序批式活性污泥法处理毛皮废水的研究

采用序批式活性污泥法处理毛皮模拟废水的试验条件为：水温２０℃,ＤＯ２ｍｇ／Ｌ,ＣＯＤｃｒ１５００ｍｇ／Ｌ,ＢＯＤ５ ９００ｍｇ／Ｌ,ＭＬＳＳ ２１００ｍｇ／Ｌ增至２６００ｍｇ／Ｌ左右,试验结果表明,采用限制曝气方式运行的序批式活性污泥系统最不易发生污泥膨胀。     

基于高通量绝对定量测序解析岗南水库微生物群落的时空分布特征及关键驱动因素

为了探究水源水库微生物群落时空演变特征及其环境驱动因子,采用高通量绝对定量测序技术,结合数据分析了相对定量和绝对定量对岗南水库微生物群落演变和驱动因子的影响.结果表明,基于绝对定量的微生物群落α-多样性呈现出明显的季节差异(p＜0.05),基于相对定量的微生物群落α-多样性没有差异;绝对定量的微生物群落a-多样性高于相...     

厌氧-好氧序列间歇式反应器处理生物制药废水的研究

采用厌氧序列间歇反应器与好氧序列间歇反应器相结合的技术,处理生物制药废水。结果表明,经7.0h厌氧搅拌处理和6.0h好氧曝气处理,进水COD为1180~3061mg/L,出水COD小于300mg/L,COD去除率在78.9%~92.8%之间,出水COD满足国家生物制药行业废水排放标准要求。      

Dynamics of bacterial communities during a seasonal hypoxia at the Bohai Sea: Coupling and response between abundant and rare populations

Marine bacterial community plays a vital role in the formation of the hypoxia zone in coastal oceans. Yet, their dynamics in the seasonal hypoxia zone of the Bohai Sea(BHS) are barely studied. Here, the 16S r RNA gene-based high-throughput sequencing was used to explore the dynamics of their diversity, structure, and function as well as driving factors during the gradual deoxygenation process in the BHS. Our results evinced that the bacterial community was dominated by Proteobacteria, followed b...     

渭河浮游细菌群落结构特征及其关键驱动因子

基于T-rflp技术和高通量测序技术,分析了渭河在平水期、枯水期和丰水期的浮游细菌群落变化特征,并采用冗余分析和典范对应分析识别了不同水文时期影响细菌群落的关键环境因子.结果表明,渭河水体浮游细菌群落空间和季节差异明显,且季节性差异比空间差异更加显著.平水期、枯水期和丰水期渭河(陕西段)干流浮游细菌群落Shannon多样性指数分别在2.13~2.82、2.05~2.84和2.61~2.91之间.平水期浮游细菌多样性指数空间差异最大(RSD=16.75%),样点间群落结构相似度最低(26.8%),流域优势T-RF片段数最多(23种);丰水期浮游细菌Shannon指数空间差异最小(RSD=9.27%),样点间群落相似度最高(62.6%),且检出的优势片段数最少(12种).咸阳-西安段是浮游细菌群落多样性最低、优势菌群结构最单一的河段.河流水体细菌群落在不同时期的关键环境驱动因子不同,而其中悬浮颗粒物(TSS)浓度是不同水文时期都不可忽视的关键影响因子.高通量分析结果表明,丰水期渭河水体浮游细菌物种涉及21个已知细菌门类和26个候选门类,其中,变形菌门(Proteobacteria)和拟杆菌门(Bacteroidetes)共同的相对丰度占比达到75%以上,是最主要的细菌类群.汛期渭河干流各样点浮游细菌群落特征趋于一致,物种结构与泾河相似而与黑河存在明显差异.     

ASBR中强化活性污泥与普通活性污泥降解啤酒废水的对照研究

在厌氧序批式反应器(ASBR)中采用优势菌群对活性污泥进行强化,驯化出强化活性污泥。与普通活性污泥处理啤酒废水对照显示,强化活性污泥较普通厌氧污泥驯化成熟时间短,处理效果更稳定、更有效,CODcr去除率最高达95％。培育出的强化活性污泥颗粒粒径为1．5～2．5cm,较普通活性污泥颗粒粒径更大,更均匀。     

UASCB-SMBR处理垃圾渗滤液的试验研究

研究了厌氧污泥复合床 (UASCB) 序批式膜生物反应器 (SMBR)串联工艺 ,处理垃圾渗滤液的工艺性能及影响因素 ,并与单纯的SMBR工艺进行了对比。试验结果表明 ,在进液COD浓度平均为 2 50 0mg/L ,NH+ 4-N平均浓度为 360mg/L ,厌氧反应器COD的负荷为 7～2 0kgCOD/m3·d ,SMBR负荷为 1～ 5kgCOD/m3·d,系统总水力停留时间为 1 4～ 2 8h时 ,该串联工艺COD去除率达到 92 %以上 ,NH+ 4-N的去除率在 80 %以上     

两级序批式MBR膜污染特性研究

采用两级SBR与膜法相结合的两级序批式MBR工艺处理生活污水,考察两级序批式运行模式对膜污染特性的影响.对运行111 d后的平板膜污染阻力分布进行了测算,并对两级序批式MBR与连续流单级好氧MBR的平板膜污染速率进行对比试验.结果表明: 两级序批式MBR的平板膜污染阻力以凝胶极化阻力为主,占总阻力的43%,沉积阻力较低,仅占总阻力的10%;与连续流单级好氧MBR相比,两级序批式MBR可以在更高的膜通量下运行,保持更低的膜污染速率,在运行42 d后,过膜流量从100 L/h下降至85 L/h,过膜压差从1.52×10~4 Pa增加至2.22×10~4 Pa;而连续流好氧MBR系统,过膜流量从61 L/h降低至39 L/h,过膜压差却从1.01×10~4 Pa增加至2.63×10~4 Pa.研究表明,两级序批式MBR工艺可以改善膜过滤过程的水力条件,从而有效地减缓浓差极化,降低沉积污染及凝胶层污染,序批式、膜间歇运行与空曝的结合起到了关键性作用.     

厌氧氨氧化菌富集培养过程微生物群落结构及多样性

为深入理解厌氧氨氧化菌富集培养过程微生物群落变化特征,采用ASBR反应器进行厌氧氨氧化菌富集培养,考察了不同培养时间微生物群落组成、多样性及物种网络关系.结果表明,通过逐步提高基质浓度,实现了厌氧氨氧化菌富集,NH₄⁺-N和NO₂^--N去除率分别为97.6%和95.4%,总氮去除率为84.9%.高通量测序发现,整个培养过程优势菌门（相对丰度>5%）为变形菌门（Proteobacteria）、拟杆菌门（Bacteroidetes）、绿弯菌门（Chloroflexi）、浮霉菌门（Planctomycetes）、装甲菌门（Armatimonadetes）和放线菌门（Actinobacteria）;富集培养获得的主要厌氧氨氧化菌为Candidatus Brocadia,相对丰度从1.42%增长到24.66%;培养过程,微生物群落优势菌群组成未发生变化,但相对丰度呈现显著差异（P<0.05）.富集培养过程不同时间,微生物群落α多样性呈现先升高后降低的趋势,且存在显著差异（P<0.05）;微生物群落β多样性在富集培养过程发生明显空间分异特征,且存在显著差异（R=0.5672,P<0.01）.培养过程不同时间,物种网络密度分别为0.188、0.068、0.059、0.18和0.0735;虽然富集培养过程导致微生物间的关联作用变弱,但浮霉菌门相关类群的物种成为网络中的主要节点.     

The formation of aerobic granular sludge for the treatment of real landfill leachate using a granular sequencing batch reactor at a constant volume

Leachate generated in a landfill may not be treated by conventional biological treatment due to its nature and complexity. The process of forming aerobic granules in batch sequencing reactors having features such as; reducing the settling process time and saving energy consumption and high decomposition rate have been noticed by researchers. In the present study, the structure of sequencing batch reactors (SBRs) was evaluated for the formation of granules, which were subsequently utilized for the treatment of landfill leachate. The experiment was initiated by using the GSBR, containing 1200 ml with different apparatuses, to develop granular sludge, and synthetic wastewater was added to reinforcement. The selected parameters for the operational hydraulic retention time (HRT) of the wastewater (6-h cycles) included feeding, idle, aeration, settling, and discharge. Furthermore, the controlled conditions were the dissolved oxygen (DO) range of 2–2.2 mg/L, temperature range of 20–23℃, and pH of 7.5–8.3. The chemical oxygen demand (COD), mixed liquor suspended solids (MLSS), and sludge volume index (SVI) daily were measured at the influent and effluent of GSBR reactor. The main properties of aerobic granular sludge were identified during the research procedures, and the remarkable settling and potent, high-density microbial structure of the granules were confirmed. The mean size of the formulated granules was estimated at 7.46 ± 1.8 mm, and the volume of the biomass also increased from approximately 1607 to 4137 mg/L through the granulation process. Moreover, 98% of the influent chemical oxygen demand (COD) could be removed by the formulated granular sludge, and the final-stage organic loading rate was estimated at 5.65 COD/m³/day. According to the results, GSBRs could be employed for the formulation of aerobic granular sludge for the treatment of landfill leachate.