气质联用法测固定污染源中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫

建立了固定污染源排气中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫的采样和气质联用分析方法,检出限分别为0.06、0.15、0.21、0.71 mg/m3,精密度在3.2%以下,相关系数大于0.999 6,并对浙江省内2家典型企业排放的温室气体进行了监测,实际样品监测结果表明,该方法能够满足废气中4种温室气体的监测要求。     

Radiation Effects on Blends of Poly(ε-Caprolactone) and Diatomites

Poly(-caprolactone) (PCL) was blended with diatomaceous earth (diatomite) and irradiated with -rays to introduce cross-linking between PCL molecules or both components. The unwashed diatomite containing a little of a volatile component showed high efficiency of introduction of cross-linking, whereas that with no volatile component showed low efficiency of introduction of cross-linking. Elongational viscosity, melt viscosity, and modulus of PCL/diatomite blend irradiated at various doses were significantly improved. Enzymatic degradation of the PCL/diatomite blend became faster than that of the PCL, though that of the blend irradiated became slower.     

Morphophysiological Rearrangements in Fish in Response to Pollution (in the Light of S.S. Shvarts' Theory)

The results of a study on morphophysiological variation in fish inhabiting a subarctic lake exposed to chronic industrial pollution are described using an example of cisco, Coregonus lavaretus. It is shown that indices of the heart, liver, kidneys, gills, and fatness in these fish are increased significantly and have retained increased values for the past 20 years. The observed changes are analyzed on the basis of biochemical data. The results of studies on the dynamics of hematological parameters in fish are used for characterizing the development of toxicosis. Adaptive rearrangements associated with an increase in the metabolic rate and the activation of protective systems in the fish are explained in the context of S.S. Schvarts' concept. The idea is proposed that the additional energy cost of detoxification may be responsible for morphophysiological variation in fish under conditions of water pollution.     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

Bi2MoO6/纳米棒ZnO异质结对MB的可见光-压电协同降解性能研究

采用水热法合成了一系列不同负载率的Bi₂MoO₆/纳米棒ZnO复合光催化剂.通过XRD、FT-IR、SEM、TEM、XPS、UV-Vis、EPR和PL等分析技术对合成的样品进行表征.在光/超声波条件下,以亚甲基蓝（MB）为目标降解物评价其压电-光催化性能.结果表明：Bi₂MoO₆/ZnO纳米棒（BZ-0.6）的降解速率常数约为ZnO传统光催化的9.25倍,其性能提升的主要原因在于ZnO的压电效应与Bi₂MoO₆/ZnO界面形成的异质结的耦合,有效地促进了电子和空穴的分离和转移.此外,同实验条件下,循环利用5次后Bi₂MoO₆/ZnO复合光催化剂降解率仍保持良好的稳定性.     

Cryptic 1p36.3/6q25.2 translocation in three generations ascertained through a foetus with IUGR and cerebral malformations

Here we describe a foetus with intrauterine growth retardation (IUGR), cerebral malformations and a 46,XY,der(1),t(1;6)(p36.3;q25.2) karyotype owing to a familial cryptic translocation segregating in three generations. A balanced translocation was present in the mother, the maternal uncle, the aunt and the grandmother. A female first cousin with dysmorphisms, hydrocephalus and mental retardation was a carrier of a partial trisomy 1p and a partial monosomy 6q. Multiple miscarriages were present in the family pedigree. Parents of the foetus had three other pregnancies: a male with a balanced translocation, and two foetuses with 1p36.3–pter monosomy and 6q25.2–qter trisomy. Copyright © 2003 John Wiley & Sons, Ltd.     

电弧离子镀HY11涂层的1200℃高温氧化行为研究

目的研究真空电弧镀方法制备的超高温金属涂层HY11在1200℃下的高温氧化行为。方法用真空电弧镀技术(AIP)在单晶镍基高温合金DD6上制备超高温金属涂层HY11,采用HB 5258循环氧化方法进行1200℃循环氧化试验,通过试验过程中试样质量变化评价涂层氧化寿命。通过扫描电镜(SEM)分析氧化后的试样显微形貌,用X-射线衍射仪分析涂层材料的相结构,通过氧化速率对涂层材料抗氧化性能进行表征。结果采用单靶真空电弧镀技术制备的HY11涂层,经过1050℃真空条件下扩散2h,涂层厚度为50～60?m,扩散区厚度为10～15μm,涂层微观组织均匀致密,涂层合金界面清晰平整。DD6合金的1200℃循环氧化寿命仅仅为4 h,HY11涂层在1200℃的循环氧化寿命近300 h。沉积态涂层HY11相结构主要以Al_2O_3和Ni3Al为主。氧化后涂层材料表面形成的氧化膜以Al_2O_3为主。结论 HY11涂层在1200℃的循环氧化寿命为298 h,极大地提高了DD6合金在1200℃的循环氧化寿命。     

热障涂层对DD6单晶高温合金高周疲劳性能的影响

目的研究电子束物理气相沉积热障涂层对单晶高温合金高周疲劳性能的影响,为热障涂层在涡轮叶片上的应用提供技术支持。方法采用真空电弧镀和电子束物理气相沉积工艺制备YSZ热障涂层,进行900℃条件下高周疲劳性能测试,采用扫描电镜对测试后的试样表面、断口形貌进行观察与分析。结果在900℃、380 MPa条件下,带涂层的DD6单晶试棒循环次数(Nf)超过了107,420 MPa条件下超过了106。通过对DD6单晶试棒断口分析,失效后的带涂层试棒仍以DD6单晶常见滑移解离形式发生破坏。结论高周疲劳性能测试条件下,带YSZ热障涂层的试棒中粘结层率先产生垂直微裂纹,但是裂纹扩展延伸中发生氧化钝化,之后DD6基体沿正常的滑移方向从表面向内部疲劳扩展,带涂层的试棒疲劳裂纹并非由涂层微裂纹直接扩展形成,热障涂层对DD6单晶高温合金高周疲劳性能影响较小。     

植物根系质外体溶液的提取方法研究:以多环芳烃为例

根系质外体溶液中多环芳烃(PAHs)的分析对于阐明植物根系PAHs吸收运移机制及阻控意义重大.然而,迄今鲜有便捷成熟的植物根系质外体溶液提取方法的报道.为此,本研究以小麦为材料,菲为PAHs的代表,探究了植物根系质外体溶液的真空渗透离心提取方法.结果表明,小麦根系质外体菲提取量随真空度、真空时间、离心速率、离心时间的增加而增大;小麦根系质外体六磷酸葡萄糖脱氢酶(G6PDH)活性随真空度、真空时间、离心速率、离心时间的增加而升高.依据质外体溶液受原生质污染程度小于1%且尽量提取完全的原则,真空渗透离心提取法的最佳真空度为70 k Pa,最佳真空时间为10 min,最佳离心速率为3 068 r·min-1,最佳离心时间为15 min.研究结果可为污染物的植物根系质外体运输研究提供有效、简便的方法支撑.