Preparation of steel slag porous sound-absorbing material using coal powder as pore former

The aim of the study was to prepare a porous sound-absorbing material using steel slag and fly ash as the main raw material, with coal powder and sodium silicate used as a pore former and binder respectively. The influence of the experimental conditions such as the ratio of fly ash, sintering temperature, sintering time, and porosity regulation on the performance of the porous sound-absorbing material was investigated. The results showed that the specimens prepared by this method had high sound absorption performance and good mechanical properties, and the noise reduction coefficient and compressive strength could reach 0.50 and 6.5 MPa, respectively. The compressive strength increased when the dosage of fly ash and sintering temperature were raised. The noise reduction coefficient decreased with increasing ratio of fly ash and reducing pore former, and first increased and then decreased with the increase of sintering temperature and time. The optimum preparation conditions for the porous sound-absorbing material were a proportion of fly ash of 50% (wt.%), percentage of coal powder of 30% (wt.%), sintering temperature of 1130°C, and sintering time of 6.0 hr, which were determined by analyzing the properties of the sound-absorbing material.     

Strength and tightness evaluation method for pipe flange connections considering thermal effects

The pipe flange connection is widely applied in chemical, power plants, petrochemical, offshore oil and gas industries, and its strength and tightness are significant for the safe operation. However, there are still no practical and applicable strength and tightness evaluation methods for pipe flange connections working in dramatically varying temperatures. This paper proposed an approach to evaluate the pipeline's strength and sealing performance considering thermal effects in actual operating conditions by combining the experimental measurement and thermostructural analysis. The critical thermodynamic parameters are identified through measured temperature data in operating conditions, and then these parameters are used in the thermostructural analysis to obtain the actual temperature and stress fields. Then, the strength and tightness in complex temperature cases can be evaluated accurately. The pipe flange connection of a liquefied natural gas (LNG) fueling station is analyzed to verify the presented method's effectiveness. This method applies to evaluating the pipeline's strength and tightness and can predict the pipeline's performances under extreme temperatures using the tested data within the measurement range and the corresponding thermostructural analysis. Furthermore, the work in this paper also provides a reference for the design and analysis of pipe flange connections working in complex temperature conditions.     

Assessing the impact of leather industries on the quality of water discharged into the East China Sea from Wenzhou Watersheds

Ammonium nitrogen and total germanium are among the main pollutants in the wastewater discharged from the leather industry. The intake of high concentrations of ammonium nitrogen and/or total germanium harms human health and biological species, as is well documented in literature. This paper focuses on assessing the trends of ammonium nitrogen and total germanium concentrations through time in two watersheds (Aojiang and Oujiang) in the Wenzhou metropolitan area of Zhejiang Province and their relationships with the released wastewater using regression and correlation statistics. The paper also utilizes the integrated pollution index to evaluate water quality in the two watersheds. Preliminary results show that, from 1992 to 1998 in the Aojing watershed, the concentrations of ammonium nitrogen and total germanium increased 13 and 14 times, respectively, decreasing somewhat after 1998, while between 1992 and 1997 in the Oujiang watershed, the concentrations increased, then decreased after 1997. The concentrations of ammonium nitrogen and total germanium are positively related to the amount of released wastewater. The concentrations of ammonium nitrogen and total germanium exceeded water standards 12 and 3 times, respectively, in Pingyang county of the Aojiang watershed, 14 and 3.3 times in Lucheng District of the Oujiang watershed, and 14 and 3.8 times in the Ouhai Oujiang watershed, respectively. In Pingyang county of the Aojiang watershed, the water quality degraded from Type III in 1992 to over Type V in 2003, and in the Oujiang watershed, the water quality degraded from Type II to over Type IV in 1999, when they were compared with the water quality standards. The water quality slightly improved in 2003 for the Oujiang watershed. It appears that pollution did have a direct positive correlation with leather industry production in the Pingyang Aojing watershed, while there was a negative correlation between the two in the Oujiang watershed. In these two watersheds, the integrated pollution index did not appear to relate to population dynamics and agricultural production. This paper also discusses the current new methodologies and approaches adopted nationally and internationally to reduce the contaminants and purify the environment for maintaining a sustainable and healthier environment in Wenzhou.     

高能重离子辐照下国产RPV钢A508-3的硬化行为

目的 研究在563 K的温度条件下,高能重离子辐照导致国产RPV钢A508-3的硬化行为。方法 使用回旋加速器提供的352.8 MeV Fe²¹⁺对A508-3钢试样进行辐照,使其依次达到0.15、0.30、1.50 dpa的损伤水平。借助辐照终端的梯度减能装置,在样品表面至25 μm的深度范围内产生一个准均匀分布的原子离位损伤坪区,并使用纳米压痕仪和维氏显微硬度计测量了试样的硬度。结果 考虑到压痕尺寸效应的影响,采用Nix-Gao模型对硬度数据进行拟合,由于高能Fe离子产生了较厚的损伤区,辐照试样中的软基效应明显减弱。辐照后的试样出现明显的硬化现象,且随着辐照剂量的增大,硬化增量有饱和趋势。通过辐照前和辐照至0.15 dpa试样的微硬度数据,得出其与纳米硬度之间的线性关系(Hv0=0.85 H0)。结论 借助A508-3辐照前后的硬度数据,计算发现试样的屈服强度增量与辐照剂量之间存在一种幂函数关系,这为A508-3钢中子-离子辐照硬化的映射关系研究提供了基础数据。     

变电站与输电线路的电磁环境影响水平分析与测试评估——以部分220kV及110kV输变电设施为例

通过对220kV及110kV户内布置、户外布置方式的变电站,架空输电线路以及地下电缆线的工频电场强度、工频磁场强度的监测,分析比较了变电站及输电线路对环境的贡献水平以及衰减规律。结果表明输变电设施对环境的贡献值非常有限,且随与之距离的增加而明显衰减。     

Echolocation call design and limits on prey size: a case study using the aerial-hawking bat Nyctalus leisleri

The echolocation calls used by Nyctalus leisleri during search phase in open air space are between 9 and 14 ms long, with the peak energy between 24 and 28 kHz. The pulses are shallowly frequency-modulated with or without an initial steep frequency-modulated component. The diet consists primarily of small flies (Diptera), including many chironomids (wingspan 9–12 mm) and yellow dung flies (Scatophaga; wingspan 24 mm), but also of some larger insects such as dung beetles (Coleoptera; Scarabaeoidea), caddis-flies (Trichoptera) and moths (Lepidoptera). The echo target strength of some prey items was measured. Contrary to models based on standard targets such as spheres or disks, the echo strength of real insects was found to be virtually independent of the emitted frequency within the 20–100 kHz frequency range. A model was used to calculate probable detection distances of the prey by the bat. Using narrow-band calls of 13.7 ± 2.7 ms duration, a bat would detect the two smallest size classes of insect at greatest range using calls of 20 kHz. The results may therefore explain why many species of large and medium sized aerial-hawking bats use low-frequency calls and still eat mostly relatively small insects. The data and model challenges the assumption that small prey are unavailable to bats using low-frequency calls.     

圆环巴西试验的抗拉强度建议公式

目的改进Hobbs公式得到的计算值普遍较大这一问题,提出圆环巴西试验的抗拉强度建议公式。方法对巴西试验圆环的应力解进行分析,并引用砂岩的试验数据验证。结果得到圆环巴西试验的抗拉强度建议公式,使用Hobbs公式得到的抗拉强度σTT比巴西圆盘试验σT大6倍以上,利用建议公式得到的抗拉强度σθ与巴西圆盘试验σT十分接近,误差不到1%。结论当圆环内外径比ρ在0.05到0.15的范围内时,该建议公式可很好地用来计算岩石类等脆性材料的抗拉强度。     

战略环境评价在中国的发展及方法学探讨

本文在回顾和评述战略评价（SEA）的发展状况的基础上，从概念和实践的角度，对SEA方法学作了初步探讨，并提出SEA方法学研究的一般思路。     

关于燃煤电厂环境影响评价工作中的一些问题

对燃煤电厂的环评工作中，项目选址、总平面布置、污染防治与清洁生产：冷却塔噪声等一些值得注意的问题进行了探讨，并提出了一些初步意见。     

The impact of a nationwide effort to reduce airbag-related deaths among children: an examination of fatality trends among younger and older age groups

INTRODUCTION: The purpose of this study was to examine the impact of a nationwide response to emerging airbag-related deaths among children. This response, implemented in 1996, focused on moving children to a rear seat and increasing proper restraint usage. METHOD: Fatality trends from 1992 through 1996 and from 1996 through 2003 were examined for younger children (ages 0-3) and for older children (ages 4-12). RESULTS: Prior to 1997, a steady reduction in unrestrained deaths (among younger children) was offset by increases in restrained deaths (among younger and older children), increases in rear-seat deaths (among younger children), and increases in front-seat deaths (among older children). After 1996, there were significant decreases in fatalities in both age groups, with larger and more immediate reductions among the younger children. The largest reductions were immediately after 1996, when younger-child deaths declined by 16%, and after 1999, when deaths among both age groups declined by about 16%. CONCLUSIONS: The immediate reduction in front-seat deaths among younger children, particularly infants, appears to have been closely associated with the nationwide public information efforts implemented in 1996. Later reductions in front-seat and unrestrained deaths, among both younger and older children, were likely associated with the combination of legislative, enforcement, and public information programs, which increased after 1999. IMPACT ON INDUSTRY: The findings suggest that a large expenditure of resources by public and private-sector organizations after 1996 resulted in the prevention of hundreds of deaths among young children. In addition, the results provide insights with regard to the categories of deaths most affected by such programs and issues that deserve additional attention.