% x 10-6 mol/L, and their decomposition efficiency (conversion %) was found to be 99%-80% for toluene, 99%-97% for benzene, 95%-92% for acetone, and 72%-85% for methanol. Corresponding decomposition in the absence of alumina was 90%-38% for toluene, 89%-57% forbenzene, 42%-30% for acetone, and 47%-19% for methanol. Feed gas flow rate was 400 cm3/min and power reading from DC source was 7.4 W in all of the experiments. Alumina also shifted the CO/CO2 ratio in the by-products in favor of CO2. Ozone concentration at the reactor outlet was higher in the presence of alumina. Enhancement in VOCs decomposition by alumina was explained on the basis of higher concentration of ozone and its precursor atomic oxygen [O].Decomposition efficiency (conversion %) for individual compounds was found to be inversely proportional to the ionization potential of the compound, under identical conditions. Double DC high voltage sources pulse generator was tested and found to improve VOCs decomposition compared with the conventional single DC high voltage source.     

苦杏仁酸、苹果酸、乳酸对Cr(VI)还原作用的比较

不同温度和pH条件下,通过批式试验研究了苦杏仁酸、苹果酸、乳酸还原Cr(VI)的反应速率.结果表明,这3种α-OH酸还原Cr(VI)的能力表现为:苦杏仁酸>苹果酸>乳酸.苦杏仁酸对Cr(VI)的还原作用受pH变化的影响较大,而乳酸受温度变化的影响较大.同时研究了Mn(II)对3种α-OH酸还原Cr(VI)反应速率的影响.结果表明,Mn(II)对3种α-OH酸还原Cr(VI)均有催化作用,其中对苦杏仁酸表现更为明显.     

[Cu—γ—Al2O3]催化剂处理染料废水工艺条件研究

采用「Ｃｕ－γ－Ａｌ２Ｏ３」催化剂对由活性艳红Ｘ－３Ｂ配制的ＣＯＤｃｒ为５７００ｍｇ／Ｌ色度３１００倍的实际染料废水进行了催化氧化试验，试验表明，在控制ｐＨ＝４－５，Ｈ２Ｏ２用量为５．０ｍｇ／Ｌ，催化剂用量为３．０ｇ／Ｌ，ｔ＝７０℃和反应时间为２ｈ条件下，可获得ＣＯＤｃｒ去除率为７７％－７８％，脱色率为９９％的良好效果，且催化剂可再生使用。     

电-多相催化反应器处理苯胺废水的研究

提出一种基于复极性固定床反应器处理有机废水的新技术:电-多相催化技术,用于苯胺废水的处理。实验结果表明,该技术对苯胺具有较好的催化降解的效果。在外加电压30V、电解时间1h、支持电解浓度800mg/L、pH值中性的条件下,降解COD为800mg/L的苯胺废水,去除率可达36.53%,同时对不同因素的影响原因进行了分析。     

含氮有机废气深度氧化催化剂的研究

本文研究了复载于改性丝光沸石上铜氧化物催化剂对有机烃类韵催化氧化活性;同时考察了催化剂对正丁胺、苯胺、硝基苯深度氧化的活性及控制NO_x能力。结果表明,Cu和改性组份La,Cr之间有明显的共助催化作用,其中Cu_3/AUM催化剂对烃类、食氮有机物的氧亿活性及控NO_x能力良好,在空速为10000h~(-1),反应温度270℃,反应物(正丁胺)浓度为260Gmg/m~3的条件下,其转化率达100％,几乎未检测到NO_x的生成,而且对空速和有机物浓度的变化具有一定妁适应性。     

介质阻挡放电-催化降解苯的研究

采用双介质阻挡放电管 ,当含苯气体的流量为 1 5L·min- 1 ,放电电压在 60 0 0V—1 2 0 0 0V范围内 ,放电管温度在 2 1 0℃左右 ,研究介质阻挡放电 催化降解苯的协同效应 .结果表明 ,在余辉区中放入催化剂 ,60 0 0V的电压下 ,苯的降解率可达 70 % ,产物中CO/CO2为 0 0 5 ;而在同样电压下 ,不放入催化剂 ,苯的降解率仅为 5 5 %左右 ,CO/CO2 约为 0 5 .由此可见 ,催化剂在余辉区时能与等离子体协同作用 ,促进苯的降解     

Nonideal transport of reactive contaminants in heterogeneous porous media: 7. distributed-domain model incorporating immiscible-liquid dissolution and rate-limited sorption/desorption

The purpose of this work is to present a distributed-domain mathematical model incorporating the primary mass-transfer processes that mediate the transport of immiscible organic liquid constituents in water-saturated, locally heterogeneous porous media. Specifically, the impact of grain/pore-scale heterogeneity on immiscible-liquid dissolution and sorption/desorption is represented in the model by describing the system as comprising a continuous distribution of mass-transfer domains. With this conceptualization, the distributions of the initial dissolution rate coefficient and the sorption/desorption rate coefficient are represented as probability density functions. Several sets of numerical experiments are conducted to examine the effects of heterogeneous dissolution and sorption/desorption on contaminant transport and elution. Four scenarios with different combinations of uniform/heterogeneous rate-limited dissolution and uniform/heterogeneous rate-limited sorption/desorption are evaluated. The results show that both heterogeneous rate-limited sorption/desorption and heterogeneous rate-limited dissolution can significantly increase the time or pore volumes required to elute immiscible-liquid constituents from a contaminated porous medium. However, sorption/desorption has minimal influence on elution behavior until essentially all of the immiscible liquid has been removed. For typical immiscible-liquid constituents that have relatively low sorption, the asymptotic elution tailing produced by heterogeneous rate-limited sorption/desorption begins at effluent concentrations that are several orders of magnitude below the initial steady-state concentrations associated with dissolution of the immiscible liquid. Conversely, the enhanced elution tailing associated with heterogeneous rate-limited dissolution begins at concentrations that are approximately one-tenth of the initial steady-state concentrations. Hence, dissolution may generally control elution behavior of immiscible-liquid constituents in cases wherein grain/pore-scale heterogeneity significantly influences both dissolution and sorption/desorption.     

Multiphase flow and transport through fractured heterogeneous porous media

The migration of Dense, Non-Aqueous Phase Liquid (DNAPL) and dissolved phase contamination through a fractured heterogeneous porous medium has been investigated through the use of a multiphase compositional model. The sensitivity of the timescales of migration and the distribution of contaminant in the subsurface to the mean permeability, the variance of the permeability, and the degree of fracturing of the domain were examined. It was found that increasing the mean permeability of the domain allowed the DNAPL to penetrate deeper into the subsurface, while decreasing the mean permeability caused the DNAPL to pool at shallower depths. The presence of fractures within the system was found to control the infiltration only in the most fractured domain. Moment analysis of the nonwetting phase showed that large-scale movement had ceased after approximately 9 years (maximum duration of the source-on condition was approximately 4.5 years). This tended to be due to a redistribution of the DNAPL towards a residual configuration, as was evidenced by the gradual trending of average nonwetting phase saturations within the domain to a static value. The dissolved phase plume was found to migrate at essentially the same rate as the nonwetting phase, due to the reduced relative permeability of lenses containing DNAPL, and due to diffusive losses of mass to the matrix of fractured clay and silty-clay lenses. Some exceptions to this were found when the DNAPL could not overcome the displacement pressure of a lens, and could not by-pass the lens due to the lack of available driving force after the source had been shut off.