SPE-GC-MS/MS法测定水源水中多种有机氯EDCs

采用C 18柱固相萃取(SPE)-三重四级杆气相色谱-质谱法同时测定水中18种含有机氯的环境内分泌干扰物,方法在0.500μg/L^100μg/L范围内线性良好,方法检出限为0.04 ng/L^0.8 ng/L,空白水样的加标回收率为61.3%~108%,6次测定结果的RSD为3.8%~18.0%。将该方法用于饮用水源水监测,18种目标化合物的测定值为未检出~1.5 ng/L,平均加标回收率为71.9%~109%,平行测定结果的RSD<15%。     

气相色谱/质谱法测定水中15种酞酸酯类化合物

采用固相萃取-气相色谱/质谱法测定水中15种酞酸酯类化合物,确定方法的最优条件为:依次用10 m L正己烷和丙酮混合溶剂(V/V=5∶1)、甲醇和空白试剂水活化C18固相萃取柱后,水样以5 m L/min过柱萃取,再以8 m L正己烷:丙酮(V/V=5∶1)混合溶剂洗脱后,浓缩至1 m L,进气相色谱/质谱测定。该法的检出限为0.18~0.38μg/L,在0.50~20.0 mg/L范围内线性良好,相关系数均0.996。空白水样的加标回收率为71.8%~120%,相对标准偏差为1.73%~12.7%;实际废水水样的加标回收率为64.8%~135%,相对标准偏差为2.75%~18.0%。     

热脱附-GC/MS法测定垃圾填埋场周围空气中氯代烃

采用热脱附-冷阱捕集-GC/MS法测定垃圾填埋场周围空气中24种氯代烃,通过试验优化并确定热脱附质谱的最佳处理条件。方法在5.00 mg/L～100 mg/L范围内线性良好,24种氯代烃的方法检出限为0.060μg/m~3～0.200μg/m~3,测定下限为0.240μg/m~3～0.800μg/m~3。空白加标回收率为91.8%～110%,6次测定结果的RSD均5%。实际样品测定结果为0.112 mg/m~3～0.412 mg/m~3,表明离垃圾填埋场最近的居民区环境中氯代烃为未检出或痕量分布,对生命体危害极低。     

Emission and burnt smell characteristics from combustion experiments with defined materials

Typical burnt smell often results from fire accidents or in general from incomplete combustion. Recently, eleven compounds were identified, which are basically responsible for this odour. When analyzing residual materials from different fire accidents, the pattern that means the relative ratios of these compounds among each other varies strongly, although always causing a burnt smelling. Consequently, lab-scale combustion experiments were performed in order to investigate the influence of defined materials from domestic environment on the burnt-smell fingerprints. Furthermore, the occurrence of other polar and higher molecular combustion products was studied. It was found that under good combustion conditions, the burnt smell patterns resulting from the single materials were astonishingly consistent, mostly dominated by methylphenols or naphthalene. No correlation could be found between these ‘fingerprints’ and combustion product groups identified by GC/MS-screenings. LC/MS/MS-measurements especially pointed at the existence of higher molecular weight phenolic and acidic functionalized compounds in the combustion residues.     

Simple analytical method for determination of pesticide residues in human serum by liquid chromatography tandem mass spectrometry

The aim of this study was to develop an analytical method for the determination of residues of organophosphorus and carbamate pesticides which are widely used in Tunisia. This method involves a liquid-liquid extraction procedure followed by liquid chromatography tandem mass spectrometry (LC/MS/MS) for the identification and quantification of compounds. Ionization of molecules was performed by the electrospray mode. Multiple reactions monitoring (MRM) was the acquisition mode used for the monitoring of two MS/MS transitions for each compound. The average recoveries obtained, at three different fortification levels, ranged between 65% and 106% for most of the pesticides studied, except for methamidophos (lower than 25%).The linearity of the method was in the range of 5 to 50 μ g/L with a correlation coefficient from 0.995 to 0.999, depending on the analyte. The estimated limit of detection and limit of quantification were 2 μ g/L and 5 μ g/L, respectively. The precision of the analytical procedure was satisfactory and the coefficients of variation, evaluated at three concentration levels were lower than 15% for most pesticides studied. The application of the method was investigated in a population of agricultural workers chronically exposed to various pesticides some of which, such as carbofuran, carbendazim, methomyl and pirimicarb, were detected in some serum samples.     

Extraction procedure optimization for perfluorooctane sulfonate and perfluorooctanoic acid in food packaging determination by LC-MS/MS

This research aimed to optimize the extraction method parameters for sample pretreatment and determine the levels of perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA) contamination in food packaging made of paper. Techniques used were pressurized liquid extraction (PLE) followed by liquid chromatography coupled with tandem mass spectrometry (LC-MS/MS). Influence parameters of PLE were carefully evaluated for extracted concentration of samples in low level (ng g^?1). The study found that the optimal conditions for PLE were 30 min static extraction time with a flush volume of 100% cell volume and one extraction cycle at 80°C and 1,000 psi. The extraction technique validated the absolute recovery from PFOS and PFOA fortified control samples at three different levels (5, 50, and 200 ng g^?1), with seven repeats at each fortification level. The average recoveries were 79% or higher, with relative standard deviation (RSD) less than 11%. Optimization of the PLE method was established based on recovery data, accuracy, precision, and repeatability of the method. Using optimal PLE technique, PFOS and PFOA were extracted from 34 food-packaging samples collected in Thailand. PFOS and PFOA were detected in all kinds of collected samples, with average concentrations of 4.89 and 2.87 ng g^?1, respectively. The concentrations of PFOS and PFOA were highest in fast-food container samples: 36.99 and 9.99 ng g^?1, respectively.     

Multiresidue determination of pesticides in tea by gas chromatography-tandem mass spectrometry

An efficient and reliable GC-MS/MS method for the multiresidue determination of pesticides in tea was developed by modifying the Japanese official multiresidue method. Sample preparation was carefully optimized for the efficient removal of coextracted matrix components. The optimal sample preparation procedure involved swelling of the sample in water; extraction with acetonitrile; removal of water by salting-out; and sequential cleanup by ODS, graphitized carbon black/primary secondary amine (GCB/PSA) and silica gel cartridges prior to GC-MS/MS analysis. The recoveries of 162 pesticides from fortified (at 0.01 mg kg^?1) green tea, oolong tea, black tea and matcha (powdered green tea) were mostly (95–98% of the tested pesticides) within the range of 70–120%, with relative standard deviations of <20%. Poor recovery of triazole pesticides was considered to be due to low recovery from the silica gel cartridges. The test solutions obtained by the modified method contained relatively small amounts of pigments, caffeine and other matrix components and were cleaner than those obtained by the original Japanese official multiresidue method. No interfering peaks were observed in the blank chromatograms, indicating the high selectivity of the modified method. The overall results suggest that the developed method is suitable for the quantitative analysis of GC-amenable pesticide residues in tea.     

Characteristics of chlorofluorocarbons (CFCs) emitted from a municipal waste treatment facility

The emission concentrations of several chlorofluorocarbons (CFCs) were measured from a municipal waste treatment facility (located in Seoul, Republic of Korea) to investigate the emission characteristics of CFCs in the urban environment. To this end, a total of five CFCs (CFC-10, CFC-11, CFC-20, CFC-30, and CFC-113) were analyzed by the thermal desorption-gas chromatography-mass spectrometry (TD-GC-MS) method. The results of this study indicate that the formation of CFC-11 (8.21 ± 1.68 ppb in spring) and CFC-20 (3.92 ± 3.93 ppb in spring) proceeded very actively within the facility. Moreover, CFC-113 was also found in relatively high concentrations (3.34 ± 1.31 ppb in spring) in the treatment facility. Unlike other CFCs, CFC-10 was observed mainly at ambient (and reference) locations and one point inside the treatment facility. In conclusion, emissions of some important CFCs are a prominent process, as they were measured either frequently or abundantly both in winter and spring. It is further indicated that certain CFCs (like CFC-11 and CFC-30) are subject to highly significant seasonal variations.     

Pilot scale application of a method for the analysis of perfluorinated compounds in surface soils

A growing number of studies now indicate that perfluorinated compounds (PFCs) are globally distributed in the environment. Their widespread distribution and presence in remote locations has led to questions about the importance of atmospheric and oceanic transport. Describing their distribution in surface soils is also an essential but neglected element in developing a comprehensive understanding of their occurrence in the environment. Soils are the critical link between global atmospheric and hydrologic processes where both local and distant contaminants can accumulate and be released into aquatic and terrestrial communities. Because PFC concentrations in soils will influence ground and surface water, wildlife, and crops, methods to accurately measure PFCs in soil are clearly needed. To help answer this need, we developed a method for the analysis of nine perfluorinated carboxylic acids and four perfluorinated sulfonic acids in soil. Samples from six nations (n = 10 per nation) were analyzed by LC-MS/MS to demonstrate the method performance parameters and to make preliminary observations about the occurrence of the PFCs in soils in different parts of the world. The resulting method shows acceptable performance characteristics for the target compounds in most soils while documenting the widespread occurrence of PFCs in surface soils.     

Analysis of mixed halogenated dibenzo-p-dioxins and dibenzofurans (PXDD/PXDFs) in soil by gas chromatography tandem mass spectrometry (GC-MS/MS)

Mixed halogenated dibenzo-p-dioxins and dibenzofurans (PXDD/PXDFs, X = Br, Cl) are formed through combustion processes, and may be more toxic than their corresponding chlorinated and brominated analogues. With 4600 potential congeners, limited analytical standards, and complex environmental matrices, PXDD/PXDFs present a significant analytical challenge. Gas chromatography tandem mass spectrometry (GC-MS/MS) offers both selectivity and sensitivity through multiple reaction monitoring of unique transitions in a novel approach to PXDD/PXDF congener identification. Method validation was performed through analysis of soil samples obtained from a recycling plant fire. Of the PXDD/PXDFs examined, monobromo-dichlorodibenzofuran was the most prevalent, ranging in concentration from 8.6 ng g⁻¹ to 180 ng g⁻¹. Dibromo-dichlorodibenzo-p-dioxin, a compound of toxicological concern, ranged from 0.41 ng g⁻¹ to 10 ng g⁻¹. Concentrations of PXDD/PXDFs were between 6% and 10% that of the corresponding polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/PCDFs), with the exception of dibromo-dichlorodibenzo-p-dioxin concentrations, which were 36% that of tetrachlorodibenzo-p-dioxins. Higher levels of polybrominated PXDD/PXDFs may indicate a significant bromine source was present during combustion.