省沽油中硒含量及其测定方法研究

采用消化液硝酸／高氯酸消解法、硝酸-硫酸消解法和微波消解方法消化省沽油，用原子吸收分光光度法测定硒（Se）含量。比较了3种消解方法在测定省沽油中的硒含量。发现微波消解法测定野生省沽油（干菜）中Se含量准确性好、时间段效率高、对环境污染少、操作简单。     

Planar detonation structure for chain-branching kinetics with large activation energy and small initiation rate

The structure of the steady planar detonation wave is analyzed for three-step chain-branching kinetics consistent with hydrogen–air chemistry. The initiation and chain-branching steps are described by an Arrhenius rate. Both are thermally neutral, so that heat release is due to termination. The initiation rate is typically very low and very stiff. As a result, a small fraction of the reactant is consumed in the initiation region, which is very long but ends in an exponential chain-branching explosion. Next, the reactant is rapidly converted into chain-branching radicals, within a very thin zone, which ends when the concentration of the chain-branching radical reaches a peak, because of reactant depletion. Finally, the termination step consumes the chain-branching radicals and releases heat within a region thicker than the peak zone, but much thinner than the initiation region. The analysis is based upon two assumptions: that the chain-branching activation energy is high and that initiation is slow. The structure of the initiation and chain-branching zones is different for post-shock states within or outside the explosion region in the chain-branching diagram. In the former situation, chain-branching is already stronger than termination at the von Neumann point, and vice versa. In the no-explosion case, the initiation zone becomes very long, while the little chain-branching specie produced by initiation is directly converted into product by the termination step. Temperature increases slowly until reaching the explosion curve, when chain-branching becomes stronger than termination. The subsequent structure is similar to the explosion case.     

The interaction between some human obstacles and birds

Some of the literature pertinent to the interactions of birds of flight and man made obstacles, such as transmission lines is reviewed here. Some birds use these towers, poles, and buildings for nesting and perches. They also collide with them. Original observations presented here suggest that the environmental impacts of these types of obstacles on birds, and vice-versa, seem not due to the inability of the birds to perceive the obstacles, but rather that the birds are apparently distracted from a safe flight pattern by their own species, or by others. Editor's Note: Although this paper is quite specialized in comparison with many other articles published in Environmental Management, I feel it is a very useful overview of the problems and the literature related to bird collisions with manmade obstacles. It is hoped that the information presented by the Willards will be helpful to other workers who are perhaps engaged in preparing environmental impact statements concerning structures that could invite bird collisions.     

一起预制板脆性断裂事件的原因及预防

对发生在该钢铁厂的一起预制板脆性断裂事件进行了介绍和分析,探讨了在高温条件下发生断裂的原因。     

Effect of six kinds of scale inhibitors on calcium carbonate precipitation in high salinity wastewater at high temperatures

Precipitation of calcium carbonate(Ca CO3) scale on heat transfer surfaces is a serious and expensive problem widely occurring in numerous industrial processes. In this study, we compared the scale inhibition effect of six kinds of commercial scale inhibitors and screened out the best one(scale inhibitor SQ-1211) to investigate its scale inhibition performance in highly saline conditions at high temperature through static scale inhibition tests. The influences of scale inhibitor dosage, temperature, heating time and p H on the inhibition efficiency of the optimal scale inhibitor were investigated. The morphologies and crystal structures of the precipitates were characterized by Scanning Electron Microscopy and X-ray Diffraction analysis. Results showed that the scale inhibition efficiency of the optimal scale inhibitor decreased with the increase of the reaction temperature. When the concentration of Ca2+was 1600 mg/L, the scale inhibition rate could reach 90.7% at 80°C at p H 8. The optimal scale inhibitor could effectively retard scaling at high temperature. In the presence of the optimal scale inhibitor, the main crystal structure of Ca CO3 changed from calcite to aragonite.     

Analysis of trace dicyandiamide in stream water using solid phase extraction and liquid chromatography UV spectrometry

An improved method for trace level quantification of dicyandiamide in stream water has been developed. This method includes sample pretreatment using solid phase extraction. The extraction procedure (including loading, washing, and eluting) used a flow rate of 1.0 mL/min, and dicyandiamide was eluted with 20 mL of a methanol/acetonitrile mixture (V/V = 2:3), followed by pre-concentration using nitrogen evaporation and analysis with high performance liquid chromatography–ultraviolet spectroscopy (HPLC–UV). Sample extraction was carried out using a Waters Sep-Pak AC-2 Cartridge (with activated carbon). Separation was achieved on a ZIC^®-Hydrophilic Interaction Liquid Chromatography (ZIC-HILIC) (50 mm × 2.1 mm, 3.5 μm) chromatography column and quantification was accomplished based on UV absorbance. A reliable linear relationship was obtained for the calibration curve using standard solutions (R² > 0.999). Recoveries for dicyandiamide ranged from 84.6% to 96.8%, and the relative standard deviations (RSDs, n = 3) were below 6.1% with a detection limit of 5.0 ng/mL for stream water samples.     

Potential application of high pressure carbon dioxide in treated wastewater and water disinfection: Recent overview and further trends

Recently emerging disadvantages in conventional disinfection have heightened the need for finding a new solution. Developments in the use of high pressure carbon dioxide for food preservation and sterilization have led to a renewed interest in its applicability in wastewater treatment and water disinfection. Pressurized CO₂ is one of the most investigated methods of antibacterial treatment and has been used extensively for decades to inhibit pathogens in dried food and liquid products. This study reviews the literature concerning the utility of CO₂ as a disinfecting agent, and the pathogen inactivation mechanism of CO₂ treatment is evaluated based on all available research. In this paper, it will be argued that the successful application and high effectiveness of CO₂ treatment in liquid foods open a potential opportunity for its use in wastewater treatment and water disinfection. The findings from models with different operating conditions (pressure, temperature, microorganism, water content, media …) suggest that most microorganisms are successfully inhibited under CO₂ treatment. It will also be shown that the bacterial deaths under CO₂ treatment can be explained by many different mechanisms. Moreover, the findings in this study can help to address the recently emerging problems in water disinfection, such as disinfection by-products (resulting from chlorination or ozone treatment).     

大渡河上游丹巴地区地质灾害的地貌分维特征解析

地貌对地质灾害的分布、类型、规模与危害等特征具有重要的影响,宏观及微观地貌指标均能在一定程度上刻画其作用特征。应用高分辨率遥感影像详细解译崩塌和滑坡灾害,采用高精度DEM和滑动窗口技术提取地貌分维特征,并用其解析灾害分布的地貌特征。结果表明:灾害体的内部与后壁、前缘、侧壁和邻区均表现出较为明显的分异性,崩塌的微地貌分异特征较之滑坡显著,大型、厚层、老(古)崩塌及滑坡分异特征更为突出。计算地貌分维值可有效识别与其同时期的或更早的地质灾害,也可间接挖掘新发生灾害的微地貌复杂性和离散性。     

植被混凝土在官地水电站的试验分析

本文主要对官地水电站高陡边坡植被混凝土前期绿化试验成果进行分析,以寻求在干湿季节明显、雨量集中、干旱季节漫长、温度高、蒸发量大等干热河谷气候特征条件下的最佳生境构筑方法,为官地水电站乃至雅砻江流域水电工程高陡边坡生态恢复提供技术依据。     

Optimization of the high-pressure, near-critical liquid-based microsortation of recyclable post-consumer plastics

High-pressure, near-critical liquids were used as float-sink separation media for the microsortation of polyolefin mixtures and PET/PVC mixtures. Near-critical carbon dioxide was used for the refinement of the polyolefins, and sulfur hexafluoride was used to separate post-consumer PVC from PET. Preliminary experiments indicated that there was no overlap in the density ranges of post-consumer HDPE, LDPE and PP containers. There was no overlap in the PET and PVC densities, with the exception of a single PVC packaging material with a density in the PET range. These initial results indicated that a float-sink separation was a viable means of microsortation. Separations of 91% LDPE (1/8′ beads)/9% PP (1/8′ chopped strands) resin mixtures and mixed post-consumer polyolefin flakes were then conducted in a laboratory-scale, 1-I batch apparatus. This apparatus not only permitted the observation of the separation, but also enabled the separated fractions to be removed from the high-pressure environment. The results indicated that LDPE purity of greater than 98.9% was obtained in 3 min or less if (a) the fluid density was 0.018 g/cm³ greater than the PP density and only 0.002 g/cm³ less than the LDPE density, thereby providing the greatest buoyancy force for the removal of the PP, (b) the fluid was recirculated upward through the bed of mixed plastics, facilitating the upward movement of the PP, and (c) the loading was kept at levels below 40% by volume. HDPE purity of 99% was also attained with clean, dry, post-consumer mixed plastic flakes. The loadings for these separations were very low, however, due to the difficulty in agitating the mixed bed of plastics using fluid recirculation. An economic analysis of these microsortation processes indicated that the value of the sorted plastics relative to the mixed feed must increase by approx. $0.08/lb for the CO₂-based separation and approx. $0.27/lb for the SF₆-based separation to justify the implementation of these high-pressure processes.