菌渣中阿维菌素残留检测方法及其无害化工艺研究

文章建立了简单、快速的阿维菌素菌渣中阿维菌素残留量高校液相色谱检测方法以及利用水热法处理阿维菌素菌渣。采用固相萃取-高效液相色谱检测方法测定阿维菌素菌渣中阿维菌素残留量,提取剂为乙腈/水=4/1(V/V),采用HLB固相萃取柱进行净化。加标回收率90.3%~107.3%,相对标准偏差(RSD)为3.00%~5.69%,阿维2菌素标准曲线线性相关系数R~2=0.999 6,线性范围为1.0~1 000 mg/L。利用正交实验,水热法处理阿维菌素菌渣,在190℃的温度下处理2 h后,菌渣中阿维菌素残留量由991.30降至0.84 mg/kg,去除率达99.92%。处理前后的菌渣与有机肥标准作对比,除含水率外其余检测指标均达到有机肥标准要求。该项研究为阿维菌素菌渣的资源化利用提供了理论依据。     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.     

热电规划中电厂的污染及防治对策

随着沈阳市推行的集中供热和低矮面源的改造和小型锅炉的拆迁,烟尘和二氧化硫的主要污染已经转到了各电厂和大型热源厂的集中排放。而且排放量还逐渐增大。污染物的排放已远远超出区域环境容量,尤其是电厂的二氧化硫已经成为治理大气污染的瓶颈。根据沈阳市热电发展规划和热源污染控制规划,对沈阳城区电厂的排污现状及污染趋势进行了分析,提出了污染控制和二氧化硫治理对策。     

高浓度焦化废水处理工艺的研究

对焦化废水的微生物处理工艺进行改进,采取提高污泥浓度,增加曝气量,增加凝聚工艺等强化处理措施,提高了对高浓度焦化废水的处理效率,使废水达到国家排放标准。     

Modulation-assisted high speed machining of compacted graphite iron (CGI)

The application of controlled, low-frequency modulation (～100 Hz) superimposed onto the cutting process in the feed-direction – modulation-assisted machining (MAM) – is shown to be quite effective in reducing the wear of cubic boron nitride (CBN) tools when machining compacted graphite iron (CGI) at high machining speeds (>500 m/min). The tool life is at least 20 times greater than in conventional machining. This significant reduction in wear is a consequence of the multiple effects realized by MAM, including periodic disruption of the tool–workpiece contact, formation of discrete chips, enhanced fluid action and lower cutting temperatures. The propensity for thermochemical wear of CBN, the principal wear mode at high speeds in CGI machining, is thus reduced. The tool wear in MAM is also found to be smaller at the higher cutting speeds (730 m/min) tested. The feed-direction MAM appears feasible for implementation in industrial machining applications involving high speeds.     

火电厂煤尘污染防治主要措施研究

文章通过对火电项目煤尘产生源的分析,根据北方地区社会、经济、环境现状,提出电厂储煤场及输煤系统煤尘的主要防治措施,从而为北方经济欠发达地区火电厂的煤尘污染防治提供一些参考依据,促进环境质量的改善。     

广东核电站厂址降水特征分析

介绍广东核电站厂址降水特性分析的方法学，给出降水的气侯学统计以及降水率、降水持续时间的分布特征．     

Optimising the environmental benefits of emission reductions from UK coal- and oil-fired power stations: a critical loads approach

This paper describes a method for determining reductions of SO₂ emissions from coal- and oil-fired power stations, oil refineries and large industrial units in the UK taking into account their pollution potential. The method is based on the use of two gridded data sets: critical loads, which represent the sensitivity of the environment to acid deposition and modelled estimates of total (wet + dry) sulphur deposition for 646 point sources within the UK. An iterative method is used to identify and subsequently reduce emissions from point sources that contribute most to areas of critical loads exceedance. This paper demonstrates how the method may be used to determine an optimal allocation of emissions across the UK which yields the maximum amount of environmental protection per unit of emission.The paper then goes on to consider the changes that will have to take place within the UK power generation industry in order to meet the revised EC Large Combustion Plant Directive which comes into force on 1 January 2008. Particular emphasis is placed upon proposed emissions trading schemes and the environmental implications of allowing trading between stations with high and low pollution potentials. The paper concludes by suggesting that the emissions trading process should take into account the pollution potential of each source, irrespective of whether the proposed emission is within the plant's agreed emission limit. An approach based entirely on minimizing environmental damage rather than one which takes cost into account, as in current integrated assessment modelling, could provide an interesting approach across the rest of Europe.     

厌氧氨氧化工艺脱氮及其污泥形态的研究

为研究厌氧氨氧化工艺对高浓度含氮废水的脱氮性能,在以聚乙烯海绵作为填料的上流式厌氧固定床反应器中利用人工配置高浓度含氮废水进行了实验研究.实验中通过添加充足无机碳源,实现了厌氧氨氧化反应器在总氮浓度900～1 210 mg/L长期稳定的运行,脱氮效率在80％以上,最高氮负荷为5.9 kg/m3·d.结果表明:充足的无机碳源在一定程度上可有效地降低高浓度亚硝氮对厌氧氨氧化菌的抑制作用.通过对污泥性状的研究,明确寻找出污泥上浮的原因所在.通过Stover-Kincannon模型确定系统动力学参数KB和Umax分别为30.2 g/L·d和2L2g/L·d,这将有助于对该厌氧氨氧化系统各控制条件的有效调节和准确设定,也为日后应用于实际工程中提供重要的理论依据.     

环境税收制度的效益分析及其对比优势探讨

环境税收制度是未来中国环境政策改革的突破口，相对于其它的环境政策如排污收费与排污权交易等，环境税收其经济效益与环境效益明显，开征环境税收有重要的意义，但在短期内，我国实施环境税收制度的条件尚不成熟，环境政策体系应该采取税费并存，并逐步过渡到以环境税为主的方式。