Ni/Fe/Cu氧化物的催化臭氧化作用研究

以吐氏酸的臭氧氧化为例,研究了过渡金属镍、铁、铜单组分和不同配比双组分氧化物的催化作用,附着沉淀法制备的Ｎｉ－Ｆｅ（１：４）和Ｎｉ－Ｃｕ（４：１）催化剂的臭氧利用率分别比γ－Ａｌ２Ｏ３载体提高了２８．９％和２４．３％,金属氧化催化臭氧化能显著改善吐氏酸溶液的可生化性,当溴氧消耗量为０．２５－０．３５ｇ／Ｌ时,ＢＯＤ５／ＣＯＤ达到最大值０．２８。     

泡沫镍载二氧化钛光催化降解磺基水杨酸

为了探索有机物在固定后光催化剂上的降解行为,将TiO₂（锐钛型）粉末固定在多孔泡沫镍上,以一只6W主波长为365nm的紫外线杀菌灯为光源,研究了磺基水杨酸（Ssal）在TiO₂-Ni体系上的光催化降解。结果表明,Ssal的降解动力学可采用Langmuir-Hinshelwood（L-H）方程来描述。通过测定降解反应的半衰期和测定初始速率的方法确定了L-H方程的参数,两种方法的结果相吻合。还研究了Ssal的光催化降解反应速率与Ph值和温度的关系。结果表明,当Ph值为7.5左右时,Ssal的光催化降解最为有利;当温度从20℃升至50℃时,Ssal的光催化降解加快。通过考察不同Ph值时Ssal在TiO₂-Ni体系上的吸附能力探讨了反应初始速率与Ph值的关系     

稀土氧化物在烟气脱硫过程中的应用研究进展

目前烟气脱硫是控制ＳＯ２排放最有效的途径之一。本文综述了以稀土氧化物作为吸收剂或催化剂在烟气脱硫过程中应用的研究进展,重点介绍了稀土氧化物吸收或催化脱硫反应的机理及特殊性能,并对稀土氧化物材料吸收或催化脱硫方法的特点及应用前景进行了讨论。     

Pulsed pumping process optimization using a potential flow model

A computational model is applied to the optimization of pulsed pumping systems for efficient in situ remediation of groundwater contaminants. In the pulsed pumping mode of operation, periodic rather than continuous pumping is used. During the pump-off or trapping phase, natural gradient flow transports contaminated groundwater into a treatment zone surrounding a line of injection and extraction wells that transect the contaminant plume. Prior to breakthrough of the contaminated water from the treatment zone, the wells are activated and the pump-on or treatment phase ensues, wherein extracted water is augmented to stimulate pollutant degradation and recirculated for a sufficient period of time to achieve mandated levels of contaminant removal. An important design consideration in pulsed pumping groundwater remediation systems is the pumping schedule adopted to best minimize operational costs for the well grid while still satisfying treatment requirements. Using an analytic two-dimensional potential flow model, optimal pumping frequencies and pumping event durations have been investigated for a set of model aquifer-well systems with different well spacings and well-line lengths, and varying aquifer physical properties. The results for homogeneous systems with greater than five wells and moderate to high pumping rates are reduced to a single, dimensionless correlation. Results for heterogeneous systems are presented graphically in terms of dimensionless parameters to serve as an efficient tool for initial design and selection of the pumping regimen best suited for pulsed pumping operation for a particular well configuration and extraction rate. In the absence of significant retardation or degradation during the pump-off phase, average pumping rates for pulsed operation were found to be greater than the continuous pumping rate required to prevent contaminant breakthrough.     

Combining steam injection with hydraulic fracturing for the in situ remediation of the unsaturated zone of a fractured soil polluted by jet fuel

A steam injection pilot-scale experiment was performed on the unsaturated zone of a strongly heterogeneous fractured soil contaminated by jet fuel. Before the treatment, the soil was stimulated by creating sub-horizontal sand-filled hydraulic fractures at three depths. The steam was injected through one hydraulic fracture and gas/water/non-aqueous phase liquid (NAPL) was extracted from the remaining fractures by applying a vacuum to extraction wells. The injection strategy was designed to maximize the heat delivery over the entire cell (10 m × 10 m × 5 m). The soil temperature profile, the recovered NAPL, the extracted water, and the concentrations of volatile organic compounds (VOCs) in the gas phase were monitored during the field test. GC-MS chemical analyses of pre- and post-treatment soil samples allowed for the quantitative assessment of the remediation efficiency. The growth of the heat front followed the configuration of hydraulic fractures. The average concentration of total hydrocarbons (g/kg of soil) was reduced by ～ 43% in the upper target zone (depth = 1.5-3.9 m) and by ～ 72% over the entire zone (depth = 1.5-5.5 m). The total NAPL mass removal based on gas and liquid stream measurements and the free-NAPL product were almost 30% and 2%, respectively, of those estimated from chemical analyses of pre- and post-treatment soil samples. The dominant mechanisms of soil remediation was the vaporization of jet fuel compounds at temperatures lower than their normal boiling points (steam distillation) enhanced by the ventilation of porous matrix due to the forced convective flow of air. In addition, the significant reduction of the NAPL mass in the less-heated deeper zone may be attributed to the counter-current imbibition of condensed water from natural fractures into the porous matrix and the gravity drainage associated with seasonal fluctuations of the water table.     

液相催化加氢法去除Cr（Ⅵ）

采用浸渍法合成出Pd/Al2O3催化剂,通过ICP、XRD、TEM和Zeta电位等表征手段对催化剂的组成和形貌进行了表征.在液相催化加氢还原Cr（Ⅵ）的反应中,分别研究了催化剂加入量、Cr（Ⅵ）初始浓度、pH值、Pd负载量等因素的影响.结果表明,该催化剂表面酸性影响催化还原效果,此反应属于吸附抑制型.     

Estimating an homogeneous series of a population abundance indicator despite changes in data collection procedure: A hierarchical Bayesian modelling approach

Abundance indicators are required both to assess and to manage wild populations. As new techniques are developed and teams in charge of gathering the data change, data collection procedures (DCPs) can evolve in space and time. How to estimate an homogeneous series of abundance indicator despite changes in DCP? To tackle this question a hierarchical Bayesian modelling (HBM) approach is proposed. It integrates multiple DCPs in order to derive a single abundance indicator that can be compared over space and time irrespective of the DCP used. Compared to single DCP models, it takes further advantage for abundance estimation of the joint treatment of a larger set of spatio-temporal units. After presenting the general formulation of our HBM approach, it is applied to the juvenile Atlantic salmon (Salmo salar L.) population of the River Nivelle (France). Posterior model checking, using χ² discrepancy measure, do not reveal any inadequacy between the model and the data. Despite a change in the DCP used (successive removals to catch-per-unit of effort), a unique abundance indicator for the 425 spatio-temporal units (site × year) sampled over twenty-four years (1985-2008) is estimated. The HBM approach allows the assessment of precision of the abundance estimates and shows variation between DCPs: a reduction in precision is observed during the most recent years (2005-2008) when only the catch-per-unit of effort DCP was used. The merits and generality of our HBM approach are discussed. We contend it extends previous single DCP models or inter-calibration of two DCPs, and it could be applied to a wide range of specific situations (taxon and DCPs).     

强化SCR脱硝催化剂转化零价汞的初步研究

常规的选择性还原脱硝(SCR)催化剂对烟气中的零价汞具有一定的催化氧化作用,从而有利于提高下游的除汞效率。但在烟气HCl浓度较低时,SCR催化剂对燃煤烟气中的零价汞催化氧化效果较差。为了提高SCR催化剂对零价汞的催化氧化效果,在现有SCR催化剂基础上,通过负载其它金属元素的方法,对其进行改性掺杂。结果发现,负载锰氧化物的Mn/SCR催化剂,对零价汞的催化氧化作用明显提高,而将其再掺杂Mo后,其催化氧化性能得到更进一步提高。在反应温度350℃的条件下,加入7.5 mg/m3HCl,Mo-Mn/SCR对零价汞的催化氧化效率接近90%,而常规SCR催化剂只有35%左右。另外,Mo只有在与Mn结合使用,其促进作用才能较显著地体现出来。对改性后的SCR催化剂的脱硝性能研究表明,掺杂Mo-Mn元素对于SCR的脱硝性能无明显影响。     

镁法脱硫浆液氧化催化剂工业化应用研究

针对镁法脱硫浆液氧化催化剂工业化的实际应用进行研究,结果表明:使用催化剂Catalyst TR后,脱硫浆液的氧化时间可缩短为4 h即能达到硫酸镁溶液含量20%以上,氧利用率可提高到20%以上,且考虑氧化系统运行成本后,使用含量0.001 mol/L的催化剂Catalyst TR较经济合理,最终能够产出符合工业硫酸镁一级品标准的七水硫酸镁产品。     

Electroreductive dechlorination of chlorophenols with Pd catalyst supported on solid electrode

Electroreductive dechlorination of chlorophenols with Pd catalyst supported on solidelectrode was studied. As solid electrodes, carbon cloth (CC), carbon felt (CF) and titanium mesh were used, and palladium was plated on solid electrodes by either electrolytic or electroless method. On each electrode with Pd, chlorophenols were qualitatively dechlorinated to phenol, while they were entirely intact on electrodes without Pd. Moreover, neither base electrode nor plating method significantly affected the activity of Pd as far as it was sufficiently loaded on the electrode. Based on the results in the experiments using one electrode repeatedly, Pd catalyst proved to possess a satisfactory duarability under the present condition. It was suggested that the reactive species responsinble for the dechlorination of chlorophenols could be formed during preliminary electrolysis. Thus, (Pd)_x-H resulting from the adsorption of electrogenerated hydrogen on metallic Pd might be assumed most probable.