准噶尔盆地西北部引水工程建设运行的生态环境效益评估

准噶尔盆地西北部引水工程的建成和运行,对工程沿线区域土地资源的利用方式产生了深远的影响,也改变了该区域以土地资源为载体的生态系统的结构和生态环境的价值。以Constanza等人对全球各类生态系统单位面积服务价值的测算为依据,根据准噶尔盆地西北部引水工程沿线影响区2000年和2002年LandsatTM卫星影像解译数据,对工程建设和运行的生态环境效益予以估算。结果表明:引水工程的建设运行使工程影响区内生态系统的生态环境效益增加了2657 14×104 (约合22054 26×104元人民币),其中水域及耕地生态系统生态效益的增加是研究区生态效益增加的主要方面。     

跌水曝气生物接触氧化预处理太湖水的研究

生物预处理是当前给水处理去除水中氨氮和有机物的有效手段,有助于改善水的理化性质且利于后续常规工艺的运行.针对以太湖水质的特点,跌水曝气生物接触氧化预处理成为首选方法.通过对不同水力停留时间(HRT)运行效果的分析,提出了在低温季节最优的水力停留时间.污染物在生物接触氧化中的去除率随水力停留时间的增大而增大,而在HRT＜1.6 h范围内HRT的影响较为显著.     

Heterogeneity of chlorinated hydrocarbon sorption properties in a sandy aquifer

Hydraulic conductivity and sorption coefficients for chlorinated hydrocarbons (chloroform, carbon tetrachloride and tetrachloroethylene) were evaluated for 216 sediment samples collected across a 15 m transect and a 21 m depth interval in a contaminated aquifer near Schoolcraft, Michigan. Relationships between hydraulic conductivity, linear sorption partition coefficients, grain size classes, and spatial location were investigated using linear regression analysis and geostatistical techniques. Clear evidence of layering was found in sorption properties, hydraulic conductivity and grain sizes. Conductivity correlated well with grain size, as expected, but sorption varied inversely with grain size, contrary to some previous reports. No significant correlation was found between sorption properties and hydraulic conductivity. This is likely due to the unexpected presence of small amounts of highly sorptive coal-like solids, which dominate the sorption behavior but have little effect on conductivity. The results demonstrate that recent findings regarding the high sorption capacity of coal materials found in soils can exert a controlling influence on contaminant transport. Designers of in situ remediation systems should be cautioned that 1) it is not reasonable to assume that sorption capacity and hydraulic conductivity are related, 2) sorption capacity and hydraulic conductivity are critical measurements for contaminant site characterization and subsequent transport modeling, 3) estimating sorption capacity from organic carbon measurement may lead to greater errors than performing sorption isotherms, and 4) it is more important to characterize vertical heterogeneity rather than horizontal heterogeneity because both sorption and hydraulic conductivity are correlated across longer distances in the horizontal plane.     

曝气生物滤池去除有机物及硝化氨氮的影响因素研究

采用以陶粒为填料的曝气生物滤池(BAF)处理低浓度生活污水,研究在气水比一定的条件下,水力负荷、有机负荷及氨氮负荷对BAF去除有机物及硝化氨氮的性能的影响.研究结果表明,当试验进水COD为105.8～156.6 mg/L,气水比为3:1的条件下,降解有机物的最佳水力负荷为1.35～1.68 m3/(m2·h),COD平均去除率为86.3%.氨氮负荷是影响反应器硝化性能的直接因素.当水力负荷为1.05 m3/(m2·h),平均进水COD为106.1 mg/L时,若使出水氨氮低于15 mg/L,则反应器能承受的最大进水氨氮负荷为0.5 kg/(m3·d)左右.并确立了相应的反应器动力学模型.     

Effects of skin and hydraulic fractures on SVE wells

Soil vapor extraction (SVE) systems are intended to cause substantial volumes of air to flow through the subsurface with the purpose of removing volatile contaminants. The effectiveness of SVE can be influenced by any effect that changes the specific gas capacity (discharge as a function of vacuum) of a well. Skins of low permeability material enveloping a well bore are widely recognized to affect the performance of wells used to recover water, natural gas, or petroleum, and skin can also significantly diminish the performance of an SVE well. Skins a few mm thick consisting of material whose gas phase permeability is 0.01 of the formation can reduce the specific gas capacity of an SVE well by factors of 2 to 10 or more. Hydraulic fractures created in the vicinities of shallow wells commonly resemble sand-filled layers shaped like flat-lying disks or gently dipping saucers. The contrast between the gas-phase permeability of the sand in the fracture and that of the formation is particularly important, with significant effects requiring the ratio to be greater than approximately 50. Shallow hydraulic fractures filled with several tenths of m3 of sand in formations that are several orders of magnitude less permeable than that of the enveloping formation should increase specific gas capacity by factors of 10 or more. Field tests of the effects of hydraulic fractures on the performance of SVE were conducted by creating four wells intersecting fractures and a suite of control wells created using conventional methods in silty saprolite. Specific gas capacities ranged over more than an order of magnitude for 10 wells completed within a small area (2 m2) and at the same depth. Specific capacities correlate to the drilling method that was used to create the bore for the well: lowest values occurred in wells drilled with a machine auger, slightly better results were obtained using a Shelby tube, and the best results were obtained from conventional wells bored with a hand auger. Skin factors determined for wells created with a machine auger could be explained by a layer 1 cm thick that has 0.007 times the permeability of the enveloping material, which could readily have been created during the drilling procedure. Specific capacities of wells intersecting hydraulic fractures were 5 to 100 times more than those of conventional wells. The large difference in performance appears to be due in part to the beneficial effects of the fracture, and in part to the detrimental effects of well skin.     

暴雨径流固态污染物旋流分离研究

旋流分离技术在暴雨径流污染控制中的应用是一项新兴的污染控制技术。本文结合滇池流域暴雨径流中固态污染物构成的特征，利用传统的旋流分离技术和复合流场旋流分离技术来实现暴雨径流中固态污染物的去除。通过现场试验，探讨了旋流分离技术的主要技术参数以及他们之间的内在联系。     

稳定塘的水力模型及其参数的确定

稳定塘的水力模型对于稳定塘的设计、运行和评价具有重要作用。该文在对稳定塘的各种水力模型分析的基础上,利用试验数据,对各种水力模型进行了识别与评价。结果表明:稳定塘的水力流态接近于完全混合态,基本上相当于2个或3个完全混合反应器的串联,无量纲扩散数d一般介于0．1～0．5之间。      

水利水电工程环境影响综合评价的人工神经网络专家系统

在分级加权评价模型层次结构体系基础上,以三峡工程为背景,应用人工神经网络技术,建立了一个水利水电工程环境影响综合评价的人工神经网络专家系统,该专家系统的知识获取和存贮方式与普通专家系统不同,具有较高的推理效率,较强的容错、自适应和自我更新能力。      

曝气生物滤池处理生活污水的试验研究

对升流式二级曝气生物滤池去除COD和NHs—N的效果进行了试验研究,并在各个阶段对比中找出最优的运行工况,从而达到节约能源,降低运行成本的目的。通过试验对水力负荷、有机负荷、气水比等参数的变化对去除COD和NH3-N效果的影响。研究结果表明,在进水水力负荷为1～4m3／m^2·h、有机负荷为4-13kgCOD／ms·d及气水比1：1～3：1的工艺条件下,COD和NH3-N的出水水质均能满足杂用水需要。     

风电机舱内典型混合液态油品热诱导燃烧特性

为探究不同尺寸方形油盘对双馈异步风力发电机组机舱中典型混合油品燃烧特性的影响,自主设计和搭建了热平板诱导油品加热燃烧测定实验系统。将液压油(CALTEXRANDO HDZ32)和齿轮箱油(CALTEXMEROPA320)按1∶1质量(各40.0g)比例均匀混合后,盛装于横截面尺寸分别为6.5cm×6.5cm、10.0cm×10.0cm、13.5cm×13.5cm 的钢制油盘中,利用热平板加热和诱导盘内同样质量混合油品燃烧,利用摄像机记录其燃烧行为和阶段节点时间,利用热电偶树、温度采集模块对油品燃烧对应阶段节点液内和上方火焰中心轴温度分布进行测定。观察发现,液/齿混合油品在加热后出现液内流动、蒸发、冒泡、气化、燃烧、发烟、火焰蹿高等典型传热传质和液相燃烧现象。实验结果表明,随油盘横截面尺寸递增,混合油品着火时间依次缩短(最高1048.0s),燃烧持续时间依次递减(最高1980.0s),燃烧液内最高温度依次升高(最高564.3 ℃),中心轴第一层火焰熄灭温度依次升高(最高489.2 ℃)。小尺寸油盘内油品交流换热过程缓慢,质量损失速率较低,着火前阶段出现最大质量损失速率(0.041g/s);中大尺寸油盘内对流、传质和传热过程明显增强,质量损失速率较高,火焰蹿高节点时出现最大质量损失速率(0.25g/s和0.29g/s)